diff options
Diffstat (limited to 'arch/blackfin/include/asm/mach-bf518/anomaly.h')
| -rw-r--r-- | arch/blackfin/include/asm/mach-bf518/anomaly.h | 170 |
1 files changed, 0 insertions, 170 deletions
diff --git a/arch/blackfin/include/asm/mach-bf518/anomaly.h b/arch/blackfin/include/asm/mach-bf518/anomaly.h deleted file mode 100644 index 56383f7cbc..0000000000 --- a/arch/blackfin/include/asm/mach-bf518/anomaly.h +++ /dev/null @@ -1,170 +0,0 @@ -/* - * DO NOT EDIT THIS FILE - * This file is under version control at - * svn://sources.blackfin.uclinux.org/toolchain/trunk/proc-defs/header-frags/ - * and can be replaced with that version at any time - * DO NOT EDIT THIS FILE - * - * Copyright 2004-2011 Analog Devices Inc. - * Licensed under the ADI BSD license. - * https://docs.blackfin.uclinux.org/doku.php?id=adi_bsd - */ - -/* This file should be up to date with: - * - Revision F, 05/23/2011; ADSP-BF512/BF514/BF516/BF518 Blackfin Processor Anomaly List - */ - -#if __SILICON_REVISION__ < 0 -# error will not work on BF518 silicon version -#endif - -#ifndef _MACH_ANOMALY_H_ -#define _MACH_ANOMALY_H_ - -/* Multi-Issue Instruction with dsp32shiftimm in slot1 and P-reg Store in slot2 Not Supported */ -#define ANOMALY_05000074 (1) -/* DMA_RUN Bit Is Not Valid after a Peripheral Receive Channel DMA Stops */ -#define ANOMALY_05000119 (1) -/* Rx.H Cannot Be Used to Access 16-bit System MMR Registers */ -#define ANOMALY_05000122 (1) -/* False Hardware Error from an Access in the Shadow of a Conditional Branch */ -#define ANOMALY_05000245 (1) -/* Incorrect Timer Pulse Width in Single-Shot PWM_OUT Mode with External Clock */ -#define ANOMALY_05000254 (1) -/* Sensitivity To Noise with Slow Input Edge Rates on External SPORT TX and RX Clocks */ -#define ANOMALY_05000265 (1) -/* False Hardware Errors Caused by Fetches at the Boundary of Reserved Memory */ -#define ANOMALY_05000310 (1) -/* PPI Underflow Error Goes Undetected in ITU-R 656 Mode */ -#define ANOMALY_05000366 (1) -/* Lockbox SESR Firmware Does Not Save/Restore Full Context */ -#define ANOMALY_05000405 (1) -/* Lockbox Firmware Memory Cleanup Routine Does not Clear Registers */ -#define ANOMALY_05000408 (1) -/* Speculative Fetches Can Cause Undesired External FIFO Operations */ -#define ANOMALY_05000416 (1) -/* TWI Fall Time (Tof) May Violate the Minimum I2C Specification */ -#define ANOMALY_05000421 (1) -/* TWI Input Capacitance (Ci) May Violate the Maximum I2C Specification */ -#define ANOMALY_05000422 (1) -/* Speculative Fetches of Indirect-Pointer Instructions Can Cause False Hardware Errors */ -#define ANOMALY_05000426 (1) -/* Software System Reset Corrupts PLL_LOCKCNT Register */ -#define ANOMALY_05000430 (__SILICON_REVISION__ < 1) -/* Incorrect Use of Stack in Lockbox Firmware During Authentication */ -#define ANOMALY_05000431 (1) -/* SW Breakpoints Ignored Upon Return From Lockbox Authentication */ -#define ANOMALY_05000434 (1) -/* Certain SIC Registers are not Reset After Soft or Core Double Fault Reset */ -#define ANOMALY_05000435 (__SILICON_REVISION__ < 1) -/* PORTx_DRIVE and PORTx_HYSTERESIS Registers Read Back Incorrect Values */ -#define ANOMALY_05000438 (__SILICON_REVISION__ < 1) -/* Preboot Cannot be Used to Alter the PLL_DIV Register */ -#define ANOMALY_05000439 (__SILICON_REVISION__ < 1) -/* bfrom_SysControl() Cannot be Used to Write the PLL_DIV Register */ -#define ANOMALY_05000440 (__SILICON_REVISION__ < 1) -/* IFLUSH Instruction at End of Hardware Loop Causes Infinite Stall */ -#define ANOMALY_05000443 (1) -/* Incorrect L1 Instruction Bank B Memory Map Location */ -#define ANOMALY_05000444 (__SILICON_REVISION__ < 1) -/* Incorrect Default