diff options
Diffstat (limited to 'arch/arm/dts/rk3328-evb.dts')
-rw-r--r-- | arch/arm/dts/rk3328-evb.dts | 220 |
1 files changed, 128 insertions, 92 deletions
diff --git a/arch/arm/dts/rk3328-evb.dts b/arch/arm/dts/rk3328-evb.dts index a2ee838fcd..6abc6f4a86 100644 --- a/arch/arm/dts/rk3328-evb.dts +++ b/arch/arm/dts/rk3328-evb.dts @@ -1,6 +1,6 @@ -// SPDX-License-Identifier: GPL-2.0+ +// SPDX-License-Identifier: (GPL-2.0+ OR MIT) /* - * (C) Copyright 2016 Rockchip Electronics Co., Ltd + * Copyright (c) 2017 Fuzhou Rockchip Electronics Co., Ltd */ /dts-v1/; @@ -11,40 +11,51 @@ compatible = "rockchip,rk3328-evb", "rockchip,rk3328"; chosen { - stdout-path = &uart2; + stdout-path = "serial2:1500000n8"; }; - gmac_clkin: external-gmac-clock { - compatible = "fixed-clock"; - clock-frequency = <125000000>; - clock-output-names = "gmac_clkin"; - #clock-cells = <0>; - }; - - vcc3v3_sdmmc: sdmmc-pwren { + dc_12v: dc-12v { compatible = "regulator-fixed"; - regulator-name = "vcc3v3"; - gpio = <&gpio0 30 GPIO_ACTIVE_LOW>; + regulator-name = "dc_12v"; regulator-always-on; regulator-boot-on; + regulator-min-microvolt = <12000000>; + regulator-max-microvolt = <12000000>; + }; + + sdio_pwrseq: sdio-pwrseq { + compatible = "mmc-pwrseq-simple"; + pinctrl-names = "default"; + pinctrl-0 = <&wifi_enable_h>; + + /* + * On the module itself this is one of these (depending + * on the actual card populated): + * - SDIO_RESET_L_WL_REG_ON + * - PDN (power down when low) + */ + reset-gpios = <&gpio1 18 GPIO_ACTIVE_LOW>; }; - vcc5v0_otg: vcc5v0-otg-drv { + vcc_sd: sdmmc-regulator { compatible = "regulator-fixed"; - enable-active-high; - regulator-name = "vcc5v0_otg"; - gpio = <&gpio0 27 GPIO_ACTIVE_HIGH>; - regulator-min-microvolt = <5000000>; - regulator-max-microvolt = <5000000>; + gpio = <&gpio0 30 GPIO_ACTIVE_LOW>; + pinctrl-names = "default"; + pinctrl-0 = <&sdmmc0m1_gpio>; + regulator-name = "vcc_sd"; + regulator-min-microvolt = <3300000>; + regulator-max-microvolt = <3300000>; + vin-supply = <&vcc_io>; }; - vcc5v0_host_xhci: vcc5v0-host-xhci-drv { + vcc_sys: vcc-sys { compatible = "regulator-fixed"; - enable-active-high; - regulator-name = "vcc5v0_host_xhci"; - gpio = <&gpio0 0 GPIO_ACTIVE_HIGH>; + regulator-name = "vcc_sys"; + regulator-always-on; + regulator-boot-on; regulator-min-microvolt = <5000000>; regulator-max-microvolt = <5000000>; + vin-supply = <&dc_12v>; }; vcc_phy: vcc-phy-regulator { @@ -55,96 +66,60 @@ }; }; -&saradc { - status = "okay"; -}; - -&uart2 { - status = "okay"; -}; - -&sdmmc { - bus-width = <4>; - cap-mmc-highspeed; - cap-sd-highspeed; - card-detect-delay = <200>; - disable-wp; - num-slots = <1>; - pinctrl-names = "default"; - pinctrl-0 = <&sdmmc0_clk>, <&sdmmc0_cmd>, <&sdmmc0_dectn>, <&sdmmc0_bus4>; - status = "okay"; +&cpu0 { + cpu-supply = <&vdd_arm>; }; &emmc { bus-width = <8>; cap-mmc-highspeed; - supports-emmc; - disable-wp; non-removable; - num-slots = <1>; pinctrl-names = "default"; pinctrl-0 = <&emmc_clk &emmc_cmd &emmc_bus8>; status = "okay"; }; -&gmac2io { +&gmac2phy { phy-supply = <&vcc_phy>; - phy-mode = "rgmii"; - clock_in_out = "input"; - snps,reset-gpio = <&gpio1 RK_PC2 GPIO_ACTIVE_LOW>; - snps,reset-active-low; - snps,reset-delays-us = <0 10000 50000>; - assigned-clocks = <&cru SCLK_MAC2IO>, <&cru SCLK_MAC2IO_EXT>; - assigned-clock-parents = <&gmac_clkin>, <&gmac_clkin>; - pinctrl-names = "default"; - pinctrl-0 = <&rgmiim1_pins>; - tx_delay = <0x26>; - rx_delay = <0x11>; - status = "okay"; -}; - -&usb_host0_ehci { - status = "okay"; -}; + clock_in_out = "output"; + assigned-clocks = <&cru SCLK_MAC2PHY_SRC>; + assigned-clock-rate = <50000000>; + assigned-clocks = <&cru SCLK_MAC2PHY>; + assigned-clock-parents = <&cru SCLK_MAC2PHY_SRC>; -&usb_host0_ohci { - status = "okay"; -}; - -&usb20_otg { - vbus-supply = <&vcc5v0_otg>; - status = "okay"; }; &i2c1 { - clock-frequency = <400000>; - i2c-scl-rising-time-ns = <168>; - i2c-scl-falling-time-ns = <4>; status = "okay"; rk805: pmic@18 { compatible = "rockchip,rk805"; - status = "okay"; reg = <0x18>; interrupt-parent = <&gpio2>; interrupts = <6 IRQ_TYPE_LEVEL_LOW>; + #clock-cells = <1>; + clock-output-names = "xin32k", "rk805-clkout2"; + gpio-controller; + #gpio-cells = <2>; pinctrl-names = "default"; pinctrl-0 = <&pmic_int_l>; rockchip,system-power-controller; wakeup-source; - gpio-controller; - #gpio-cells = <2>; - #clock-cells = <1>; - clock-output-names = "xin32k", "rk805-clkout2"; + + vcc1-supply = <&vcc_sys>; + vcc2-supply = <&vcc_sys>; + vcc3-supply = <&vcc_sys>; + vcc4-supply = <&vcc_sys>; + vcc5-supply = <&vcc_io>; + vcc6-supply = <&vcc_io>; regulators { vdd_logic: DCDC_REG1 { regulator-name = "vdd_logic"; regulator-min-microvolt = <712500>; regulator-max-microvolt = <1450000>; - regulator-ramp-delay = <6001>; - regulator-boot-on; regulator-always-on; + regulator-boot-on; regulator-state-mem { regulator-on-in-suspend; regulator-suspend-microvolt = <1000000>; @@ -155,19 +130,18 @@ regulator-name = "vdd_arm"; regulator-min-microvolt = <712500>; regulator-max-microvolt = <1450000>; - regulator-ramp-delay = <6001>; - regulator-boot-on; regulator-always-on; + regulator-boot-on; regulator-state-mem { regulator-on-in-suspend; - regulator-suspend-microvolt = <1000000>; + regulator-suspend-microvolt = <950000>; }; }; vcc_ddr: DCDC_REG3 { regulator-name = "vcc_ddr"; - regulator-boot-on; regulator-always-on; + regulator-boot-on; regulator-state-mem { regulator-on-in-suspend; }; @@ -177,32 +151,32 @@ regulator-name = "vcc_io"; regulator-min-microvolt = <3300000>; regulator-max-microvolt = <3300000>; - regulator-boot-on; regulator-always-on; + regulator-boot-on; regulator-state-mem { regulator-on-in-suspend; regulator-suspend-microvolt = <3300000>; }; }; - vdd_18: LDO_REG1 { - regulator-name = "vdd_18"; + vcc_18: LDO_REG1 { + regulator-name = "vcc_18"; regulator-min-microvolt = <1800000>; regulator-max-microvolt = <1800000>; - regulator-boot-on; regulator-always-on; + regulator-boot-on; regulator-state-mem { regulator-on-in-suspend; regulator-suspend-microvolt = <1800000>; }; }; - vcc_18emmc: LDO_REG2 { - regulator-name = "vcc_18emmc"; + vcc18_emmc: LDO_REG2 { + regulator-name = "vcc18_emmc"; regulator-min-microvolt = <1800000>; regulator-max-microvolt = <1800000>; - regulator-boot-on; regulator-always-on; + regulator-boot-on; regulator-state-mem { regulator-on-in-suspend; regulator-suspend-microvolt = <1800000>; @@ -213,8 +187,8 @@ regulator-name = "vdd_10"; regulator-min-microvolt = <1000000>; regulator-max-microvolt = <1000000>; - regulator-boot-on; regulator-always-on; + regulator-boot-on; regulator-state-mem { regulator-on-in-suspend; regulator-suspend-microvolt = <1000000>; @@ -227,9 +201,71 @@ &pinctrl { pmic { pmic_int_l: pmic-int-l { + rockchip,pins = <2 RK_PA6 RK_FUNC_GPIO &pcfg_pull_up>; + }; + }; + + sdio-pwrseq { + wifi_enable_h: wifi-enable-h { rockchip,pins = - <2 RK_PA6 RK_FUNC_GPIO &pcfg_pull_up>; /* gpio2_a6 */ + <1 RK_PC2 RK_FUNC_GPIO &pcfg_pull_none>; }; }; }; +&sdio { + bus-width = <4>; + cap-sd-highspeed; + cap-sdio-irq; + keep-power-in-suspend; + max-frequency = <150000000>; + mmc-pwrseq = <&sdio_pwrseq>; + non-removable; + pinctrl-names = "default"; + pinctrl-0 = <&sdmmc1_bus4 &sdmmc1_cmd &sdmmc1_clk>; + status = "okay"; +}; + +&sdmmc { + bus-width = <4>; + cap-mmc-highspeed; + cap-sd-highspeed; + disable-wp; + max-frequency = <150000000>; + pinctrl-names = "default"; + pinctrl-0 = <&sdmmc0_clk &sdmmc0_cmd &sdmmc0_dectn &sdmmc0_bus4>; + vmmc-supply = <&vcc_sd>; + status = "okay"; +}; + +&tsadc { + status = "okay"; +}; + +&uart2 { + status = "okay"; +}; + +&u2phy { + status = "okay"; +}; + +&u2phy_host { + status = "okay"; +}; + +&u2phy_otg { + status = "okay"; +}; + +&usb20_otg { + status = "okay"; +}; + +&usb_host0_ehci { + status = "okay"; +}; + +&usb_host0_ohci { + status = "okay"; +}; |