diff options
Diffstat (limited to 'doc')
| -rw-r--r-- | doc/README.marvell | 40 |
1 files changed, 37 insertions, 3 deletions
diff --git a/doc/README.marvell b/doc/README.marvell index 336461745c..5416bc3035 100644 --- a/doc/README.marvell +++ b/doc/README.marvell @@ -13,7 +13,8 @@ Build Procedure 2. Set the cross compiler: - # export CROSS_COMPILE=/path/to/toolchain/aarch64-marvell-linux-gnu- + # sudo apt-get install gcc-aarch64-linux-gnu + # export CROSS_COMPILE=aarch64-linux-gnu- 3. Clean-up old residuals: @@ -30,7 +31,7 @@ Build Procedure 5. Configure the device-tree and build the U-Boot image: - Compile u-boot and set the required device-tree using: + For the Armada-70x0/80x0 DB board compile u-boot and set the required device-tree using: # make DEVICE_TREE=<name> @@ -42,12 +43,45 @@ Build Procedure In order to prevent this, the required device-tree MUST be set during compilation. All device-tree files are located in ./arch/arm/dts/ folder. + For other DB boards (MacchiatoBin, EspressoBin and 3700 DB board) compile u-boot with + just default device-tree from defconfig using: + + # make + NOTE: The u-boot.bin should not be used as a stand-alone image. The ARM Trusted Firmware (ATF) build process uses this image to generate the - flash image. + flash image. See TF-A Build Instructions for Marvell Platforms for more details at: + https://trustedfirmware-a.readthedocs.io/en/latest/plat/marvell/armada/build.html Configuration update --------------------- To update the U-Boot configuration, please refer to doc/README.kconfig + +Permanent ethernet MAC address +------------------------------- + Prior flashing new U-Boot version (as part of ATF image) it is suggested to backup + permanent ethernet MAC address as it is stored only in U-Boot env storage (SPI or eMMC). + Some boards like EspressoBin have MAC address printed on sticker. To print current MAC + address run: + + # echo $ethaddr + + MAC addresses 00:51:82:11:22:00, 00:51:82:11:22:01, 00:51:82:11:22:02, 00:51:82:11:22:03 + and F0:AD:4E:03:64:7F are default hardcoded values found in Marvell's and Armbian U-Boot + forks and therefore *not* unique. Usage of static hardcoded MAC addresses should be avoided. + When original address is lost (e.g. erased by Armbian boot scripts for EspressoBin) it is + suggested to generate new random one. + + After flashing new U-Boot version it is suggested to reset U-Boot env variables to default + and then set correct permanent ethernet MAC address. + + # env default -a + # setenv ethaddr XX:XX:XX:XX:XX:XX + # saveenv + + Where XX:XX:XX:XX:XX:XX is permanent ethernet MAC address. + + Recent Linux kernel versions use correct permanent ethernet MAC address from U-Boot env as + U-Boot will inject it into kernel's device-tree. |