diff options
Diffstat (limited to 'include/configs/microblaze-generic.h')
| -rw-r--r-- | include/configs/microblaze-generic.h | 74 |
1 files changed, 3 insertions, 71 deletions
diff --git a/include/configs/microblaze-generic.h b/include/configs/microblaze-generic.h index f93861d770..97a0d86b91 100644 --- a/include/configs/microblaze-generic.h +++ b/include/configs/microblaze-generic.h @@ -32,54 +32,20 @@ #endif /* uart */ -#ifdef XILINX_UARTLITE_BASEADDR -# define CONFIG_XILINX_UARTLITE -# define CONFIG_SERIAL_BASE XILINX_UARTLITE_BASEADDR -# define CONFIG_BAUDRATE XILINX_UARTLITE_BAUDRATE -# define CONFIG_SYS_BAUDRATE_TABLE { CONFIG_BAUDRATE } -# define CONSOLE_ARG "console=console=ttyUL0,115200\0" -#elif XILINX_UART16550_BASEADDR -# define CONFIG_SYS_NS16550_SERIAL -# if defined(__MICROBLAZEEL__) -# define CONFIG_SYS_NS16550_REG_SIZE -4 -# else -# define CONFIG_SYS_NS16550_REG_SIZE 4 -# endif -# define CONFIG_CONS_INDEX 1 -# define CONFIG_SYS_NS16550_COM1 \ - ((XILINX_UART16550_BASEADDR & ~0xF) + 0x1000) -# define CONFIG_SYS_NS16550_CLK XILINX_UART16550_CLOCK_HZ # define CONFIG_BAUDRATE 115200 - /* The following table includes the supported baudrates */ # define CONFIG_SYS_BAUDRATE_TABLE \ {300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200, 230400} -# define CONSOLE_ARG "console=console=ttyS0,115200\0" -#else -# error Undefined uart -#endif /* setting reset address */ /*#define CONFIG_SYS_RESET_ADDRESS CONFIG_SYS_TEXT_BASE*/ -/* ethernet */ -#undef CONFIG_SYS_ENET -#if defined(XILINX_EMACLITE_BASEADDR) || defined(CONFIG_OF_CONTROL) -# define CONFIG_XILINX_EMACLITE 1 -# define CONFIG_SYS_ENET -#endif -#if defined(XILINX_AXIEMAC_BASEADDR) -# define CONFIG_XILINX_AXIEMAC 1 -# define CONFIG_SYS_ENET -#endif - -#undef ET_DEBUG - /* gpio */ #ifdef XILINX_GPIO_BASEADDR # define CONFIG_XILINX_GPIO # define CONFIG_SYS_GPIO_0_ADDR XILINX_GPIO_BASEADDR #endif +#define CONFIG_BOARD_LATE_INIT /* interrupt controller */ #ifdef XILINX_INTC_BASEADDR @@ -103,13 +69,6 @@ # endif #endif -#if !defined(CONFIG_OF_CONTROL) || \ - (defined(CONFIG_SPL_BUILD) && !defined(CONFIG_SPL_OF_CONTROL)) -/* ddr sdram - main memory */ -# define CONFIG_SYS_SDRAM_BASE XILINX_RAM_START -# define CONFIG_SYS_SDRAM_SIZE XILINX_RAM_SIZE -#endif - #define CONFIG_SYS_MALLOC_LEN 0xC0000 /* Stack location before relocation */ @@ -198,16 +157,6 @@ #endif /* !SPIFLASH */ #endif /* !FLASH */ -/* system ace */ -#ifdef XILINX_SYSACE_BASEADDR -# define CONFIG_SYSTEMACE -/* #define DEBUG_SYSTEMACE */ -# define SYSTEMACE_CONFIG_FPGA -# define CONFIG_SYS_SYSTEMACE_BASE XILINX_SYSACE_BASEADDR -# define CONFIG_SYS_SYSTEMACE_WIDTH XILINX_SYSACE_MEM_WIDTH -# define CONFIG_DOS_PARTITION -#endif - #if defined(XILINX_USE_ICACHE) # define CONFIG_ICACHE #else @@ -245,17 +194,6 @@ # undef CONFIG_CMD_CACHE #endif -#ifdef CONFIG_SYS_ENET -# define CONFIG_CMD_PING -# define CONFIG_CMD_DHCP -# define CONFIG_CMD_TFTPPUT -#endif - -#if defined(CONFIG_SYSTEMACE) -# define CONFIG_CMD_EXT2 -# define CONFIG_CMD_FAT -#endif - #if defined(FLASH) # define CONFIG_CMD_JFFS2 # define CONFIG_CMD_UBI @@ -315,7 +253,7 @@ #define CONFIG_SYS_MAXARGS 15 #define CONFIG_SYS_LONGHELP /* default load address */ -#define CONFIG_SYS_LOAD_ADDR XILINX_RAM_START +#define CONFIG_SYS_LOAD_ADDR 0 #define CONFIG_BOOTDELAY -1 /* -1 disables auto-boot */ #define CONFIG_BOOTARGS "root=romfs" @@ -342,15 +280,10 @@ #define CONFIG_CMDLINE_EDITING -#define CONFIG_NETCONSOLE #define CONFIG_SYS_CONSOLE_IS_IN_ENV -/* Use the HUSH parser */ -#define CONFIG_SYS_HUSH_PARSER - /* Enable flat device tree support */ #define CONFIG_LMB 1 -#define CONFIG_FIT 1 #define CONFIG_OF_LIBFDT 1 #if defined(CONFIG_XILINX_AXIEMAC) @@ -358,20 +291,19 @@ # define CONFIG_CMD_MII 1 # define CONFIG_PHY_GIGE 1 # define CONFIG_SYS_FAULT_ECHO_LINK_DOWN 1 -# define CONFIG_PHYLIB 1 # define CONFIG_PHY_ATHEROS 1 # define CONFIG_PHY_BROADCOM 1 # define CONFIG_PHY_DAVICOM 1 # define CONFIG_PHY_LXT 1 # define CONFIG_PHY_MARVELL 1 # define CONFIG_PHY_MICREL 1 +# define CONFIG_PHY_MICREL_KSZ9021 # define CONFIG_PHY_NATSEMI 1 # define CONFIG_PHY_REALTEK 1 # define CONFIG_PHY_VITESSE 1 #else # undef CONFIG_MII # undef CONFIG_CMD_MII -# undef CONFIG_PHYLIB #endif /* SPL part */ |