summaryrefslogtreecommitdiff
AgeCommit message (Expand)Author
2016-04-13ARM64: zynqmp: Move kernel and fdt offsets and sizes to board config fileSiva Durga Prasad Paladugu
2016-04-13ARM: zynq: Do not perform reset at the end of thorMichal Simek
2016-04-13ARM: zynq: Support systems with more memory banksMichal Simek
2016-04-13ARM: zynq: Use memory initialization based on DTS fileMichal Simek
2016-04-13ARM: zynq: Fix usb phy node for ZyboMichal Simek
2016-04-13ARM: zynq: Extend microzed board supportMichal Simek
2016-04-13ARM: zynq: Add missing qspi for xm013Michal Simek
2016-04-13ARM: zynq: Create empty line below headersMichal Simek
2016-04-13ARM: zynq: Align spi and qspi node locationsMichal Simek
2016-04-13ARM: zynq: zc706: Add adv7511 on i2c busChristian Kohn
2016-04-13ARM: zynq: zc702: Add adv7511 on i2c busChristian Kohn
2016-04-13ARM: zynq: DT: Add ethernet phy reset informationPunnaiah Choudary Kalluri
2016-04-13ARM: zynq: Fix bootargs in board dtsiMichal Simek
2016-04-13ARM: zynq: Align devcfg nodeMichal Simek
2016-04-13ARM: dts: Updated devicetree bindings for Zynq 7000 platformMoritz Fischer
2016-04-13ARM: dts: zynq: Add devicetree entry for Xilinx Zynq reset controller.Moritz Fischer
2016-04-13ARM: zynq: Add interrupt-controller property to gpio nodesMichal Simek
2016-04-13Merge git://www.denx.de/git/u-boot-cfi-flashTom Rini
2016-04-13mtd: cfi: Unlock current sector instead of sector 0 before buffered writeRouven Behr
2016-04-13Merge branch 'master' of git://www.denx.de/git/u-boot-imxTom Rini
2016-04-12Merge git://www.denx.de/git/u-boot-marvellTom Rini
2016-04-12arm: mvebu: theadorable: Remove Board name output in checkboardStefan Roese
2016-04-12arm: mvebu: theadorable: Add PEX-switch detection and reset codeStefan Roese
2016-04-12arm: mvebu: theadorable: Enable 2nd I2C controllerStefan Roese
2016-04-12arm: mvebu: Add base address for 2nd I2C controllerStefan Roese
2016-04-12arm: mvebu: theadorable: Add bootcounter supportStefan Roese
2016-04-12arm: mvebu: theadorable: Add USB power toggle and tweak USB PHY registerStefan Roese
2016-04-12gpio: mvebu_gpio: Add missing out value set to gpio_direction_output()Stefan Roese
2016-04-12sunxi: Add defconfig and dts file for Orange Pi One SBCHans de Goede
2016-04-12sunxi: H3: Do not clear usb companion clk-gate / reset on removeHans de Goede
2016-04-12sunxi: Enable CMD_GPIO on all sunxi boardsHans de Goede
2016-04-12sunxi: Enable usb ports on the Sinovoip BPI M3Hans de Goede
2016-04-12sunxi: Set DCDC1 to 3.3V on the Sinovoip BPI M3Hans de Goede
2016-04-12sunxi: Add INITIAL_USB_SCAN_DELAY Kconfig optionHans de Goede
2016-04-11Prepare v2016.05-rc1Tom Rini
2016-04-11fastboot: sparse: remove unnecessary loggingSteve Rae
2016-04-11fastboot: sparse: fix block addressing for don't care chunk typeSteve Rae
2016-04-11Merge branch 'master' of git://git.denx.de/u-boot-arcTom Rini
2016-04-11spl: mmc: raw: Try to load u-boot if Linux image is not foundLokesh Vutla
2016-04-11arm: Replace v7_maint_dcache_all(ARMV7_DCACHE_INVAL_ALL) with asm codeHans de Goede
2016-04-11arm: Replace v7_maint_dcache_all(ARMV7_DCACHE_CLEAN_INVAL_ALL) with asm codeHans de Goede
2016-04-11lib/crc8: Add crc start valueStefan Roese
2016-04-11test/py: README: link to example hook scriptsStephen Warren
2016-04-11bootcounter_ram: Flush dcache after data is written into SDRAMStefan Roese
2016-04-11disk: part: Enable get_info pointer for CONFIG_SPL_FAT_SUPPORTMichal Simek
2016-04-11am33xx changed BOOT_DEVICE_SPI to correct valueVogt, Christof
2016-04-11rpi: remove redundant board filesStephen Warren
2016-04-11stm32: stm32_flash: add memory barrier during flash writeVikas Manocha
2016-04-11test/py: Add support for loading image via tftp to specified locationMichal Simek
2016-04-11spmi: Fix sandbox spmi driver memory corruptionMateusz Kulikowski