summaryrefslogtreecommitdiff
AgeCommit message (Expand)Author
2020-01-14clk: imx: pfd: add set_rate()Giulio Benetti
2020-01-14clk: imx: pllv3: add support for PLLV3_AV typeGiulio Benetti
2020-01-14clk: imx: pllv3: add PLLV3_SYS supportGiulio Benetti
2020-01-14clk: imx: pllv3: add set_rate() supportGiulio Benetti
2020-01-14clk: imx: pllv3: add disable() supportGiulio Benetti
2020-01-14clk: imx: pllv3: add enable() supportGiulio Benetti
2020-01-14clk: imx: pllv3: set div_mask differently if PLLV3 is GENERIC or USBGiulio Benetti
2020-01-14clk: imx: pllv3: register PLLV3 GENERIC and USB as 2 different clocksGiulio Benetti
2020-01-14armv7m: cache: add mmu_set_region_dcache_behaviour() stub for compatibilityGiulio Benetti
2020-01-14spl: fix entry_point equal to load_addrGiulio Benetti
2020-01-14imx: dts: imx8dx: add I2C IPG clock for bus 0 and 2Anatolij Gustschin
2020-01-14clk: imx8qxp: extend to support getting I2C IPG clockAnatolij Gustschin
2020-01-14ARM: dts: imx6ul-14x14-evk: Pass the "broken-cd" propertyFabio Estevam
2020-01-14mmc: fsl_esdhc_imx: Handle the "broken-cd" propertyFabio Estevam
2020-01-14pico-imx7d: Convert to DM_ETHJoris Offouga
2020-01-14pico-imx7d: Disable USB_ETHER support for bl33 defconfigJoris Offouga
2020-01-14mx6ul_14x14_evk: Fix SPL boot hangFabio Estevam
2020-01-14imx: imx8qxp_mek: update READMEPeng Fan
2020-01-14wandboard: Do not print error message when PMIC is absentFabio Estevam
2020-01-14imx8qxp_mek: Select CONFIG_NET_RANDOM_ETHADDRFabio Estevam
2020-01-14imx: add imx8x based deneb boardAnatolij Gustschin
2020-01-14imx: add imx8x capricorn giedi boardAnatolij Gustschin
2020-01-14tegra: fdt: Add tegra186-u-boot.dtsiStephen Warren
2020-01-14arm64: versal: Enable board_late_init callingMichal Simek
2020-01-14ARM: dts: zynq: enablement of coresight topologyZumeng Chen
2020-01-14arm64: zynqmp: Sync gem clock nodes with mainline LinuxMichal Simek
2020-01-14arm64: zynqmp: Sync gpio-controller name locationMichal Simek
2020-01-14arm64: dts: zynqmp: replace gpio-key,wakeup with wakeup-source propertySudeep Holla
2020-01-14arm64: dts: zcu100-revC: Give wifi some time after power-onJan Kiszka
2020-01-14arm64: dts: zynqmp: Fix node names which contain "_"Michal Simek
2020-01-14arm64: dts: Remove inconsistent use of 'arm,armv8' compatible stringRob Herring
2020-01-14arm64: zynqmp: Remove incorrect phy from DT for zcu102-revB upMichal Simek
2020-01-14arm64: zynqmp: Add support for zcu1285 revA boardMichal Simek
2020-01-14net: zynq: Add a note about RX_BUF macroMichal Simek
2020-01-14arm64: zynqmp: Switch zcu100 revC to use firmware clock driverMichal Simek
2020-01-14zynqmp: dts: Cleanup no-1-8-v property from sdhci dt nodesT Karthik Reddy
2020-01-14arm64: zynqmp: Add support for zcu208Michal Simek
2020-01-14ARM: zynq: Add missing nand/smcc nodesMichal Simek
2020-01-14firmware: Remove probe which is causing extra bindAshok Reddy Soma
2020-01-14arm64: zynqmp: Correct the type of eeprom for zcu216 boardsRaviteja Narayanam
2020-01-14arm64: zynqmp: Fix ina226 shunt resistor valueMichal Simek
2020-01-14arm64: zynqmp: Move PANIC to KconfigMichal Simek
2020-01-14arm64: zynqmp: Use zynqmp_virt platformMichal Simek
2020-01-14arm64: zynqmp: Add missing Kconfig options to zynqmp_virt platformMichal Simek
2020-01-14arm64: zynqmp: Add support for u-boot.itb generation with ATFMichal Simek
2020-01-14test/py: hush_if_test: Add tests to cover octal/hex valuesMichal Simek
2020-01-14ARM: zynq: Remove unused QSPI and USB addressesMichal Simek
2020-01-14zynq: mtd: nand: Remove hardcoded base addressesAshok Reddy Soma
2020-01-14zynq: mtd: nand: Move zynq nand driver to driver modelAshok Reddy Soma
2020-01-14ARM: zynq: Add jtag distro boot supportT Karthik Reddy
generated by cgit (git 2.34.1) at 2024-12-27 03:04:13 +0000