diff options
Diffstat (limited to 'include/configs/MPC8349EMDS.h')
| -rw-r--r-- | include/configs/MPC8349EMDS.h | 56 |
1 files changed, 37 insertions, 19 deletions
diff --git a/include/configs/MPC8349EMDS.h b/include/configs/MPC8349EMDS.h index 5bed2d0a29..0460be9e56 100644 --- a/include/configs/MPC8349EMDS.h +++ b/include/configs/MPC8349EMDS.h @@ -60,17 +60,6 @@ #endif #endif -#define CFG_SCCR_INIT (SCCR_DEFAULT & (~SCCR_CLK_MASK)) -#define CFG_SCCR_TSEC1CM SCCR_TSEC1CM_1 /* TSEC1 clock setting */ -#define CFG_SCCR_TSEC2CM SCCR_TSEC2CM_1 /* TSEC2 clock setting */ -#define CFG_SCCR_ENCCM SCCR_ENCCM_3 /* ENC clock setting */ -#define CFG_SCCR_USBCM SCCR_USBCM_3 /* USB clock setting */ -#define CFG_SCCR_VAL ( CFG_SCCR_INIT \ - | CFG_SCCR_TSEC1CM \ - | CFG_SCCR_TSEC2CM \ - | CFG_SCCR_ENCCM \ - | CFG_SCCR_USBCM ) - #define CONFIG_BOARD_EARLY_INIT_F /* call board_pre_init */ #define CFG_IMMR 0xE0000000 @@ -82,7 +71,7 @@ /* * DDR Setup */ -#undef CONFIG_DDR_ECC /* only for ECC DDR module */ +#define CONFIG_DDR_ECC /* support DDR ECC function */ #define CONFIG_DDR_ECC_CMD /* use DDR ECC user commands */ #define CONFIG_SPD_EEPROM /* use SPD EEPROM for DDR setup*/ @@ -101,8 +90,15 @@ #define CFG_DDR_BASE 0x00000000 /* DDR is system memory*/ #define CFG_SDRAM_BASE CFG_DDR_BASE #define CFG_DDR_SDRAM_BASE CFG_DDR_BASE +#define CFG_DDR_SDRAM_CLK_CNTL (DDR_SDRAM_CLK_CNTL_SS_EN | \ + DDR_SDRAM_CLK_CNTL_CLK_ADJUST_05) #undef CONFIG_DDR_2T_TIMING +/* + * DDRCDR - DDR Control Driver Register + */ +#define CFG_DDRCDR_VALUE 0x80080001 + #if defined(CONFIG_SPD_EEPROM) /* * Determine DDR configuration from I2C interface. @@ -113,6 +109,21 @@ * Manually set up DDR parameters */ #define CFG_DDR_SIZE 256 /* MB */ +#if defined(CONFIG_DDR_II) +#define CFG_DDRCDR 0x80080001 +#define CFG_DDR_CS2_BNDS 0x0000000f +#define CFG_DDR_CS2_CONFIG 0x80330102 +#define CFG_DDR_TIMING_0 0x00220802 +#define CFG_DDR_TIMING_1 0x38357322 +#define CFG_DDR_TIMING_2 0x2f9048c8 +#define CFG_DDR_TIMING_3 0x00000000 +#define CFG_DDR_CLK_CNTL 0x02000000 +#define CFG_DDR_MODE 0x47d00432 +#define CFG_DDR_MODE2 0x8000c000 +#define CFG_DDR_INTERVAL 0x03cf0080 +#define CFG_DDR_SDRAM_CFG 0x43000000 +#define CFG_DDR_SDRAM_CFG2 0x00401000 +#else #define CFG_DDR_CONFIG (CSCONFIG_EN | CSCONFIG_ROW_BIT_13 | CSCONFIG_COL_BIT_10) #define CFG_DDR_TIMING_1 0x36332321 #define CFG_DDR_TIMING_2 0x00000800 /* P9-45,may need tuning */ @@ -127,6 +138,7 @@ #define CFG_DDR_MODE 0x00000022 /* DLL,normal,seq,4/2.5, 4 burst len */ #endif #endif +#endif /* * SDRAM on the Local Bus @@ -140,19 +152,20 @@ #define CFG_FLASH_CFI /* use the Common Flash Interface */ #define CFG_FLASH_CFI_DRIVER /* use the CFI driver */ #define CFG_FLASH_BASE 0xFE000000 /* start of FLASH */ -#define CFG_FLASH_SIZE 8 /* flash size in MB */ +#define CFG_FLASH_SIZE 32 /* max flash size in MB */ /* #define CFG_FLASH_USE_BUFFER_WRITE */ #define CFG_BR0_PRELIM (CFG_FLASH_BASE | /* flash Base address */ \ - (2 << BR_PS_SHIFT) | /* 32 bit port size */ \ + (2 << BR_PS_SHIFT) | /* 16 bit port size */ \ BR_V) /* valid */ - -#define CFG_OR0_PRELIM 0xFF806FF7 /* 8 MB flash size */ +#define CFG_OR0_PRELIM ((~(CFG_FLASH_SIZE - 1) << 20) | OR_UPM_XAM | \ + OR_GPCM_CSNT | OR_GPCM_ACS_0b11 | OR_GPCM_XACS | OR_GPCM_SCY_15 | \ + OR_GPCM_TRLX | OR_GPCM_EHTR | OR_GPCM_EAD) #define CFG_LBLAWBAR0_PRELIM CFG_FLASH_BASE /* window base at flash base */ -#define CFG_LBLAWAR0_PRELIM 0x80000016 /* 8 MB window size */ +#define CFG_LBLAWAR0_PRELIM 0x80000018 /* 32 MB window size */ #define CFG_MAX_FLASH_BANKS 1 /* number of banks */ -#define CFG_MAX_FLASH_SECT 64 /* sectors per device */ +#define CFG_MAX_FLASH_SECT 256 /* max sectors per device */ #undef CFG_FLASH_CHECKSUM #define CFG_FLASH_ERASE_TOUT 60000 /* Flash Erase Timeout (ms) */ @@ -197,7 +210,11 @@ #define CFG_LCRR (LCRR_DBYP | LCRR_CLKDIV_4) #define CFG_LBC_LBCR 0x00000000 -#define CFG_LB_SDRAM /* if board has SRDAM on local bus */ +/* + * The MPC834xEA MDS for 834xE rev3.1 may not be assembled SDRAM memory. + * if board has SRDAM on local bus, you can define CFG_LB_SDRAM + */ +#undef CFG_LB_SDRAM #ifdef CFG_LB_SDRAM /* Local bus BR2, OR2 definition for SDRAM if soldered on the MDS board */ @@ -314,6 +331,7 @@ #define CFG_NS16550_COM1 (CFG_IMMR+0x4500) #define CFG_NS16550_COM2 (CFG_IMMR+0x4600) +#define CONFIG_CMDLINE_EDITING 1 /* add command line history */ /* Use the HUSH parser */ #define CFG_HUSH_PARSER #ifdef CFG_HUSH_PARSER |