diff options
Diffstat (limited to 'include/configs/dvlhost.h')
-rw-r--r-- | include/configs/dvlhost.h | 222 |
1 files changed, 0 insertions, 222 deletions
diff --git a/include/configs/dvlhost.h b/include/configs/dvlhost.h deleted file mode 100644 index 1af7f16989..0000000000 --- a/include/configs/dvlhost.h +++ /dev/null @@ -1,222 +0,0 @@ -/* - * (C) Copyright 2009 - * Michael Schwingen, michael@schwingen.org - * - * Configuration settings for the - * dLAN200 AV Wireless G ("dvlhost") board. - * - * SPDX-License-Identifier: GPL-2.0+ - */ - -#ifndef __CONFIG_H -#define __CONFIG_H - -#define CONFIG_IXP425 1 -#define CONFIG_DVLHOST 1 - -#define CONFIG_MACH_TYPE 1343 - -#define CONFIG_DISPLAY_CPUINFO 1 -#define CONFIG_DISPLAY_BOARDINFO 1 - -#define CONFIG_IXP_SERIAL -#define CONFIG_SYS_IXP425_CONSOLE IXP425_UART2 -#define CONFIG_BAUDRATE 115200 -#define CONFIG_BOOTDELAY 3 -#define CONFIG_ZERO_BOOTDELAY_CHECK /* check for keypress on bootdelay==0 */ -#define CONFIG_BOARD_EARLY_INIT_F 1 -#define CONFIG_SYS_LDSCRIPT "board/dvlhost/u-boot.lds" - -/*************************************************************** - * U-boot generic defines start here. - ***************************************************************/ -/* Size of malloc() pool */ -#define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + 128*1024) - -/* allow to overwrite serial and ethaddr */ -#define CONFIG_ENV_OVERWRITE - -/* Command line configuration. */ -#include <config_cmd_default.h> - -#define CONFIG_CMD_ELF -#define CONFIG_PCI -#ifdef CONFIG_PCI -#define CONFIG_CMD_PCI -#define CONFIG_PCI_PNP -#define CONFIG_IXP_PCI -#define CONFIG_PCI_SCAN_SHOW -#define CONFIG_CMD_PCI_ENUM -#endif - -#define CONFIG_BOOTCOMMAND "run boot_flash" -/* enable passing of ATAGs */ -#define CONFIG_CMDLINE_TAG 1 -#define CONFIG_SETUP_MEMORY_TAGS 1 -#define CONFIG_INITRD_TAG 1 - -#if defined(CONFIG_CMD_KGDB) -# define CONFIG_KGDB_BAUDRATE 230400 -#endif - -/* Miscellaneous configurable options */ -#define CONFIG_SYS_LONGHELP -/* Console I/O Buffer Size */ -#define CONFIG_SYS_CBSIZE 256 -/* Print Buffer Size */ -#define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE+sizeof(CONFIG_SYS_PROMPT)+16) -/* max number of command args */ -#define CONFIG_SYS_MAXARGS 16 -/* Boot Argument Buffer Size */ -#define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE - -#define CONFIG_SYS_MEMTEST_START 0x00000000 -#define CONFIG_SYS_MEMTEST_END 0x01D80000 - -/* timer clock - 2* OSC_IN system clock */ -#define CONFIG_IXP425_TIMER_CLK 66666666 - -/* default load address */ -#define CONFIG_SYS_LOAD_ADDR 0x00010000 - -/* valid baudrates */ -#define CONFIG_SYS_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, \ - 115200, 230400 } -#define CONFIG_SERIAL_RTS_ACTIVE 1 - -/* Expansion bus settings */ -#define CONFIG_SYS_EXP_CS0 0xbd113442 - -/* SDRAM settings */ -#define CONFIG_NR_DRAM_BANKS 1 -#define PHYS_SDRAM_1 0x00000000 -#define CONFIG_SYS_SDRAM_BASE 0x00000000 - -/* 32MB SDRAM: 2* 8Mx16, CL3 */ -#define CONFIG_SYS_SDR_CONFIG 0x18 -#define PHYS_SDRAM_1_SIZE 0x02000000 -#define CONFIG_SYS_SDRAM_REFRESH_CNT 0x800 -#define CONFIG_SYS_SDR_MODE_CONFIG 0x1 -#define CONFIG_SYS_DRAM_SIZE PHYS_SDRAM_1_SIZE - -/* FLASH organization: one Spansion S29AL032D-04 Flash */ -#define CONFIG_SYS_TEXT_BASE 0x50000000 -#define CONFIG_SYS_MAX_FLASH_BANKS 1 -/* max number of sectors on one chip */ -#define CONFIG_SYS_MAX_FLASH_SECT 140 -#define PHYS_FLASH_1 0x50000000 -#define CONFIG_SYS_FLASH_BANKS_LIST { PHYS_FLASH_1 } - -#define CONFIG_SYS_FLASH_BASE PHYS_FLASH_1 -#define CONFIG_SYS_MONITOR_BASE PHYS_FLASH_1 -#define CONFIG_SYS_MONITOR_LEN (256 << 10) -#define CONFIG_BOARD_SIZE_LIMIT 