summaryrefslogtreecommitdiff
AgeCommit message (Collapse)Author
2011-02-12x86: Add processor flags header from linuxGraeme Russ
2011-02-12x86: Move Global Descriptor Table defines to processor.hGraeme Russ
2011-02-12x86: Add stack dump to register dumpGraeme Russ
2011-02-12x86: Fix mangled umlautsGraeme Russ
git mergetool has a nasty habit of mangling umlats - fix ones that have been missed in previous submissions
2011-02-12sc520: Sort MakefileGraeme Russ
2011-02-12x86: Parametize values used in linker scriptGraeme Russ
2011-02-12eNET: Create distinct board configurationsGraeme Russ
Position independant functionality is due for removal from the x86 architecture, so create two distinct configurations - One for Flash and one for SRAM
2011-02-12x86: Align config.mk and linker scripts with other archesGraeme Russ
2011-02-12x86: Fix definition of global_data struct for asm-offsets.cGraeme Russ
2011-02-11Merge branch 'master' of git://git.denx.de/u-boot-mpc85xxWolfgang Denk
2011-02-10powerpc/8xxx: Add additional cycle to write-to-read turnaound for DDR3York Sun
When DDR data rate is higher than 1200MT/s or controller interleaving is enabled, additional cycle for write-to-read turnaround is needed to satisfy dynamic ODT timing. Signed-off-by: York Sun <yorksun@freescale.com> Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
2011-02-09powerpc/85xx: corrected p1_p2_rdb EEPROM addressPriyanka Jain
Board EEPROM is used to read/save Ethernet MAC addresses. Signed-off-by: Priyanka Jain <Priyanka.Jain@freescale.com> Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
2011-02-09powerpc/85xx: Fix p1_p2_rdb boards.cfgKumar Gala
We should have been defining the actual board name in the options, not the processor. Fix this for P1011RDB, P1020RDB, P2010RDB, and P2020RDB. Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
2011-02-09fsl: update CRC after setting EEPROM identifierTimur Tabi
The "mac id" command is used to initialize the EEPROM data to a specific format, but it was not updating the CRC. This didn't cause any real problems, because writing the data to the EEPROM will always update the CRC anyway, but it did result in a bogus CRC warning. Signed-off-by: Timur Tabi <timur@freescale.com> Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
2011-02-09cmd_bmp.c: message about compressed formats is debug info only.Wolfgang Denk
Signed-off-by: Wolfgang Denk <wd@denx.de> Cc: Anatolij Gustschin <agust@denx.de>
2011-02-09Merge branch 'master' of git://git.denx.de/u-boot-nand-flashWolfgang Denk
2011-02-09Merge branch 'next' of git://git.denx.de/u-boot-niosWolfgang Denk
2011-02-09Merge branch 'master' of git://git.denx.de/u-boot-ppc4xxWolfgang Denk
2011-02-08NAND: env: remember the flags used in the previous environmentScott Wood
Previously, uninitialized stack space was being referenced. Signed-off-by: Scott Wood <scottwood@freescale.com>
2011-02-08nios2: add gpio_is_validThomas Chou
Signed-off-by: Thomas Chou <thomas@wytron.com.tw> Signed-off-by: Scott McNutt <smcnutt@psyent.com>
2011-02-08nios2: use long for ssize_tThomas Chou
This is consistent with nios2-linux. And resolved the warning, cmd_nvedit.c: In function `do_env_export': cmd_nvedit.c:660: warning: size_t format, ssize_t arg (arg 3) Signed-off-by: Thomas Chou <thomas@wytron.com.tw> Signed-off-by: Scott McNutt <smcnutt@psyent.com>
2011-02-08altera_spi: add spi_set_speedThomas Chou
Added this for mmc_spi driver. Though altera spi core does not support programmable speed. It is fixed when configured in sopc-builder. Signed-off-by: Thomas Chou <thomas@wytron.com.tw> Signed-off-by: Scott McNutt <smcnutt@psyent.com>
2011-02-08nios2: add gpio_freeThomas Chou
Signed-off-by: Thomas Chou <thomas@wytron.com.tw> Signed-off-by: Scott McNutt <smcnutt@psyent.com>
2011-02-07ppc4xx: Add DLVision-10G board supportDirk Eibach
Board support for the Guntermann & Drunck DLVision-10G. Adds support for multiple FPGAs per board for gdsys 405ep architecture. Adds support for dual link osd hardware for gdsys 405ep. Signed-off-by: Dirk Eibach <eibach@gdsys.de> Signed-off-by: Stefan Roese <sr@denx.de>
2011-02-06Merge branch 'master' of git://git.denx.de/u-boot-mpc83xxWolfgang Denk
2011-02-06Merge branch 'master' of git://git.denx.de/u-boot-usbWolfgang Denk
2011-02-06Merge branch 'master' of git://git.denx.de/u-boot-mpc85xxWolfgang Denk
2011-02-05mpc83xx: Use correct register to calculate clocks.Joakim Tjernlund
Use SPMR instead of HRCWL when calculating clocks as HCRWL may be changed and the CPU will not pick up all changes until there is a POR. u-boot will think SPMF has changed and get the clocks wrong. Signed-off-by: Joakim Tjernlund <Joakim.Tjernlund@transmode.se> Signed-off-by: Kim Phillips <kim.phillips@freescale.com>
2011-02-05mpc83xx: fix pcie configuration space read/writeLeo Liu
This patch fix a problem for the pcie enumeration when the mpc83xx pcie controller is connected with switch or we use both of the two pcie controller. Signed-off-by: Leo Liu <liucai.lfn@gmail.com> fix codingstyle and compiler warning: 'pcie_priv' defined but not used Signed-off-by: Kim Phillips <kim.phillips@freescale.com>
