summaryrefslogtreecommitdiff
AgeCommit message (Expand)Author
2016-04-04ARM64: zynqmp: Read RAM information from DTMichal Simek
2016-04-04ARM64: Move HUSH enabling from board file to defconfigMichal Simek
2016-04-04ARM64: zynqmp: Select SYS_CONFIG_NAME via KconfigMichal Simek
2016-04-04ARM64: zynqmp: Enable FAT write and EXT4 write for USB tooMichal Simek
2016-04-04ARM64: zynqmp: Decrease boot delaySoren Brinkmann
2016-04-04net: axi_emac: Report phy-node error message permanentlyMichal Simek
2016-04-04microblaze: Remove !OF_CONTROL code for timer and interruptMichal Simek
2016-04-04microblaze: Read information about timer/interrupts from DTMichal Simek
2016-04-04ARM: zynq: Fix default ps7_init_gpl.c/h for ZYBOMichal Simek
2016-04-04ARM: zynq: zybo: Enabling reading MAC address from EEPROMMichal Simek
2016-04-04net: gem: Allow to set the MAC from an EEPROMJoe Hershberger
2016-04-04ARM: zynq: Enable option to overwrite default variablesMichal Simek
2016-04-04net: xilinx_axi: Clear Isolate bit if found during phy setupSiva Durga Prasad Paladugu
2016-04-04net: xilinx_axi: Use interface type instead of zeroSiva Durga Prasad Paladugu
2016-04-04zynq-common: Enable phy driver for Xilinx PCS/PMA coreSiva Durga Prasad Paladugu
2016-04-04net: zynq_gem: Add support for SGMII interfaceSiva Durga Prasad Paladugu
2016-04-04phy: Add phy driver support for xilinx PCS/PMA coreSiva Durga Prasad Paladugu
2016-04-02net: phy: Realtek RTL8211B/C PHY ID fixKarsten Merker
2016-04-01MAINTAINERS: Update Scott Wood's email addressScott Wood
2016-04-01sata: use block layer for sata commandEric Nelson
2016-04-01mmc: use block layer in mmc commandEric Nelson
2016-04-01drivers: block: add block device cacheEric Nelson
2016-04-01Add myself as Snapdragon and SPMI maintainerMateusz Kulikowski
2016-04-01board: Add Qualcomm Dragonboard 410C supportMateusz Kulikowski
2016-04-01arm: Add support for Qualcomm Snapdragon familyMateusz Kulikowski
2016-04-01gpio: Add support for Qualcomm PM8916 gpiosMateusz Kulikowski
2016-04-01pmic: Add support for Qualcomm PM8916 PMICMateusz Kulikowski
2016-04-01drivers: spmi: Add support for Qualcomm SPMI bus driverMateusz Kulikowski
2016-04-01spmi: Add sandbox test driverMateusz Kulikowski
2016-04-01drivers: Add SPMI bus uclassMateusz Kulikowski
2016-04-01ehci: Add support for Qualcomm EHCIMateusz Kulikowski
2016-04-01ehci-ci.h: drop generic USBCMD fieldsMateusz Kulikowski
2016-04-01usb: ehci-ci: Add missing registers.Mateusz Kulikowski
2016-04-01usb: Rename ehci-fsl.h to ehci-ci.hMateusz Kulikowski
2016-04-01eth: asix88179: Print packet length properlyMateusz Kulikowski
2016-04-01usb: ulpi: Fix compile warning in read/write on 64-bit machines.Mateusz Kulikowski
2016-04-01usb: ulpi: Fix viewport_addr typeMateusz Kulikowski
2016-04-01Migrate CONFIG_ULPI* to KconfigMateusz Kulikowski
2016-04-01usb: ulpi: Add Kconfig options for ULPIMateusz Kulikowski
2016-04-01ehci-hcd: Add init_after_resetMateusz Kulikowski
2016-04-01mmc: Add support for Qualcomm SDHCI controllerMateusz Kulikowski
2016-04-01gpio: Add support for Qualcomm gpio controllerMateusz Kulikowski
2016-04-01serial: Add support for Qualcomm serial portMateusz Kulikowski
2016-04-01board: ti: DRA7: Add DP83867 TI phy for rev cDan Murphy
2016-04-01efi_loader: Always allocate the highest available addressAlexander Graf
2016-04-01sniper: Change vendor name from lge to lg, matching devicetree vendor prefixPaul Kocialkowski
2016-04-01kc1: Proper reboot mode and boot reason validationPaul Kocialkowski
2016-04-01sniper: Proper reboot mode and boot reason validationPaul Kocialkowski
2016-04-01kc1: Add some sysboot and devicetree-related environment variablesPaul Kocialkowski
2016-04-01kc1: Select libfdt to allow running devicetree-based kernelsPaul Kocialkowski