diff options
Diffstat (limited to 'lib/Kconfig')
| -rw-r--r-- | lib/Kconfig | 57 |
1 files changed, 57 insertions, 0 deletions
diff --git a/lib/Kconfig b/lib/Kconfig index 2120216593..05f82d4a50 100644 --- a/lib/Kconfig +++ b/lib/Kconfig @@ -165,6 +165,63 @@ config RBTREE config BITREVERSE bool "Bit reverse library from Linux" +config TRACE + bool "Support for tracing of function calls and timing" + imply CMD_TRACE + help + Enables function tracing within U-Boot. This allows recording of call + traces including timing information. The command can write data to + memory for exporting for analysis (e.g. using bootchart). + See doc/README.trace for full details. + +config TRACE_BUFFER_SIZE + hex "Size of trace buffer in U-Boot" + depends on TRACE + default 0x01000000 + help + Sets the size of the trace buffer in U-Boot. This is allocated from + memory during relocation. If this buffer is too small, the trace + history will be truncated, with later records omitted. + + If early trace is enabled (i.e. before relocation), this buffer must + be large enough to include all the data from the early trace buffer as + well, since this is copied over to the main buffer during relocation. + + A trace record is emitted for each function call and each record is + 12 bytes (see struct trace_call). A suggested minimum size is 1MB. If + the size is too small then 'trace stats' will show a message saying + how many records were dropped due to buffer overflow. + +config TRACE_EARLY + bool "Enable tracing before relocation" + depends on TRACE + help + Sometimes it is helpful to trace execution of U-Boot before + relocation. This is possible by using a arch-specific, fixed buffer + position in memory. Enable this option to start tracing as early as + possible after U-Boot starts. + +config TRACE_EARLY_SIZE + hex "Size of early trace buffer in U-Boot" + depends on TRACE_EARLY + default 0x00100000 + help + Sets the size of the early trace buffer in bytes. This is used to hold + tracing information before relocation. + +config TRACE_EARLY_ADDR + hex "Address of early trace buffer in U-Boot" + depends on TRACE_EARLY + default 0x00100000 + help + Sets the address of the early trace buffer in U-Boot. This memory + must be accessible before relocation. + + A trace record is emitted for each function call and each record is + 12 bytes (see struct trace_call). A suggested minimum size is 1MB. If + the size is too small then the message which says the amount of early + data being coped will the the same as the + source lib/dhry/Kconfig menu "Security support" |