uboot-2021-rebase.git - uboot 2021 rebase, to fix booting on modern SD cards, from https://github.com/fifteenhex/u-boot/tree/am335x_som

Age	Commit message (Expand)	Author
2016-06-12	arm: at91: Add a header file for the real-time clock	Andre Renaud
2016-06-12	arm: at91: dts: Bring in device tree file for AT91SAM9G45	Simon Glass
2016-06-12	net: macb: Convert to driver model	Simon Glass
2016-06-12	net: macb: Flush correct cache portion when sending	Simon Glass
2016-06-12	net: macb: Prepare for driver-model conversion	Simon Glass
2016-06-12	net: Handle an empty bootp extension section	Andre Renaud
2016-06-12	bootm: Align cache flush end address correctly	Simon Glass
2016-06-12	arm: Allow skipping of low-level init with I-cache on	Simon Glass
2016-06-12	at91: Add support for the AT91 slow clock controller	Andre Renaud
2016-06-12	gpio: at91: Fix pullup/pulldown configuration on PIO3	Marek Vasut
2016-06-12	verified-boot: Minimal support for booting U-Boot proper from SPL	Teddy Reed
2016-06-12	ti_armv7_common: env: Remove no longer needed mem_reserve	Andrew F. Davis
2016-06-12	cmd: gpt: add - partition size parsing	Michael Trimarchi
2016-06-12	arm: dra7xx: Assign omap_vcores based on board type	Keerthy
2016-06-12	Merge branch 'master' of http://git.denx.de/u-boot-sunxi	Tom Rini
2016-06-12	Merge branch 'master' of git://git.denx.de/u-boot-mips	Tom Rini
2016-06-12	Merge branch 'master' of git://www.denx.de/git/u-boot-imx	Tom Rini
2016-06-12	Merge branch 'master' of git://git.denx.de/u-boot-x86	Tom Rini
2016-06-12	x86: broadwell: gpio: Remove the codes to set up pin control	Bin Meng
2016-06-12	x86: Probe pinctrl driver in cpu_init_r()	Bin Meng
2016-06-12	x86: Enable regmap and syscon for coreboot and qemu-x86	Bin Meng
2016-06-12	x86: Update x86-pinctrl driver device-tree-bindings doc	Bin Meng
2016-06-12	x86: baytrail: Configure card detect pin of the SD controller	Bin Meng
2016-06-12	x86: baytrail: Change fsp, emmc-boot-mode to "auto"	Bin Meng
2016-06-12	x86: baytrail: Add 'reg' property in the pinctrl node	Bin Meng
2016-06-12	x86: ich6_gpio: Output return value of syscon_get_by_driver_data()	Bin Meng
2016-06-12	x86: acpi: Fix madt lapic generation	George McCollister
2016-06-10	armv8: ls2080aqds: Enable QSPI boot support	Yuan Yao
2016-06-10	configs: ls2080aqds_nand_defconfig: Enable QSPI	Yuan Yao
2016-06-10	configs: ls2080a: Increase load image len in NAND boot	Yuan Yao
2016-06-10	armv8: ls2080aqds: Config QSPI pin mux via FPGA in NAND boot	Yuan Yao
2016-06-10	dts: ls2080aqds: Add QSPI dts node	Yuan Yao
2016-06-10	configs: ls2080aqds: Enable QSPI flash support	Yuan Yao
2016-06-10	armv8: ls2080aqds: disable IFC NOR & QIXIS when QSPI enable	Yuan Yao
2016-06-10	configs: ls2080a_common: Remove duplicate NOR configs	Yuan Yao
2016-06-10	armv8: ls2080aqds: Select QSPI CLK div via SCFG	Yuan Yao
2016-06-10	drivers: i2c: mxc: Add early init	Yuan Yao
2016-06-10	board: ls2080a: Add "mcinitcmd" env for MC & DPL deployment	Pratiyush Mohan Srivastava
2016-06-10	armv8/ls2080a: configure PMU's PCTBENR to enable WDT	Yunhui Cui
2016-06-10	sunxi: Move the SPL stack top to 0x1A000 on Allwinner A64/A80	Siarhei Siamashka
2016-06-10	sunxi: Downclock AHB1 to 100MHz on Allwinner A64	Siarhei Siamashka
2016-06-10	spi: pic32_spi: add SPI master driver for PIC32 SoC.	Purna Chandra Mandal
2016-06-10	MIPS: Make CONFIG_SYS_DCACHE_LINE_SIZE int, not hex	Paul Burton
2016-06-10	MIPS: Fix invalidate_dcache_range to operate on L1 Dcache	Paul Burton
2016-06-10	sunxi: musb: Properly turn of musb controller before booting	Hans de Goede
2016-06-10	sunxi: Add INITIAL_USB_SCAN_DELAY to Mele_A1000G_quad_defconfig	Hans de Goede
2016-06-10	sunxi: Enable ALDO3 and ALDO4 in Wobo_i5_defconfig	Hans de Goede
2016-06-09	siemens,am33x: add draco etamin board	Heiko Schocher
2016-06-09	dfu, nand, ubi: fix erasing after write finish	Heiko Schocher
2016-06-09	am335x, dxr2: get ECC sType from I2C eeprom	Heiko Schocher