summaryrefslogtreecommitdiff
AgeCommit message (Expand)Author
2015-10-27spi: tegra: Use GENMASKJagan Teki
2015-10-27spi: omap3_spi: Use GENMASKJagan Teki
2015-10-27spi: fsl_qspi: Use GENMASKJagan Teki
2015-10-27spi: designware_spi: Use GENMASKJagan Teki
2015-10-27spi: atmel_spi: Use GENMASKJagan Teki
2015-10-27spi: xilinx_spi: Use BIT macroJagan Teki
2015-10-27spi: ti_qspi: Use BIT macroJagan Teki
2015-10-27spi: tegra: Use BIT macroJagan Teki
2015-10-27spi: sh_qspi: Use BIT macroJagan Teki
2015-10-27spi: omap3_spi: Use BIT macroJagan Teki
2015-10-27spi: mpc8xxx_spi: Use BIT macroJagan Teki
2015-10-27spi: ich: Use BIT macroJagan Teki
2015-10-27spi: fsl: Use BIT macroJagan Teki
2015-10-27spi: designware_spi: Use BIT macroJagan Teki
2015-10-27spi: cadence_qspi_apb: Use BIT macroJagan Teki
2015-10-27spi: bfin_spi6xx: Use BIT macroJagan Teki
2015-10-27spi: atmel_spi: Use BIT macroJagan Teki
2015-10-27spi: zynq_[q]spi: Use GENMASK macroJagan Teki
2015-10-27spi: zynq_[q]spi: Use BIT macroJagan Teki
2015-10-25spi: zynq_qspi: Minor cleanupsJagan Teki
2015-10-25sf: Add FSR support to spi_flash_cmd_wait_readyJagan Teki
2015-10-25sf: Update status reg check in spi_flash_cmd_wait_readyJagan Teki
2015-10-25sf: Make flash->flags use for generic usageJagan Teki
2015-10-25sf: Optimize BAR write codeJagan Teki
2015-10-25sf: Add spi_flash_read_barJagan Teki
2015-10-25sf: Return bank_sel, if flash->bank_curr == bank_selJagan Teki
2015-10-25spi: zynq_spi: Remove unneeded headersJagan Teki
2015-10-25zynq-common: Add SPL SPI offset, size configsSiva Durga Prasad Paladugu
2015-10-25spi: zynq_qspi: Fix to configure CPOL, CPHA maskJagan Teki
2015-10-25zynq-common: Enable ISSI SPI-NOR flash supportJagan Teki
2015-10-25sf: params: Add IS25LP128 part supportJagan Teki
2015-10-25sf: params: Add IS25LP064 part supportJagan Teki
2015-10-25sf: params: Add IS25LP032 part supportJagan Teki
2015-10-25spi: zynq_spi: Store cs value into private dataJagan Teki
2015-10-25spi: zynq_spi: Rename baudrate divisor mask nameJagan Teki
2015-10-25spi: zynq_spi: Add config reg shift named macrosJagan Teki
2015-10-25spi: Kconfig: Add Zynq QSPI controller entryJagan Teki
2015-10-25configs: zynq: Enable zynq qspi controllerJagan Teki
2015-10-25zynq-common: Enable Bank/Extended address register supportJagan Teki
2015-10-25zynq-common: Enable zynq qspi controller supportJagan Teki
2015-10-25configs: Enable legacy SPI flash interface supportJagan Teki
2015-10-25dts: zed: Enable zynq qspi controller nodeJagan Teki
2015-10-25dts: zc770-xm010: Enable zynq qspi controller nodeJagan Teki
2015-10-25dts: zc706: Enable zynq qspi controller nodeJagan Teki
2015-10-25dts: zc702: Enable zynq qspi controller nodeJagan Teki
2015-10-25dts: microzed: Enable zynq qspi controller nodeJagan Teki
2015-10-25doc: device-tree-bindings: spi: Add zynq qspi infoJagan Teki
2015-10-25dts: zynq: Add zynq qspi controller nodesJagan Teki
2015-10-25spi: Add zynq qspi controller driverJagan Teki
2015-10-24common/board_f.c: modify the macro to use get_clocks() more commonGong Qianyu
generated by cgit (git 2.34.1) at 2024-12-24 16:20:08 +0000