Hysteresis Setting for RESET, NMI, and BMODE Signals */ -#define ANOMALY_05000452 (__SILICON_REVISION__ < 1) -/* PWM_TRIPB Signal Not Available on PG10 */ -#define ANOMALY_05000453 (__SILICON_REVISION__ < 1) -/* PPI_FS3 is Driven One Half Cycle Later Than PPI Data */ -#define ANOMALY_05000455 (__SILICON_REVISION__ < 1) -/* False Hardware Error when RETI Points to Invalid Memory */ -#define ANOMALY_05000461 (1) -/* Synchronization Problem at Startup May Cause SPORT Transmit Channels to Misalign */ -#define ANOMALY_05000462 (__SILICON_REVISION__ < 2) -/* Incorrect Default MSEL Value in PLL_CTL */ -#define ANOMALY_05000472 (__SILICON_REVISION__ < 2) -/* Interrupted SPORT Receive Data Register Read Results In Underflow when SLEN > 15 */ -#define ANOMALY_05000473 (1) -/* TESTSET Instruction Cannot Be Interrupted */ -#define ANOMALY_05000477 (1) -/* Reads of ITEST_COMMAND and ITEST_DATA Registers Cause Cache Corruption */ -#define ANOMALY_05000481 (1) -/* PLL Latches Incorrect Settings During Reset */ -#define ANOMALY_05000482 (__SILICON_REVISION__ < 2) -/* PLL_CTL Change Using bfrom_SysControl() Can Result in Processor Overclocking */ -#define ANOMALY_05000485 (__SILICON_REVISION__ < 2) -/* SPI Master Boot Can Fail Under Certain Conditions */ -#define ANOMALY_05000490 (1) -/* Instruction Memory Stalls Can Cause IFLUSH to Fail */ -#define ANOMALY_05000491 (1) -/* EXCPT Instruction May Be Lost If NMI Happens Simultaneously */ -#define ANOMALY_05000494 (1) -/* CNT_COMMAND Functionality Depends on CNT_IMASK Configuration */ -#define ANOMALY_05000498 (1) -/* RXS Bit in SPI_STAT May Become Stuck In RX DMA Modes */ -#define ANOMALY_05000501 (1) - -/* Anomalies that don't exist on this proc */ -#define ANOMALY_05000099 (0) -#define ANOMALY_05000120 (0) -#define ANOMALY_05000125 (0) -#define ANOMALY_05000149 (0) -#define ANOMALY_05000158 (0) -#define ANOMALY_05000171 (0) -#define ANOMALY_05000179 (0) -#define ANOMALY_05000182 (0) -#define ANOMALY_05000183 (0) -#define ANOMALY_05000189 (0) -#define ANOMALY_05000198 (0) -#define ANOMALY_05000202 (0) -#define ANOMALY_05000215 (0) -#define ANOMALY_05000219 (0) -#define ANOMALY_05000220 (0) -#define ANOMALY_05000227 (0) -#define ANOMALY_05000230 (0) -#define ANOMALY_05000231 (0) -#define ANOMALY_05000233 (0) -#define ANOMALY_05000234 (0) -#define ANOMALY_05000242 (0) -#define ANOMALY_05000244 (0) -#define ANOMALY_05000248 (0) -#define ANOMALY_05000250 (0) -#define ANOMALY_05000257 (0) -#define ANOMALY_05000261 (0) -#define ANOMALY_05000263 (0) -#define ANOMALY_05000266 (0) -#define ANOMALY_05000273 (0) -#define ANOMALY_05000274 (0) -#define ANOMALY_05000278 (0) -#define ANOMALY_05000281 (0) -#define ANOMALY_05000283 (0) -#define ANOMALY_05000285 (0) -#define ANOMALY_05000287 (0) -#define ANOMALY_05000301 (0) -#define ANOMALY_05000305 (0) -#define ANOMALY_05000307 (0) -#define ANOMALY_05000311 (0) -#define ANOMALY_05000312 (0) -#define ANOMALY_05000315 (0) -#define ANOMALY_05000323 (0) -#define ANOMALY_05000353 (0) -#define ANOMALY_05000357 (0) -#define ANOMALY_05000362 (1) -#define ANOMALY_05000363 (0) -#define ANOMALY_05000364 (0) -#define ANOMALY_05000371 (0) -#define ANOMALY_05000380 (0) -#define ANOMALY_05000383 (0) -#define ANOMALY_05000386 (0) -#define ANOMALY_05000389 (0) -#define ANOMALY_05000400 (0) -#define ANOMALY_05000402 (0) -#define ANOMALY_05000412 (0) -#define ANOMALY_05000432 (0) -#define ANOMALY_05000447 (0) -#define ANOMALY_05000448 (0) -#define ANOMALY_05000456 (0) -#define ANOMALY_05000450 (0) -#define ANOMALY_05000465 (0) -#define ANOMALY_05000467 (0) -#define ANOMALY_05000474 (0) -#define ANOMALY_05000475 (0) -#define ANOMALY_05000480 (0) - -#endif |