diff options
Diffstat (limited to 'arch/arm/cpu/armv7/uniphier/Kconfig')
| -rw-r--r-- | arch/arm/cpu/armv7/uniphier/Kconfig | 74 |
1 files changed, 71 insertions, 3 deletions
diff --git a/arch/arm/cpu/armv7/uniphier/Kconfig b/arch/arm/cpu/armv7/uniphier/Kconfig index 524b193e58..0556e4b350 100644 --- a/arch/arm/cpu/armv7/uniphier/Kconfig +++ b/arch/arm/cpu/armv7/uniphier/Kconfig @@ -5,15 +5,17 @@ config SYS_SOC default "uniphier" config SYS_CONFIG_NAME - default "ph1_pro4" if MACH_PH1_PRO4 - default "ph1_ld4" if MACH_PH1_LD4 - default "ph1_sld8" if MACH_PH1_SLD8 + default "uniphier" + +config UNIPHIER_SMP + bool choice prompt "UniPhier SoC select" config MACH_PH1_PRO4 bool "PH1-Pro4" + select UNIPHIER_SMP config MACH_PH1_LD4 bool "PH1-LD4" @@ -23,4 +25,70 @@ config MACH_PH1_SLD8 endchoice +choice + prompt "UniPhier Support Card select" + optional + +config PFC_MICRO_SUPPORT_CARD + bool "Support card with PFC CPLD" + help + This option provides support for the expansion board with PFC + original address mapping. + + Say Y to use the on-board UART, Ether, LED devices. + +config DCC_MICRO_SUPPORT_CARD + bool "Support card with DCC CPLD" + help + This option provides support for the expansion board with DCC- + arranged address mapping that is compatible with legacy UniPhier + reference boards. + + Say Y to use the on-board UART, Ether, LED devices. + +endchoice + +config CMD_PINMON + bool "Enable boot mode pins monitor command" + depends on !SPL_BUILD + default y + help + The command "pinmon" shows the state of the boot mode pins. + The boot mode pins are latched when the system reset is deasserted + and determine which device the system should load a boot image from. + +config SOC_INIT + bool + default SPL_BUILD + +config DRAM_INIT + bool + default SPL_BUILD + +config CMD_DDRPHY_DUMP + bool "Enable dump command of DDR PHY parameters" + depends on !SPL_BUILD + help + The command "ddrphy" shows the resulting parameters of DDR PHY + training; it is useful for the evaluation of DDR PHY training. + +choice + prompt "DDR3 Frequency select" + depends on DRAM_INIT + +config DDR_FREQ_1600 + bool "DDR3 1600" + depends on MACH_PH1_PRO4 || MACH_PH1_LD4 + +config DDR_FREQ_1333 + bool "DDR3 1333" + depends on MACH_PH1_LD4 || MACH_PH1_SLD8 + +endchoice + +config DDR_FREQ + int + default 1333 if DDR_FREQ_1333 + default 1600 if DDR_FREQ_1600 + endmenu |