diff options
Diffstat (limited to 'board/solidrun/clearfog/Kconfig')
| -rw-r--r-- | board/solidrun/clearfog/Kconfig | 62 |
1 files changed, 62 insertions, 0 deletions
diff --git a/board/solidrun/clearfog/Kconfig b/board/solidrun/clearfog/Kconfig new file mode 100644 index 0000000000..e8c3f53d84 --- /dev/null +++ b/board/solidrun/clearfog/Kconfig @@ -0,0 +1,62 @@ +menu "ClearFog configuration" + depends on TARGET_CLEARFOG + +config TARGET_CLEARFOG_BASE + bool "Use ClearFog Base static configuration" + help + Use the ClearFog Base as the static configuration instead of the + default which uses the ClearFog Pro. + + Runtime board detection is always attempted and used if available. The + static configuration is used as a fallback in cases where runtime + detection is disabled, is not available in hardware, or otherwise fails. + + Only newer revisions of the ClearFog product line support runtime + detection via additional EEPROM hardware. This option enables selecting + the Base variant for older hardware revisions. + +config CLEARFOG_CON3_SATA + bool "Use CON3 slot in SATA mode" + help + Use the CON3 port with SATA protocol instead of the default PCIe. + The ClearFog port allows usage of either mSATA or miniPCIe + modules, but the desired protocol must be configured at build + time since it affects the SerDes topology layout. + +config CLEARFOG_CON2_SATA + bool "Use CON2 slot in SATA mode" + depends on !TARGET_CLEARFOG_BASE + help + Use the CON2 port with SATA protocol instead of the default PCIe. + The ClearFog port allows usage of either mSATA or miniPCIe + modules, but the desired protocol must be configured at build + time since it affects the SerDes topology layout. + +config CLEARFOG_SFP_25GB + bool "Enable 2.5 Gbps mode for SFP" + help + Set the SFP module connection to support 2.5 Gbps transfer speed for the + SGMII connection (requires a supporting SFP). By default, transfer speed + of 1.25 Gbps is used, suitable for a more common 1 Gbps SFP module. + +config ENV_SIZE + hex "Environment Size" + default 0x10000 + +config ENV_OFFSET + hex "Environment offset" + default 0xF0000 + +config ENV_SECT_SIZE + hex "Environment Sector-Size" + # Use SPI flash erase block size of 4 KiB + default 0x1000 if MVEBU_SPL_BOOT_DEVICE_SPI + # Use optimistic 64 KiB erase block, will vary between actual media + default 0x10000 if MVEBU_SPL_BOOT_DEVICE_MMC + +config SYS_SPI_U_BOOT_OFFS + hex "address of u-boot payload in SPI flash" + default 0x20000 + depends on MVEBU_SPL_BOOT_DEVICE_SPI + +endmenu |