2011-02-05USB: Change the necessary defines to get debug outputAlexander Holler
While debugging some USB stuff, I've first missed that there are actually two defines necessary to get usefull output. The one needed to get debug output for the communication with HUBs was burried somewhere deep inside the code. Change that so that a #define DEBUG is enough while still leaving the possibility to reduce unwanted debug output. Signed-off-by: Alexander Holler <holler@ahsoftware.de>
2011-02-05USB: Fix device stati for removable and powerctrl (typo)Alexander Holler
I currently don't know if the error could have other consequences than a wrong output when turning debug on. Signed-off-by: Alexander Holler <holler@ahsoftware.de>
2011-02-04Merge branch 'master' of git://git.denx.de/u-boot-nand-flashWolfgang Denk
2011-02-04powerpc/8xxx: Fix possible compile issue related to P1013Kumar Gala
The P1013 is a single core version of P1022 and thus should use the p1022_serdes.c code. It was acciently pointing to p1013_serdes.c which doesn't exist. Reported-by: Renaud Barbier <renaud.barbier@ge.com> Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
2011-02-04Merge branch 'master' of git://git.denx.de/u-boot-shWolfgang Denk
2011-02-03powerpc/85xx: Enable ECC on MPC8572DSYork Sun
Using hwconfig to turn on/off ECC, without re-compiling. Signed-off-by: York Sun <yorksun@freescale.com> Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
2011-02-03powerpc/mpc85xx: implement workaround for errata DDR111 and DDR134York Sun
Workaround for the following errata: DDR111 - MCKE signal may not function correctly at assertion of HRESET DDR134 - The automatic CAS-to-Preamble feature of the DDR controller can calibrate to incorrect values These two workarounds must be implemented together because they touch common registers. Signed-off-by: York Sun <yorksun@freescale.com> Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
2011-02-03powerpc/85xx: Rename MPC8572 DDR erratum to DDR115York Sun
Use unique erratum number instead of platform number. Enable command that reports errata on MPC8572DS. Signed-off-by: York Sun <yorksun@freescale.com> Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
2011-02-03powerpc/85xx: Enable Errata command on MPC8572DSYork Sun
Also removed duplicate CONFIG_CMD_IRQ define. Signed-off-by: York Sun <yorksun@freescale.com> Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
2011-02-03powerpc/85xx: Remove unnecessary polling loop from DDR initYork Sun
This polling loop is not required normally, unless specifically stated in workaround. Signed-off-by: York Sun <yorksun@freescale.com> Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
2011-02-03fsl_esdhc: Add the workaround for erratum ESDHC-A001 (enable on P2020)Kumar Gala
Data timeout counter (SYSCTL[DTOCV]) is not reliable for values of 4, 8, and 12. Program one more than the desired value: 4 -> 5, 8 -> 9, 12 -> 13. Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
2011-02-03powerpc/85xx: Enable ESDHC111 Erratum on P2010/P2020 SoCsKumar Gala
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
2011-02-03sh: sh7785lcr: Fix out of tree buildingNobuhiro Iwamatsu
Signed-off-by: Nobuhiro Iwamatsu <nobuhiro.iwamatsu.yj@renesas.com> Signed-off-by: Nobuhiro Iwamatsu <iwamatsu@nigauri.org>
2011-02-02NAND: Fix saving of redundand environmentAlexander Holler
When redundand environments are used the serial needs to get increased, otherwise the old one will still be used. Signed-off-by: Alexander Holler <holler@ahsoftware.de>
2011-02-02Prepare v2011.03-rc1Wolfgang Denk
Signed-off-by: Wolfgang Denk <wd@denx.de>
2011-02-02Minor Coding Style Cleanup.Wolfgang Denk
Signed-off-by: Wolfgang Denk <wd@denx.de>
2011-02-02Merge branch 'master' of /home/wd/git/u-boot/custodiansWolfgang Denk
2011-02-02Print compiler and linker version with the version commandAlexander Holler
After years of unsuccessful research I've finally shamelessly stolen other peoples intellectual properties to present the all-new and world-changing updated version command: - U-Boot>> version U-Boot 2010.12-00014-g7435056-dirty (Jan 18 2011 - 23:19:38) MyBoard gcc (GCC) 0.42 (Distro foobar) GNU ld (GNU Binutils) 0.314159265 - May the toolchain bugs rest in peace. Signed-off-by: Alexander Holler <holler@ahsoftware.de>
2011-02-02change email address in MAINTAINERSYoshihiro Shimoda
Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>
2011-02-02change email address in MAINTAINERSYoshihiro Shimoda
Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com> Signed-off-by: Nobuhiro Iwamatsu <iwamatsu@nigauri.org>
2011-02-02sh: add support for sh7757lcr boardYoshihiro Shimoda
The R0P7757LC0030RL board has SH7757, 256MB DDR3-SDRAM, SPI ROM, Ethernet, and more. This patch supports the following functions: - 256MB DDR3-SDRAM - SPI ROM - Ethernet Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com> Signed-off-by: Nobuhiro Iwamatsu <iwamatsu@nigauri.org>
generated by cgit (git 2.34.1) at 2024-12-28 13:41:56 +0000