diff options
Diffstat (limited to 'drivers')
| -rw-r--r-- | drivers/core/Kconfig | 23 | ||||
| -rw-r--r-- | drivers/serial/ns16550.c | 10 |
2 files changed, 31 insertions, 2 deletions
diff --git a/drivers/core/Kconfig b/drivers/core/Kconfig index c5c9d2a42e..87495614c2 100644 --- a/drivers/core/Kconfig +++ b/drivers/core/Kconfig @@ -178,4 +178,27 @@ config SPL_OF_TRANSLATE used for the address translation. This function is faster and smaller in size than fdt_translate_address(). +config OF_ISA_BUS + bool + depends on OF_TRANSLATE + help + Is this option is enabled then support for the ISA bus will + be included for addresses read from DT. This is something that + should be known to be required or not based upon the board + being targetted, and whether or not it makes use of an ISA bus. + + The bus is matched based upon its node name equalling "isa". The + busses #address-cells should equal 2, with the first cell being + used to hold flags & flag 0x1 indicating that the address range + should be accessed using I/O port in/out accessors. The second + cell holds the offset into ISA bus address space. The #size-cells + property should equal 1, and of course holds the size of the + address range used by a device. + + If this option is not enabled then support for the ISA bus is + not included and any such busses used in DT will be treated as + typical simple-bus compatible busses. This will lead to + mistranslation of device addresses, so ensure that this is + enabled if your board does include an ISA bus. + endmenu diff --git a/drivers/serial/ns16550.c b/drivers/serial/ns16550.c index 28da9ddfd8..d7a3cf665e 100644 --- a/drivers/serial/ns16550.c +++ b/drivers/serial/ns16550.c @@ -100,7 +100,8 @@ static void ns16550_writeb(NS16550_t port, int offset, int value) unsigned char *addr; offset *= 1 << plat->reg_shift; - addr = map_physmem(plat->base, 0, MAP_NOCACHE) + offset; + addr = (unsigned char *)plat->base + offset; + /* * As far as we know it doesn't make sense to support selection of * these options at run-time, so use the existing CONFIG options. @@ -114,7 +115,7 @@ static int ns16550_readb(NS16550_t port, int offset) unsigned char *addr; offset *= 1 << plat->reg_shift; - addr = map_physmem(plat->base, 0, MAP_NOCACHE) + offset; + addr = (unsigned char *)plat->base + offset; return serial_in_shift(addr + plat->reg_offset, plat->reg_shift); } @@ -400,7 +401,12 @@ int ns16550_serial_ofdata_to_platdata(struct udevice *dev) if (addr == FDT_ADDR_T_NONE) return -EINVAL; +#ifdef CONFIG_SYS_NS16550_PORT_MAPPED plat->base = addr; +#else + plat->base = (unsigned long)map_physmem(addr, 0, MAP_NOCACHE); +#endif + plat->reg_offset = fdtdec_get_int(gd->fdt_blob, dev->of_offset, "reg-offset", 0); plat->reg_shift = fdtdec_get_int(gd->fdt_blob, dev->of_offset, |