summaryrefslogtreecommitdiff
AgeCommit message (Expand)Author
1999-12-31set delay to zero during PW and PRF calibrationroot
1999-12-31Revert "do not show polarity sign for positive-only amplitudes"root
1999-12-31Revert "Revert "add possibility to ignore voltage polarity set by user""root
1999-12-31Revert "add possibility to ignore voltage polarity set by user"root
1999-12-31add possibility to ignore voltage polarity set by userroot
2013-10-02do not show polarity sign for positive-only amplitudesMichael J. Chudobiak
2013-10-02Revert "added chans_opposite_polarities for AVR-D3-B-MS1 error checking"Michael J. Chudobiak
2013-10-02Revert "calculate ch1 min/max ampl correctly in AVR-D3-B"Michael J. Chudobiak
1999-12-31calculate ch1 min/max ampl correctly in AVR-D3-Broot
2013-10-02added chans_opposite_polarities for AVR-D3-B-MS1 error checkingMichael J. Chudobiak
2013-10-02don't show plus sign on delay if min_delay > 0Michael J. Chudobiak
1999-12-31boost "fixed" pw only in calibration moderoot
1999-12-31Boost "fixed" pw from OP1B in units with volt-ctrl-pw at low PRFs.root
1999-12-31version bump to 5.07INSTRUMENT_5_0_7root
1999-12-31added EW to submenusroot
1999-12-31allow main menu to display PW:EXTroot
1999-12-31implement the EW relay setting functionroot
1999-12-31fix to make diag:eprom:reset XXXX take effect right awayroot
2013-08-09add ew_xtra_rly config setting to flashMichael J. Chudobiak
2013-08-08added basic parser support for EW mode, and added ew_enabled to flashMichael J. Chudobiak
2013-08-08finish ab_mode chankey changesMichael J. Chudobiak
2013-08-08rename ab_mode vars to pw_ctrl_mode, and remove ab_mode chankeyMichael J. Chudobiak
2013-08-08rename ab_mode_allowed to pw_ab_mode_enabledMichael J. Chudobiak
2013-06-25version bump to 5.06INSTRUMENT_5_0_6Michael J. Chudobiak
2013-06-25forward-port multi-channel min/max fixes from 4.16Michael J. Chudobiak
1999-12-31version bump to 5.05INSTRUMENT_5_0_5root
1999-12-31put welcome greeting all on one lineroot
2013-04-26Send a idn command to the daemon and print the first line of it before accept...daniel
2013-04-26Add two defines to allow the frozen struct size to be either smaller or bigge...daniel
1999-12-31use narrower fixed PW on high PRF units like AVM-6-BINSTRUMENT_5_0_4root
1999-12-31version bump to 5.04root
2013-04-24Add a work around for the unaligned access and add some notes on what was hap...daniel
1999-12-31astyle overwrote symlinks. Reverse that.INSTRUMENT_5_0_3root
1999-12-31compile regexes before clearing boot screenroot
1999-12-31astyle fixesroot
1999-12-31fix initial menu write delay due to slow regex compilationroot
1999-12-31reset TNT4882 a little bit earlierroot
1999-12-31Don't show IP at startup - not ready anywayroot
2013-04-08version bumpMichael J. Chudobiak
2013-04-08add a dedicated pin to reset GPIB, becase SYS_RESETn is flakyMichael J. Chudobiak
1999-12-31when using attenuators, do not go to very top of raw ampl rangeINSTRUMENT_5_0_2root
1999-12-31allow attenuators to be disabled for amplitude calibrationtroot
1999-12-31use XTR_RLY1, not 5, to drive attenuator - in future, use I2Croot
2013-04-02implemented basic attenuator range function (but not in cal funcs)Michael J. Chudobiak
1999-12-31formatting fixes, removed debug printfsroot
2013-04-02fix typoMichael J. Chudobiak
2013-04-02switch to set_shiftreg_bits for better readabilityMichael J. Chudobiak
2013-04-02formatting fixesMichael J. Chudobiak
2013-04-02version bump to 5.02 for new attenuator functionalityMichael J. Chudobiak
2013-04-02added attenuator ranges to flashMichael J. Chudobiak
generated by cgit (git 2.34.1) at 2024-12-24 05:09:35 +0000