uboot-2021-rebase.git - uboot 2021 rebase, to fix booting on modern SD cards, from https://github.com/fifteenhex/u-boot/tree/am335x_som

Age	Commit message (Expand)	Author
2017-11-28	arm64: zynqmp: Add clock name for GPU	Madhurkiran Harikrishnan
2017-11-28	arm64: zynqmp: Label whole PL part as fpga_full region	Nava kishore Manne
2017-11-28	arm64: zynqmp: Fix broken architected timer interrupt trigger	Michal Simek
2017-11-28	arm64: zynqmp: PM: Add IRQ	Soren Brinkmann
2017-11-28	arm64: zynqmp: Reduced min-residency time for idle state node	Jolly Shah
2017-11-28	arm64: zynqmp: DT: Fix typo in idle-states node definition	Jyotheeswar Reddy
2017-11-28	arm64: zynqmp: Update the OPPs for cpu freq	Shubhrajyoti Datta
2017-11-28	arm64: zynqmp: Add references to cpu nodes	Michal Simek
2017-11-28	arm64: zynqmp: Wire QSPI boot mode for SPL	Michal Simek
2017-11-28	arm64: zynqmp: Enable debug uart for zc1751 dc5	Michal Simek
2017-11-28	arm64: zynqmp: Add new ID for RFSoC	Michal Simek
2017-11-28	arm64: zynqmp: Add support for CG/EG/EV device detection	Michal Simek
2017-11-28	arm64: zynqmp: Use u32 type instead of uint32_t	Michal Simek
2017-11-28	arm64: zynqmp: Add SD1 level shifter mode to alternative selection	Michal Simek
2017-11-28	arm64: zynqmp: Enable config DEFINE_TCM_OCM_MMAP if CONFIG_MP defined	Siva Durga Prasad Paladugu
2017-11-28	tools: mkimage: Extend mkimage to also include pmufw	Michal Simek
2017-11-28	arm64: zynqmp: Provide a Kconfig option to use specified memory for MMU table	Siva Durga Prasad Paladugu
2017-11-28	arm64: zynqmp: mp: Correct the R5 release sequence	Siva Durga Prasad Paladugu
2017-11-28	arm64: zynqmp: Remove slcr with mio status pin detection	Michal Simek
2017-11-28	ata: Fix ahci wording	Michal Simek
2017-11-28	arm: zynq: Add mini u-boot configuration for zynq	Michal Simek
2017-11-28	arm: zynq: Sort dts names	Michal Simek
2017-11-28	arm: zynq: Move ZYNQ_SERIAL to Kconfig	Michal Simek
2017-11-28	arm: zynq: Enable FPGA/FPGA_XILINX via Kconfig	Michal Simek
2017-11-28	arm: zynq: Return value from fdtdec_setup_memory_banksize directly	Michal Simek
2017-11-28	arm: zynq: Add board support for cc108	Michal Simek
2017-11-28	arm: zynq: Enable qspi for zc770_xm013	Michal Simek
2017-11-28	arm: zynq: Enable MACRONIX flash for zc702/zc706/zc770 xm010	Michal Simek
2017-11-28	arm: zynq: Enable debug console on zc770 xm010 by default	Michal Simek
2017-11-28	arm: zynq: Enable bootz command for Xilinx platforms	Michal Simek
2017-11-28	arm: zynq: Sync location of DT properties with Linux	Michal Simek
2017-11-28	arm: zynq: Remove empty ifdef env structures from config file	Michal Simek
2017-11-28	arm: zynq: Add device-type property for zynq ethernet phy nodes	Sai Pavan Boddu
2017-11-28	arm: zynq: Add SCL & SDA GPIO entries for recovery	Chirag Parekh
2017-11-28	mtd: nand: zynq: Add a config option to use 1st stage bootloader timing	Jeff Westfahl
2017-11-28	arm: zynq: Add support for SYZYGY Hub board	Tom McLeod
2017-11-28	arm64: zynqmp: remove unnecessary logical constraint	Heinrich Schuchardt
2017-11-27	test: Correct operation when tests pass	Simon Glass
2017-11-27	spl: TI: Do not default to SPL_FIT_IMAGE_TINY being enabled	Tom Rini
2017-11-27	Merge git://www.denx.de/git/u-boot-imx	Tom Rini
2017-11-27	configs: icore-rqs: Enable falcon mode	Jagan Teki
2017-11-27	engicam: imx6q: Return mmc dev 0 for icore	Jagan Teki
2017-11-27	i.MX6: engicam: Add imx6q/imx6ul boards for existing boards	Jagan Teki
2017-11-27	board: icore-rqs: Fix mmc get env device	Jagan Teki
2017-11-27	i.MX6UL: icore: Add SPL_OF_CONTROL support	Jagan Teki
2017-11-27	pinctrl: imx6ul: Fix pinctrl data overlapped with DT area	Jagan Teki
2017-11-27	i.MX6Q: icore: Add SPL_OF_CONTROL support	Jagan Teki
2017-11-27	i.MX6Q: icorem6: Move spl load fit to common/spl	Jagan Teki
2017-11-27	i.MX6: engicam: Move set_fdt_file to common	Jagan Teki
2017-11-27	mx6sxsabresd: Use PARTUUID to specify the rootfs location	Fabio Estevam