summaryrefslogtreecommitdiff
AgeCommit message (Collapse)Author
2007-11-17Unify pixis_reset altbank across board familiesJason Jin
Basically, refactor the CFG_PIXIS_VBOOT_MASK values into the separate board config files. Signed-off-by: Jason Jin <Jason.jin@freescale.com> Signed-off-by: Jon Loeliger <jdl@freescale.com>
2007-11-17Merge branch 'master' of /home/wd/git/u-boot/workWolfgang Denk
2007-11-17Fix warning: pointer targets in assignment differ in signednessJean-Christophe PLAGNIOL-VILLARD
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
2007-11-16Fix warning differ in signedness in common/cmd_ide.cJean-Christophe PLAGNIOL-VILLARD
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
2007-11-16Merge branch 'master' of git://www.denx.de/git/u-boot-netWolfgang Denk
2007-11-16ppc4xx: Enable 405EX PCIe UTL register configurationStefan Roese
Till now the UTL registers on 405EX were not initialized but left with their default values. This patch new initializes some of the UTL registers on 405EX. Signed-off-by: Stefan Roese <sr@denx.de>
2007-11-16ppc4xx: Update AMCC Makalu for board rev 1.1Stefan Roese
This patch adds changes needed for Makalu rev 1.1: - Enable 2nd DDR2 bank resulting in 256MByte of SDRAM - Enable 2nd ethernet port EMAC1 - Use generic GPIO configuration framework (CFG_4xx_GPIO_TABLE) - Reset PCIe ports via GPIO upon bootup Signed-off-by: Stefan Roese <sr@denx.de>
2007-11-15Group PCI and PCMCIA drivers in drivers/MakefileGrant Likely
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
2007-11-15Group block/flash drivers in drivers/MakefileGrant Likely
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
2007-11-15Group USB drivers in drivers/MakefileGrant Likely
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
2007-11-15Group i2c drivers in drivers/MakefileGrant Likely
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
2007-11-15Group console drivers in drivers/MakefileGrant Likely
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
2007-11-15Group network drivers in drivers/MakefileGrant Likely
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
2007-11-15Build: split COBJS value into multiple linesGrant Likely
This change is in preparation for condtitionial compile support in the build system. By spliting them all into seperate lines now, subsequent patches that change 'COBJS-y += ' into 'COBJS-$(CONFIG_<blah>) += ' will be less invasive and easier to review Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
2007-11-15Add .gitignore filesGrant Likely
Signed-off-by: Grant Likely <grant.likely@secretlab.ca> Acked-by: Kim Phillips <kim.phillips@freescale.com>
2007-11-15Revert "Correct relocation fixup for mpc5xx"Grant Likely
This reverts commit 3649cd99ba815b6601868735765602f00ef3692b. Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
2007-11-15Revert "Correct fixup relocation for MPC5xxx"Grant Likely
This reverts commit 6f7576b20ecf0d040c3ac3b032b5cbc860e38a90. Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
2007-11-15Revert "Correct fixup relocation for mpc8220"Grant Likely
This reverts commit a85dd254c0577fca13627c46e93fc2ad4c4f1f00. Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
2007-11-15Revert "Correct fixup relocation for mpc824x"Grant Likely
This reverts commit f3a52fe05923935db86985daf9438e2f70ac39aa. Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
2007-11-15Revert "Correct fixup relocation for mpc8260"Grant Likely
This reverts commit 5af61b2f4b838a05f79be274f3e5a66edd2d9c96. Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
2007-11-15Revert "Correct fixup relocation for mpc83xx"Grant Likely
This reverts commit 057004f4a4863554d56cc56268bfa7c7d9738e27. Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
