diff options
Diffstat (limited to 'arch/arm/mach-omap2/am33xx/ddr.c')
| -rw-r--r-- | arch/arm/mach-omap2/am33xx/ddr.c | 33 |
1 files changed, 29 insertions, 4 deletions
diff --git a/arch/arm/mach-omap2/am33xx/ddr.c b/arch/arm/mach-omap2/am33xx/ddr.c index be6f4d72cc..3fd1d086ff 100644 --- a/arch/arm/mach-omap2/am33xx/ddr.c +++ b/arch/arm/mach-omap2/am33xx/ddr.c @@ -80,6 +80,11 @@ static void configure_mr(int nr, u32 cs) */ void config_sdram_emif4d5(const struct emif_regs *regs, int nr) { +#ifdef CONFIG_AM43XX + struct prm_device_inst *prm_device = + (struct prm_device_inst *)PRM_DEVICE_INST; +#endif + writel(0xA0, &emif_reg[nr]->emif_pwr_mgmt_ctrl); writel(0xA0, &emif_reg[nr]->emif_pwr_mgmt_ctrl_shdw); writel(regs->zq_config, &emif_reg[nr]->emif_zq_config); @@ -126,6 +131,15 @@ void config_sdram_emif4d5(const struct emif_regs *regs, int nr) writel(regs->ref_ctrl, &emif_reg[nr]->emif_sdram_ref_ctrl); writel(regs->ref_ctrl, &emif_reg[nr]->emif_sdram_ref_ctrl_shdw); +#ifdef CONFIG_AM43XX + /* + * Disable EMIF_DEVOFF + * -> Cold Boot: This is just rewriting the default register value. + * -> RTC Resume: Must disable DEVOFF before leveling. + */ + writel(0, &prm_device->emif_ctrl); +#endif + /* Perform hardware leveling for DDR3 */ if (emif_sdram_type(regs->sdram_config) == EMIF_SDRAM_TYPE_DDR3) { writel(readl(&emif_reg[nr]->emif_ddr_ext_phy_ctrl_36) | @@ -138,6 +152,9 @@ void config_sdram_emif4d5(const struct emif_regs *regs, int nr) /* Enable read leveling */ writel(0x80000000, &emif_reg[nr]->emif_rd_wr_lvl_ctl); + /* Wait 1ms because of L3 timeout error */ + udelay(1000); + /* * Enable full read and write leveling. Wait for read and write * leveling bit to clear RDWRLVLFULL_START bit 31 @@ -256,8 +273,16 @@ static void ext_phy_settings_hwlvl(const struct emif_regs *regs, int nr) * Enable hardware leveling on the EMIF. For details about these * magic values please see the EMIF registers section of the TRM. */ - writel(0x08020080, &emif_reg[nr]->emif_ddr_ext_phy_ctrl_1); - writel(0x08020080, &emif_reg[nr]->emif_ddr_ext_phy_ctrl_1_shdw); + if (regs->emif_ddr_phy_ctlr_1 & 0x00040000) { + /* PHY_INVERT_CLKOUT = 1 */ + writel(0x00040100, &emif_reg[nr]->emif_ddr_ext_phy_ctrl_1); + writel(0x00040100, &emif_reg[nr]->emif_ddr_ext_phy_ctrl_1_shdw); + } else { + /* PHY_INVERT_CLKOUT = 0 */ + writel(0x08020080, &emif_reg[nr]->emif_ddr_ext_phy_ctrl_1); + writel(0x08020080, &emif_reg[nr]->emif_ddr_ext_phy_ctrl_1_shdw); + } + writel(0x00000000, &emif_reg[nr]->emif_ddr_ext_phy_ctrl_22); writel(0x00000000, &emif_reg[nr]->emif_ddr_ext_phy_ctrl_22_shdw); writel(0x00600020, &emif_reg[nr]->emif_ddr_ext_phy_ctrl_23); @@ -286,8 +311,8 @@ static void ext_phy_settings_hwlvl(const struct emif_regs *regs, int nr) writel(0x00000000, &emif_reg[nr]->emif_ddr_ext_phy_ctrl_34_shdw); writel(0x00000000, &emif_reg[nr]->emif_ddr_ext_phy_ctrl_35); writel(0x00000000, &emif_reg[nr]->emif_ddr_ext_phy_ctrl_35_shdw); - writel(0x000000FF, &emif_reg[nr]->emif_ddr_ext_phy_ctrl_36); - writel(0x000000FF, &emif_reg[nr]->emif_ddr_ext_phy_ctrl_36_shdw); + writel(0x00000077, &emif_reg[nr]->emif_ddr_ext_phy_ctrl_36); + writel(0x00000077, &emif_reg[nr]->emif_ddr_ext_phy_ctrl_36_shdw); /* * Sequence to ensure that the PHY is again in a known state after |