uboot-2021-rebase.git - uboot 2021 rebase, to fix booting on modern SD cards, from https://github.com/fifteenhex/u-boot/tree/am335x_som

Age	Commit message (Expand)	Author
2019-10-25	dts: mtmips: add default pinctrl for gardena-smart-gateway-mt7688	Weijie Gao
2019-10-25	dts: mtmips: add mmc related nodes for mt7628an.dtsi	Weijie Gao
2019-10-25	mmc: mtk-sd: add a dts property cd-active-high for builtin-cd mode	Weijie Gao
2019-10-25	mmc: mtk-sd: add support for MediaTek MT7620/MT7628 SoCs	Weijie Gao
2019-10-25	dts: mtmips: enable eth port0 led and link poll functions for all boards	Weijie Gao
2019-10-25	net: mt7628-eth: add support to isolate LAN/WAN ports	Weijie Gao
2019-10-25	net: mt7628-eth: free rx descriptor on receiving failure	Weijie Gao
2019-10-25	net: mt7628-eth: make phy link up detection optional via DT	Weijie Gao
2019-10-25	net: mt7628-eth: remove hardcoded gpio settings and regmap-based phy reset	Weijie Gao
2019-10-25	phy: mt76x8-usb-phy: add slew rate calibration and remove non-mt7628 part	Weijie Gao
2019-10-25	dts: mtmips: update reset controller node for mt7628	Weijie Gao
2019-10-25	reset: add reset controller driver for MediaTek MIPS platform	Weijie Gao
2019-10-25	dts: mtmips: add default pinctrl for uart nodes	Weijie Gao
2019-10-25	dts: mtmips: add pinctrl node for mt7628	Weijie Gao
2019-10-25	pinctrl: add support for MediaTek MT7628	Weijie Gao
2019-10-25	spi: mt7621-spi: restore default register value after each xfer	Weijie Gao
2019-10-25	spi: mt7621-spi: remove data cache and rewrite its xfer function	Weijie Gao
2019-10-25	spi: mt7621-spi: use clock frequency from clk driver	Weijie Gao
2019-10-25	dts: mtmips: add clock node for mt7628	Weijie Gao
2019-10-25	clk: add clock driver for MediaTek MT76x8 platform	Weijie Gao
2019-10-25	dts: mtmips: enable high-speed UART support for mt7628	Weijie Gao
2019-10-25	dts: mtmips: move uart property clock-frequency into mt7628an.dtsi	Weijie Gao
2019-10-25	serial: serial_mtk: add non-DM version for SPL	Weijie Gao
2019-10-25	serial: serial_mtk: enable FIFO and disable flow control	Weijie Gao
2019-10-25	drivers: nand: brcmnand: fix nand_chip ecc layout structure	William Zhang
2019-10-25	mips: bmips: switch to board defines for dtb	Álvaro Fernández Rojas
2019-10-25	bmips: correct name characters	Álvaro Fernández Rojas
2019-10-25	bmips: configs: switch to size definitions	Álvaro Fernández Rojas
2019-10-25	mips: bmips: remove unneeded definitions	Álvaro Fernández Rojas
2019-10-25	bmips: enable vr-3032u nand support	Álvaro Fernández Rojas
2019-10-25	bmips: bcm63268: add support for brcmnand	Álvaro Fernández Rojas
2019-10-25	bmips: bcm6362: add support for brcmnand	Álvaro Fernández Rojas
2019-10-25	bmips: bcm6328: add support for brcmnand	Álvaro Fernández Rojas
2019-10-25	bmips: bcm6368: add support for brcmnand	Álvaro Fernández Rojas
2019-10-25	nand: brcm: add BCM6368 support	Álvaro Fernández Rojas
2019-10-25	MIPS: add compile time definition of L2 cache size	Ramon Fried
2019-10-25	sunxi: set PIO voltage to hardware-detected value on startup on H6	Icenowy Zheng
2019-10-25	arm: dts: sync dts for Allwinner H6	Clément Péron
2019-10-25	sunxi: Fix pll1 clock calculation	Stefan Mavrodiev
2019-10-25	arm64: dts: sun50i: Add support for A64 OLinuXino (with eMMC)	Sunil Mohan Adapa
2019-10-25	sunxi: H6: DRAM: Add support for half DQ	Jernej Skrabec
2019-10-25	spi-nor-ids: Add support for Adesto AT25SL321	Fabio Estevam
2019-10-25	mtd: spi: Clean up usage of CONFIG_SPI_FLASH_MTD	Frieder Schrempf
2019-10-25	spi-nor: spi-nor-ids: Add USE_FSR flag for mt25q* and n25q* entry	Vignesh Raghavendra
2019-10-25	spi-nor: spi-nor-ids: Add entries for mt25q variants	Vignesh Raghavendra
2019-10-25	spi-nor: spi-nor-ids: Disable SPI_NOR_4B_OPCODES for n25q512* and n25q256*	Vignesh Raghavendra
2019-10-25	spi: designware_spi: Disable and free clock when remove driver	Ley Foon Tan
2019-10-25	mtd: spi-nor-core: Replace MTD_SPI_NOR_USE_4K_SECTORS with SPI_FLASH_USE_4K_S...	Vignesh Raghavendra
2019-10-25	mtd: spi-nor-core: Use dev_err for reporting erase/write failures	Vignesh Raghavendra
2019-10-25	stm32mp1: configs: Add CONFIG_SPL_SPI_FLASH_MTD	Frieder Schrempf