Set output on for wide-PW cal of wide-PW models, because terminations can load TRIG and distort calHEADINSTRUMENT_6_4_39master

1 files changed, 11 insertions, 2 deletions

diff --git a/device-functions.c b/device-functions.c
index 02162cf..1ed0cac 100644
--- a/device-functions.c
+++ b/device-functions.c
@@ -2182,13 +2182,22 @@ int Set_Cal_Nom(int channel,int calibration_point_number,int parameter, float *n
 		return OK;
 	}
 
-	/* For timing parameters, turn off output and error-checking, and change prf/pw,
+	/* For most timing parameters, turn off output and error-checking, and change prf/pw,
 	   except for voltage-controlled delay (2CHPP, for example). For ampl/os parameters,
 	   and voltage-controlled delay, use existing timing and output state, and use error-checking */
 
 	if (reset_state) {
 		Main_Rst();
-		Set_Output_State(true_channel,output_off);
+
+		/* keep output on for wide-pw cal, because the effect of multiple 50 Ohm terminations
+		   can affect the timing */
+		if ((parameter == pwl_pw_values) &&
+		    (nominal_val > 100e-6) &&
+		    (globals.Flash.max_pw[channel] > 100e-6)) {
+			Set_Output_State(true_channel,output_on);
+		} else {
+			Set_Output_State(true_channel,output_off);
+		}
 		Main_update_shift_registers();
 		bus_setpin(PW_ENABLE, 1);	/* enable PW circuit (but output relay still off) */
 	}