6 files changed, 9 insertions, 23 deletions
diff --git a/board/BuR/common/bur_common.h b/board/BuR/common/bur_common.h
index 39afbba7db..e4896fba14 100644
--- a/board/BuR/common/bur_common.h
+++ b/board/BuR/common/bur_common.h
@@ -16,10 +16,9 @@
 
 int load_lcdtiming(struct am335x_lcdpanel *panel);
 void br_summaryscreen(void);
-void blink(u32 blinks, u32 intervall, u32 pin);
 void pmicsetup(u32 mpupll);
 void enable_uart0_pin_mux(void);
-void enable_i2c0_pin_mux(void);
+void enable_i2c_pin_mux(void);
 void enable_board_pin_mux(void);
 int board_eth_init(bd_t *bis);
 
diff --git a/board/BuR/common/common.c b/board/BuR/common/common.c
index 5ff8a7e0ae..ccaa9c6845 100644
--- a/board/BuR/common/common.c
+++ b/board/BuR/common/common.c
@@ -441,30 +441,12 @@ void lcd_enable(void)
 #error "LCD-support with a suitable FB-Driver is mandatory !"
 #endif /* CONFIG_LCD */
 
-void blink(u32 blinks, u32 intervall, u32 pin)
-{
-	gpio_direction_output(pin, 0);
-	int val = 0;
-
-	do {
-		val ^= 0x01;
-		gpio_set_value(pin, val);
-		mdelay(intervall);
-	} while (blinks--);
-
-	gpio_set_value(pin, 0);
-}
-
 #ifdef CONFIG_SPL_BUILD
 void pmicsetup(u32 mpupll)
 {
 	int mpu_vdd;
 	int usb_cur_lim;
 
-	/* setup I2C */
-	enable_i2c0_pin_mux();
-	i2c_init(CONFIG_SYS_OMAP24_I2C_SPEED, CONFIG_SYS_OMAP24_I2C_SLAVE);
-
 	if (i2c_probe(TPS65217_CHIP_PM)) {
 		puts("PMIC (0x24) not found! skip further initalization.\n");
 		return;
diff --git a/board/BuR/kwb/board.c b/board/BuR/kwb/board.c
index 892311e6ee..6eed7e0d7f 100644
--- a/board/BuR/kwb/board.c
+++ b/board/BuR/kwb/board.c
@@ -124,7 +124,8 @@ void am33xx_spl_board_init(void)
 	gpio_direction_output(LCD_PWR, 0);
 
 	/* setup I2C */
-	enable_i2c0_pin_mux();
+	enable_i2c_pin_mux();
+	i2c_set_bus_num(0);
 	i2c_init(CONFIG_SYS_OMAP24_I2C_SPEED, CONFIG_SYS_OMAP24_I2C_SLAVE);
 
 	/* power-ON  3V3 via Resetcontroller */
diff --git a/board/BuR/kwb/mux.c b/board/BuR/kwb/mux.c
index 9f89b5e53d..2b1d8d3b1d 100644
--- a/board/BuR/kwb/mux.c
+++ b/board/BuR/kwb/mux.c
@@ -180,7 +180,7 @@ void enable_uart0_pin_mux(void)
 	configure_module_pin_mux(uart0_pin_mux);
 }
 
-void enable_i2c0_pin_mux(void)
+void enable_i2c_pin_mux(void)
 {
 	configure_module_pin_mux(i2c0_pin_mux);
 }
diff --git a/board/BuR/tseries/board.c b/board/BuR/tseries/board.c
index 9402aa4205..89e989f246 100644
--- a/board/BuR/tseries/board.c
+++ b/board/BuR/tseries/board.c
@@ -123,6 +123,10 @@ void am33xx_spl_board_init(void)
 	/* setup LCD-Pixel Clock */
 	writel(0x2, &cmdpll->clklcdcpixelclk);	/* clock comes from perPLL M2 */
 
+	/* setup I2C */
+	enable_i2c_pin_mux();
+	i2c_set_bus_num(0);
+	i2c_init(CONFIG_SYS_OMAP24_I2C_SPEED, CONFIG_SYS_OMAP24_I2C_SLAVE);
 	pmicsetup(0);
 }
 
diff --git a/board/BuR/tseries/mux.c b/board/BuR/tseries/mux.c
index 2c87a63b85..ac7e885f61 100644
--- a/board/BuR/tseries/mux.c
+++ b/board/BuR/tseries/mux.c
@@ -226,7 +226,7 @@ void enable_uart0_pin_mux(void)
 	configure_module_pin_mux(uart0_pin_mux);
 }
 
-void enable_i2c0_pin_mux(void)
+void enable_i2c_pin_mux(void)
 {
 	configure_module_pin_mux(i2c0_pin_mux);
 }