diff options
Diffstat (limited to 'arch/arm/cpu/armv8/fsl-layerscape/doc')
| -rw-r--r-- | arch/arm/cpu/armv8/fsl-layerscape/doc/README.lsch3 | 29 |
1 files changed, 29 insertions, 0 deletions
diff --git a/arch/arm/cpu/armv8/fsl-layerscape/doc/README.lsch3 b/arch/arm/cpu/armv8/fsl-layerscape/doc/README.lsch3 index f9323c1d28..da5e052569 100644 --- a/arch/arm/cpu/armv8/fsl-layerscape/doc/README.lsch3 +++ b/arch/arm/cpu/armv8/fsl-layerscape/doc/README.lsch3 @@ -121,6 +121,35 @@ mcboottimeout: MC boot timeout in milliseconds. If this variable is not defined mcmemsize: MC DRAM block size. If this variable is not defined, the value CONFIG_SYS_LS_MC_DRAM_BLOCK_MIN_SIZE will be assumed. +mcinitcmd: This environment variable is defined to initiate MC and DPL deployment + from the location where it is stored(NOR, NAND, SD, SATA, USB)during + u-boot booting.If this variable is not defined then MC_BOOT_ENV_VAR + will be null and MC will not be booted and DPL will not be applied + during U-boot booting.However the MC, DPC and DPL can be applied from + console independently. + The variable needs to be set from the console once and then on + rebooting the parameters set in the varible will automatically be + executed. The commmand is demostrated taking an example of mc boot + using NOR Flash i.e. MC, DPL, and DPC is stored in the NOR flash: + + cp.b 0xa0000000 0x580300000 $filesize + cp.b 0x80000000 0x580800000 $filesize + cp.b 0x90000000 0x580700000 $filesize + + setenv mcinitcmd 'fsl_mc start mc 0x580300000 0x580800000' + + If only linux is to be booted then the mcinitcmd environment should be set as + + setenv mcinitcmd 'fsl_mc start mc 0x580300000 0x580800000;fsl_mc apply DPL 0x580700000' + + Here the addresses 0xa0000000, 0x80000000, 0x80000000 are of DDR to where + MC binary, DPC binary and DPL binary are stored and 0x580300000, 0x580800000 + and 0x580700000 are addresses in NOR where these are copied. It is to be + noted that these addresses in 'fsl_mc start mc 0x580300000 0x580800000;fsl_mc apply DPL 0x580700000' + can be replaced with the addresses of DDR to + which these will be copied in case of these binaries being stored in other + devices like SATA, USB, NAND, SD etc. + Booting from NAND ------------------- Booting from NAND requires two images, RCW and u-boot-with-spl.bin. |