diff options
Diffstat (limited to 'drivers/power/Kconfig')
| -rw-r--r-- | drivers/power/Kconfig | 43 |
1 files changed, 43 insertions, 0 deletions
diff --git a/drivers/power/Kconfig b/drivers/power/Kconfig index 1a3852442a..9495dca33b 100644 --- a/drivers/power/Kconfig +++ b/drivers/power/Kconfig @@ -197,6 +197,49 @@ config AXP_ALDO3_VOLT On A83T / H8 boards aldo3 is AVCC, VCC-PL, and VCC-LED, and should be 3.0V. +choice + prompt "axp pmic (a)ldo3 voltage rate control" + depends on AXP209_POWER + default AXP_ALDO3_VOLT_SLOPE_NONE + ---help--- + The AXP can slowly ramp up voltage to reduce the inrush current when + changing voltages. + Note, this does not apply when enabling/disabling LDO3. See + "axp pmic (a)ldo3 inrush quirk" below to enable a slew rate to limit + inrush current on broken board designs. + +config AXP_ALDO3_VOLT_SLOPE_NONE + bool "No voltage slope" + ---help--- + Tries to reach the next voltage setting near instantaneously. Measurements + indicate that this is about 0.0167 V/uS. + +config AXP_ALDO3_VOLT_SLOPE_16 + bool "1.6 mV per uS" + ---help--- + Increases the voltage by 1.6 mV per uS until the final voltage has + been reached. Note that the scaling is in 25 mV steps and thus + the slew rate in reality is about 25 mV/31.250 uS. + +config AXP_ALDO3_VOLT_SLOPE_08 + bool "0.8 mV per uS" + ---help--- + Increases the voltage by 0.8 mV per uS until the final voltage has + been reached. Note that the scaling is in 25 mV steps however and thus + the slew rate in reality is about 25 mV/15.625 uS. + This is the slowest supported rate. + +endchoice + +config AXP_ALDO3_INRUSH_QUIRK + bool "axp pmic (a)ldo3 inrush quirk" + depends on AXP209_POWER + default n + ---help--- + The reference design denotes a value of 4.7 uF for the output capacitor + of LDO3. Some boards have too high capacitance causing an inrush current + and resulting an AXP209 shutdown. + config AXP_ALDO4_VOLT int "axp pmic (a)ldo4 voltage" depends on AXP209_POWER |