diff options
Diffstat (limited to 'board/isee/igep0033/board.c')
| -rw-r--r-- | board/isee/igep0033/board.c | 174 |
1 files changed, 0 insertions, 174 deletions
diff --git a/board/isee/igep0033/board.c b/board/isee/igep0033/board.c deleted file mode 100644 index 5fea7ffaef..0000000000 --- a/board/isee/igep0033/board.c +++ /dev/null @@ -1,174 +0,0 @@ -/* - * Board functions for IGEP COM AQUILA based boards - * - * Copyright (C) 2013, ISEE 2007 SL - http://www.isee.biz/ - * - * SPDX-License-Identifier: GPL-2.0+ - */ - -#include <common.h> -#include <errno.h> -#include <spl.h> -#include <asm/arch/cpu.h> -#include <asm/arch/hardware.h> -#include <asm/arch/omap.h> -#include <asm/arch/ddr_defs.h> -#include <asm/arch/clock.h> -#include <asm/arch/gpio.h> -#include <asm/arch/mmc_host_def.h> -#include <asm/arch/sys_proto.h> -#include <asm/io.h> -#include <asm/emif.h> -#include <asm/gpio.h> -#include <i2c.h> -#include <miiphy.h> -#include <cpsw.h> -#include "board.h" - -DECLARE_GLOBAL_DATA_PTR; - -static struct ctrl_dev *cdev = (struct ctrl_dev *)CTRL_DEVICE_BASE; - -#ifdef CONFIG_SPL_BUILD -static const struct ddr_data ddr3_data = { - .datardsratio0 = K4B2G1646EBIH9_RD_DQS, - .datawdsratio0 = K4B2G1646EBIH9_WR_DQS, - .datafwsratio0 = K4B2G1646EBIH9_PHY_FIFO_WE, - .datawrsratio0 = K4B2G1646EBIH9_PHY_WR_DATA, -}; - -static const struct cmd_control ddr3_cmd_ctrl_data = { - .cmd0csratio = K4B2G1646EBIH9_RATIO, - .cmd0iclkout = K4B2G1646EBIH9_INVERT_CLKOUT, - - .cmd1csratio = K4B2G1646EBIH9_RATIO, - .cmd1iclkout = K4B2G1646EBIH9_INVERT_CLKOUT, - - .cmd2csratio = K4B2G1646EBIH9_RATIO, - .cmd2iclkout = K4B2G1646EBIH9_INVERT_CLKOUT, -}; - -static struct emif_regs ddr3_emif_reg_data = { - .sdram_config = K4B2G1646EBIH9_EMIF_SDCFG, - .ref_ctrl = K4B2G1646EBIH9_EMIF_SDREF, - .sdram_tim1 = K4B2G1646EBIH9_EMIF_TIM1, - .sdram_tim2 = K4B2G1646EBIH9_EMIF_TIM2, - .sdram_tim3 = K4B2G1646EBIH9_EMIF_TIM3, - .zq_config = K4B2G1646EBIH9_ZQ_CFG, - .emif_ddr_phy_ctlr_1 = K4B2G1646EBIH9_EMIF_READ_LATENCY, -}; - -#define OSC (V_OSCK/1000000) -const struct dpll_params dpll_ddr = { - 400, OSC-1, 1, -1, -1, -1, -1}; - -const struct dpll_params *get_dpll_ddr_params(void) -{ - return &dpll_ddr; -} - -void set_uart_mux_conf(void) -{ - enable_uart0_pin_mux(); -} - -void set_mux_conf_regs(void) -{ - enable_board_pin_mux(); -} - -const struct ctrl_ioregs ioregs = { - .cm0ioctl = K4B2G1646EBIH9_IOCTRL_VALUE, - .cm1ioctl = K4B2G1646EBIH9_IOCTRL_VALUE, - .cm2ioctl = K4B2G1646EBIH9_IOCTRL_VALUE, - .dt0ioctl = K4B2G1646EBIH9_IOCTRL_VALUE, - .dt1ioctl = K4B2G1646EBIH9_IOCTRL_VALUE, -}; - -void sdram_init(void) -{ - config_ddr(400, &ioregs, &ddr3_data, - &ddr3_cmd_ctrl_data, &ddr3_emif_reg_data, 0); -} -#endif - -/* - * Basic board specific setup. Pinmux has been handled already. - */ -int board_init(void) -{ - gd->bd->bi_boot_params = CONFIG_SYS_SDRAM_BASE + 0x100; - - gpmc_init(); - - return 0; -} - -#if defined(CONFIG_DRIVER_TI_CPSW) -static void cpsw_control(int enabled) -{ - /* VTP can be added here */ - - return; -} - -static struct cpsw_slave_data cpsw_slaves[] = { - { - .slave_reg_ofs = 0x208, - .sliver_reg_ofs = 0xd80, - .phy_addr = 0, - .phy_if = PHY_INTERFACE_MODE_RMII, - }, -}; - -static struct cpsw_platform_data cpsw_data = { - .mdio_base = CPSW_MDIO_BASE, - .cpsw_base = CPSW_BASE, - .mdio_div = 0xff, - .channels = 8, - .cpdma_reg_ofs = 0x800, - .slaves = 1, - .slave_data = cpsw_slaves, - .ale_reg_ofs = 0xd00, - .ale_entries = 1024, - .host_port_reg_ofs = 0x108, - .hw_stats_reg_ofs = 0x900, - .bd_ram_ofs = 0x2000, - .mac_control = (1 << 5), - .control = cpsw_control, - .host_port_num = 0, - .version = CPSW_CTRL_VERSION_2, -}; - -int board_eth_init(bd_t *bis) -{ - int rv, ret = 0; - uint8_t mac_addr[6]; - uint32_t mac_hi, mac_lo; - - if (!eth_getenv_enetaddr("ethaddr", mac_addr)) { - /* try reading mac address from efuse */ - mac_lo = readl(&cdev->macid0l); - mac_hi = readl(&cdev->macid0h); - mac_addr[0] = mac_hi & 0xFF; - mac_addr[1] = (mac_hi & 0xFF00) >> 8; - mac_addr[2] = (mac_hi & 0xFF0000) >> 16; - mac_addr[3] = (mac_hi & 0xFF000000) >> 24; - mac_addr[4] = mac_lo & 0xFF; - mac_addr[5] = (mac_lo & 0xFF00) >> 8; - if (is_valid_ethaddr(mac_addr)) - eth_setenv_enetaddr("ethaddr", mac_addr); - } - - writel((GMII1_SEL_RMII | RMII1_IO_CLK_EN), - &cdev->miisel); - - rv = cpsw_register(&cpsw_data); - if (rv < 0) - printf("Error %d registering CPSW switch\n", rv); - else - ret += rv; - - return ret; -} -#endif |