diff options
| -rw-r--r-- | include/configs/PMC440.h | 70 |
1 files changed, 43 insertions, 27 deletions
diff --git a/include/configs/PMC440.h b/include/configs/PMC440.h index 85342a60c3..7071ccbfe7 100644 --- a/include/configs/PMC440.h +++ b/include/configs/PMC440.h @@ -1,5 +1,5 @@ /* - * (C) Copyright 2007 + * (C) Copyright 2007-2008 * Matthias Fuchs, esd gmbh, matthias.fuchs@esd-electronics.com. * Based on the sequoia configuration file. * @@ -46,6 +46,7 @@ #endif #define CONFIG_BOARD_EARLY_INIT_F 1 /* Call board_early_init_f */ +#define CONFIG_MISC_INIT_F 1 #define CONFIG_MISC_INIT_R 1 /* Call misc_init_r */ #define CONFIG_BOARD_TYPES 1 /* support board types */ /*----------------------------------------------------------------------- @@ -79,6 +80,7 @@ #define CONFIG_SYS_USB_HOST 0xe0000400 #define CONFIG_SYS_FPGA_BASE0 0xef000000 /* 32 bit */ #define CONFIG_SYS_FPGA_BASE1 0xef100000 /* 16 bit */ +#define CONFIG_SYS_RESET_BASE 0xef200000 /*----------------------------------------------------------------------- * Initial RAM & stack pointer @@ -139,7 +141,7 @@ #ifdef CONFIG_ENV_IS_IN_FLASH #define CONFIG_ENV_SECT_SIZE 0x20000 /* size of one complete sector */ #define CONFIG_ENV_ADDR ((-CONFIG_SYS_MONITOR_LEN)-CONFIG_ENV_SECT_SIZE) -#define CONFIG_ENV_SIZE 0x2000 /* Total Size of Environment Sector */ +#define CONFIG_ENV_SIZE 0x2000 /* Total Size of Environment Sector */ /* Address and size of Redundant Environment Sector */ #define CONFIG_ENV_ADDR_REDUND (CONFIG_ENV_ADDR-CONFIG_ENV_SECT_SIZE) @@ -217,13 +219,15 @@ #if !defined(CONFIG_NAND_U_BOOT) && !defined(CONFIG_NAND_SPL) #define CONFIG_DDR_DATA_EYE /* use DDR2 optimization */ #endif +#define CFG_MEM_TOP_HIDE (4 << 10) /* don't use last 4kbytes */ + /* 440EPx errata CHIP 11 */ /*----------------------------------------------------------------------- * I2C *----------------------------------------------------------------------*/ #define CONFIG_HARD_I2C 1 /* I2C with hardware support */ #undef CONFIG_SOFT_I2C /* I2C bit-banged */ -#define CONFIG_SYS_I2C_SPEED 100000 /* I2C speed and slave address */ +#define CONFIG_SYS_I2C_SPEED 400000 /* I2C speed and slave address */ #define CONFIG_SYS_I2C_SLAVE 0x7F #define CONFIG_I2C_CMD_TREE 1 @@ -260,38 +264,50 @@ #define CONFIG_DTT_ADM1021 #define CONFIG_SYS_DTT_ADM1021 { { 0x4c, 0x02, 0, 1, 70, 0, 1, 70, 0} } -#define CONFIG_PREBOOT /* enable preboot variable */ +#define CONFIG_PREBOOT "echo Add \\\"run fpga\\\" and " \ + "\\\"painit\\\" to preboot command" #undef CONFIG_BOOTARGS /* Setup some board specific values for the default environment variables */ #define CONFIG_HOSTNAME pmc440 -#define CONFIG_SYS_BOOTFILE "bootfile=/tftpboot/pmc440/uImage\0" -#define CONFIG_SYS_ROOTPATH "rootpath=/opt/eldk_410/ppc_4xx\0" +#define CONFIG_SYS_BOOTFILE "bootfile=/tftpboot/pmc440/uImage\0" +#define CONFIG_SYS_ROOTPATH "rootpath=/opt/eldk/ppc_4xxFP\0" #define CONFIG_EXTRA_ENV_SETTINGS \ - CONFIG_SYS_BOOTFILE \ - CONFIG_SYS_ROOTPATH \ + CONFIG_SYS_BOOTFILE \ + CONFIG_SYS_ROOTPATH \ + "fdt_file=/tftpboot/pmc440/pmc440.dtb\0" \ "netdev=eth0\0" \ "ethrotate=no\0" \ "nfsargs=setenv bootargs root=/dev/nfs rw " \ "nfsroot=${serverip}:${rootpath}\0" \ "ramargs=setenv bootargs root=/dev/ram rw\0" \ "addip=setenv bootargs ${bootargs} " \ - "ip=${ipaddr}:${serverip}:${gatewayip}:${netmask}" \ - ":${hostname}:${netdev}:off panic=1\0" \ + "ip=${ipaddr}:${serverip}:${gatewayip}:${netmask}" \ + ":${hostname}:${netdev}:off panic=1\0" \ "addtty=setenv bootargs ${bootargs} console=ttyS0,${baudrate}\0" \ - "flash_nfs=run nfsargs addip addtty;" \ - "bootm ${kernel_addr}\0" \ - "flash_self=run ramargs addip addtty;" \ - "bootm ${kernel_addr} ${ramdisk_addr}\0" \ - "net_nfs=tftp 200000 ${bootfile};run nfsargs addip addtty;" \ - "bootm\0" \ - "kernel_addr=FC000000\0" \ - "ramdisk_addr=FC180000\0" \ + "addmisc=setenv bootargs ${bootargs} mem=${mem}\0" \ + "nandargs=setenv bootargs root=/dev/mtdblock6 rootfstype=jffs2 rw\0" \ + "nand_boot=run nandargs addip addtty addmisc;bootm ${kernel_addr}\0" \ + "nand_boot_fdt=run nandargs addip addtty addmisc;" \ + "bootm ${kernel_addr} - ${fdt_addr}\0" \ + "net_nfs=tftp ${kernel_addr_r} ${bootfile};" \ + "run nfsargs addip addtty addmisc;" \ + "bootm\0" \ + "net_nfs_fdt=tftp ${kernel_addr_r} ${bootfile};" \ + "tftp ${fdt_addr_r} ${fdt_file};" \ + "run nfsargs addip addtty addmisc;" \ + "bootm ${kernel_addr_r} - ${fdt_addr_r}\0" \ + "kernel_addr=ffc00000\0" \ + "kernel_addr_r=200000\0" \ + "fpga_addr=fff00000\0" \ + "fdt_addr=fff80000\0" \ + "fdt_addr_r=800000\0" \ + "fpga=fpga loadb 0 ${fpga_addr}\0" \ "load=tftp 200000 /tftpboot/pmc440/u-boot.bin\0" \ - "update=protect off FFFA0000 FFFFFFFF;era FFFA0000 FFFFFFFF;" \ - "cp.b 200000 FFFA0000 60000\0" \ + "update=protect off fffa0000 ffffffff;era fffa0000 ffffffff;" \ + "cp.b 200000 fffa0000 60000\0" \ "" #define CONFIG_BOOTDELAY 3 /* autoboot after 3 seconds */ @@ -366,14 +382,8 @@ CONFIG_SYS_POST_SPR) #define CONFIG_SYS_POST_WORD_ADDR (CONFIG_SYS_GBL_DATA_OFFSET - 0x4) - -/* esd expects pram at end of physical memory. - * So no logbuffer at the moment. - */ -#if 0 #define CONFIG_LOGBUFFER -#endif -#define CONFIG_SYS_POST_CACHE_ADDR 0x10000000 /* free virtual address */ +#define CONFIG_SYS_POST_CACHE_ADDR 0x7fff0000 /* free virtual address */ #define CONFIG_SYS_CONSOLE_IS_IN_ENV /* Otherwise it catches logbuffer as output */ @@ -478,6 +488,10 @@ #define CONFIG_SYS_EBC_PB0CR (CONFIG_SYS_NAND_ADDR | 0x1c000) #endif +/* Memory Bank 1 (RESET) initialization */ +#define CFG_EBC_PB1AP 0x7f817200 //0x03017200 +#define CFG_EBC_PB1CR (CFG_RESET_BASE | 0x1c000) + /* Memory Bank 4 (FPGA / 32Bit) initialization */ #define CONFIG_SYS_EBC_PB4AP 0x03840f40 /* BME=0,TWT=7,CSN=1,TH=7,RE=1,SOR=0,BEM=1 */ #define CONFIG_SYS_EBC_PB4CR (CONFIG_SYS_FPGA_BASE0 | 0x1c000) /* BS=1M,BU=R/W,BW=32bit */ @@ -512,4 +526,6 @@ #define CONFIG_OF_LIBFDT 1 #define CONFIG_OF_BOARD_SETUP 1 +#define CONFIG_API 1 + #endif /* __CONFIG_H */ |