262144 - -/* Use common CFI driver */ -#define CONFIG_SYS_FLASH_CFI -#define CONFIG_FLASH_CFI_DRIVER -/* no byte writes on IXP4xx */ -#define CONFIG_SYS_FLASH_CFI_WIDTH FLASH_CFI_16BIT - -/* print 'E' for empty sector on flinfo */ -#define CONFIG_SYS_FLASH_EMPTY_INFO - -/* Ethernet */ - -/* include IXP4xx NPE support */ -#define CONFIG_IXP4XX_NPE 1 - -/* NPE0 PHY: MII dLAN200 AVmodule, 100BaseT-FDX fixed */ -#define CONFIG_PHY_ADDR 0x18 -/* NPE1 PHY: MII IP175 switch, port 5 is host port */ -#define CONFIG_PHY1_ADDR 0x05 -/* MII PHY management */ -#define CONFIG_MII 1 -/* fixed-speed powerline modem without standard PHY registers on MII */ -#define CONFIG_MII_NPE0_FIXEDLINK 1 -#define CONFIG_MII_NPE0_SPEED 100 -#define CONFIG_MII_NPE0_FULLDUPLEX 1 -/* fixed-speed switch without standard PHY registers on MII */ -#define CONFIG_MII_NPE1_FIXEDLINK 1 -#define CONFIG_MII_NPE1_SPEED 100 -#define CONFIG_MII_NPE1_FULLDUPLEX 1 - -/* Number of ethernet rx buffers & descriptors */ -#define CONFIG_SYS_RX_ETH_BUFFER 16 -#define CONFIG_RESET_PHY_R 1 -/* ethernet switch connected to MII port */ -#define CONFIG_MII_ETHSWITCH 1 -#define CONFIG_HAS_ETH1 1 - -#define CONFIG_CMD_DHCP -#define CONFIG_CMD_NET -#define CONFIG_CMD_MII -#define CONFIG_CMD_PING -#undef CONFIG_CMD_NFS - -/* BOOTP options */ -#define CONFIG_BOOTP_BOOTFILESIZE -#define CONFIG_BOOTP_BOOTPATH -#define CONFIG_BOOTP_GATEWAY -#define CONFIG_BOOTP_HOSTNAME - -/* Cache Configuration */ -#define CONFIG_SYS_CACHELINE_SIZE 32 - -/* - * environment organization: - * one flash sector, embedded in uboot area (bottom bootblock flash) - */ -#define CONFIG_ENV_IS_IN_FLASH 1 -#define CONFIG_ENV_SIZE 0x2000 -#define CONFIG_ENV_ADDR (PHYS_FLASH_1 + 0x4000) -#define CONFIG_SYS_USE_PPCENV 1 - -#define CONFIG_EXTRA_ENV_SETTINGS \ - "npe_ucode=50040000\0" \ - "ethprime=NPE1\0" \ - "ethrotate=no\0" \ - "mtd=IXP4XX-Flash.0:256k(uboot),64k(ucode),1152k(linux),-(root),\0" \ - "kerneladdr=50050000\0" \ - "kernelfile=dvlhost/uImage\0" \ - "rootfile=dvlhost/rootfs\0" \ - "rootaddr=50170000\0" \ - "loadaddr=10000\0" \ - "updateboot_ser=mw.b 10000 ff 40000;" \ - " loady ${loadaddr};" \ - " run eraseboot writeboot\0" \ - "updateboot_net=mw.b 10000 ff 40000;" \ - " tftp ${loadaddr} dvlhost/u-boot.bin;" \ - " run eraseboot writeboot\0" \ - "eraseboot=protect off 50000000 50003fff;" \ - " protect off 50006000 5003ffff;" \ - " erase 50000000 50003fff;" \ - " erase 50006000 5003ffff\0" \ - "writeboot=cp.b 10000 50000000 4000;" \ - " cp.b 16000 50006000 3a000\0" \ - "updateucode=loady;" \ - " era ${npe_ucode} +${filesize};" \ - " cp.b ${loadaddr} ${npe_ucode} ${filesize}\0" \ - "updateroot=tftp ${loadaddr} ${rootfile};" \ - " era ${rootaddr} +${filesize};" \ - " cp.b ${loadaddr} ${rootaddr} ${filesize}\0" \ - "updatekern=tftp ${loadaddr} ${kernelfile};" \ - " era ${kerneladdr} +${filesize};" \ - " cp.b ${loadaddr} ${kerneladdr} ${filesize}\0" \ - "flashargs=setenv bootargs mtdparts=${mtd} root=/dev/mtdblock3" \ - " rootfstype=squashfs,jffs2 init=/etc/preinit\0" \ - "netargs=setenv bootargs mtdparts=${mtd} root=/dev/mtdblock3" \ - " rootfstype=squashfs,jffs2 init=/etc/preinit\0" \ - "addtty=setenv bootargs ${bootargs} console=ttyS0,${baudrate}\0" \ - "addeth=setenv bootargs ${bootargs} ethaddr=${ethaddr}\0" \ - "boot_flash=run flashargs addtty addeth;" \ - " bootm ${kerneladdr}\0" \ - "boot_net=run netargs addtty addeth;" \ - " tftpboot ${loadaddr} ${kernelfile};" \ - " bootm\0" - -/* additions for new relocation code, must be added to all boards */ -#define CONFIG_SYS_INIT_SP_ADDR \ - (CONFIG_SYS_SDRAM_BASE + 0x1000 - GENERATED_GBL_DATA_SIZE) - -#endif /* __CONFIG_H */ |