diff options
Diffstat (limited to 'arch/arm/include/asm/arch-armada-xp/config.h')
| -rw-r--r-- | arch/arm/include/asm/arch-armada-xp/config.h | 82 |
1 files changed, 82 insertions, 0 deletions
diff --git a/arch/arm/include/asm/arch-armada-xp/config.h b/arch/arm/include/asm/arch-armada-xp/config.h new file mode 100644 index 0000000000..00ee775a45 --- /dev/null +++ b/arch/arm/include/asm/arch-armada-xp/config.h @@ -0,0 +1,82 @@ +/* + * (C) Copyright 2011 + * Marvell Semiconductor <www.marvell.com> + * Written-by: Lei Wen <leiwen@marvell.com> + * + * SPDX-License-Identifier: GPL-2.0+ + */ + +/* + * This file should be included in board config header file. + * + * It supports common definitions for Armada XP platforms + */ + +#ifndef _ARMADA_XP_CONFIG_H +#define _ARMADA_XP_CONFIG_H + +#include <asm/arch/soc.h> + +#define MV88F78X60 /* for the DDR training bin_hdr code */ + +#define CONFIG_SYS_CACHELINE_SIZE 32 + +/* + * By default kwbimage.cfg from board specific folder is used + * If for some board, different configuration file need to be used, + * CONFIG_SYS_KWD_CONFIG should be defined in board specific header file + */ +#ifndef CONFIG_SYS_KWD_CONFIG +#define CONFIG_SYS_KWD_CONFIG $(CONFIG_BOARDDIR)/kwbimage.cfg +#endif /* CONFIG_SYS_KWD_CONFIG */ + +/* Add target to build it automatically upon "make" */ +#define CONFIG_BUILD_TARGET "u-boot.kwb" + +/* end of 16M scrubbed by training in bootrom */ +#define CONFIG_SYS_INIT_SP_ADDR 0x00FF0000 +#define CONFIG_NR_DRAM_BANKS_MAX 2 + +#define MV_UART_CONSOLE_BASE MVEBU_UART0_BASE + +/* + * SPI Flash configuration + */ +#ifdef CONFIG_CMD_SF +#define CONFIG_HARD_SPI 1 +#define CONFIG_KIRKWOOD_SPI 1 +#ifndef CONFIG_ENV_SPI_BUS +# define CONFIG_ENV_SPI_BUS 0 +#endif +#ifndef CONFIG_ENV_SPI_CS +# define CONFIG_ENV_SPI_CS 0 +#endif +#ifndef CONFIG_ENV_SPI_MAX_HZ +# define CONFIG_ENV_SPI_MAX_HZ 50000000 +#endif +#endif + +/* + * Ethernet Driver configuration + */ +#ifdef CONFIG_CMD_NET +#define CONFIG_CMD_MII +#define CONFIG_MII /* expose smi ove miiphy interface */ +#define CONFIG_MVNETA /* Enable Marvell Gbe Controller Driver */ +#define CONFIG_PHYLIB +#define CONFIG_ENV_OVERWRITE /* ethaddr can be reprogrammed */ +#define CONFIG_PHY_GIGE /* GbE speed/duplex detect */ +#endif /* CONFIG_CMD_NET */ + +/* + * I2C related stuff + */ +#ifdef CONFIG_CMD_I2C +#ifndef CONFIG_SYS_I2C_SOFT +#define CONFIG_I2C_MVTWSI +#endif +#define CONFIG_SYS_I2C_SLAVE 0x0 +#define CONFIG_SYS_I2C_SPEED 100000 +#endif + +#endif /* _ARMADA_XP_CONFIG_H */ |