2007-11-15Revert "[MPC512x] Correct fixup relocation"Grant Likely
This reverts commit 8d17979d0359492a822a0a409d26e3a3549b4cd4. Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
2007-11-15ppc4xx: Small AMCC Kilauea cleanupStefan Roese
Remove not needed pci_target_init() function. Signed-off-by: Stefan Roese <sr@denx.de>
2007-11-15ppc4xx: Enable 440 GPIO init table CFG_440_GPIO_TABLE for 405 platformsStefan Roese
- Rename CFG_440_GPIO_TABLE to CFG_4xx_GPIO_TABLE - Cleanup of the 4xx GPIO functions - Move some GPIO defines from the cpu headers ppc405.h/ppc440.h into gpio.h Signed-off-by: Stefan Roese <sr@denx.de>
2007-11-15ppc4xx: AMCC Taihu board config file cleanupStefan Roese
This patch makes the AMCC Taihu a little more compatible to the other AMCC eval boards. Signed-off-by: Stefan Roese <sr@denx.de>
2007-11-13ppc4xx: lwmon5: Change PHY reset sequence for PHY MDIO address latchingStefan Roese
Signed-off-by: Stefan Roese <sr@denx.de>
2007-11-13Merge branch 'master' of git://www.denx.de/git/u-bootStefan Roese
2007-11-13ppc4xx: Fix 405EX PCIe UTLSET register setupStefan Roese
Signed-off-by: Stefan Roese <sr@denx.de>
2007-11-13[UC101] SRAM now with 2 MB working.Heiko Schocher
Signed-off-by: Heiko Schocher <hs@denx.de>
2007-11-09ppc4xx: Use generic usb-ohci driver for sequoia boardMatthias Fuchs
This patch makes the sequoia board use the generic usb-ohci driver instead of cpu/ppc4xx/usb_ohci.c. Signed-off-by: Matthias Fuchs <matthias.fuchs@esd-electronics.com> Signed-off-by: Stefan Roese <sr@denx.de>
2007-11-09ppc4xx: Make USB working with CONFIG_4xx_DCACHE definedMatthias Fuchs
This patch disables the 44x d-cache on 'usb start' and reenables it on 'usb stop'. This should be seen as a temporary fix until the generic usb-ohci driver can life with d-cache enabled. Signed-off-by: Matthias Fuchs <matthias.fuchs@esd-electronics.com> Signed-off-by: Stefan Roese <sr@denx.de>
2007-11-09ppc4xx: Remove redundant code from 4xx network driverMatthias Fuchs
This patch removes some redundant code and decrements the end address of cache flush and invalidate by 1. Signed-off-by: Matthias Fuchs <matthias.fuchs@esd-electronics.com> Signed-off-by: Stefan Roese <sr@denx.de>
2007-11-09ppc4xx: Remove In:/Out:/Err: boot output for AMCC KilaueaStefan Roese
Signed-off-by: Stefan Roese <sr@denx.de>
2007-11-09ppc4xx: Make output a little shorter on I2C bootrom detectionStefan Roese
Most 4xx PPC capable of using an I2C bootrom for bootstrap setting already print a line with the information which I2C bootrom is used for bootstrap configuration. So we don't need this extra line with "I2C boot EEPROM en-/dis-abled". This patch also has a little code cleanup integrated. Signed-off-by: Stefan Roese <sr@denx.de>
2007-11-08ColdFire: MCF5329 - Remove reset registers from CCMTsiChungLiew
Signed-off-by: TsiChungLiew <Tsi-Chung.Liew@freescale.com>
2007-11-08ColdFire: MCF5329 - Add Reset structure to immap_5329.hTsiChungLiew
Signed-off-by: TsiChungLiew <Tsi-Chung.Liew@freescale.com>
2007-11-08ColdFire: MCF5329 - revert include/asm-m68k/m5329.h file modeTsiChungLiew
Signed-off-by: TsiChungLiew <Tsi-Chung.Liew@freescale.com>
2007-11-07ColdFire: MCF5445x - Update correct RAMBAR and missing linker filesTsiChungLiew
Signed-off-by: TsiChungLiew <Tsi-Chung.Liew@freescale.com>
2007-11-07ColdFire: MCF532x - Update do_reset() using core resetTsiChungLiew
Signed-off-by: TsiChungLiew <Tsi-Chung.Liew@freescale.com>
2007-11-07ColdFire: Update cpu flag for 4.2-xx compilerTsiChungLiew
Signed-off-by: TsiChungLiew <Tsi-Chung.Liew@freescale.com>
2007-11-06Implement general ULi 526x Ethernet driver support in U-bootRoy Zang
This patch implements general ULi 526x Ethernet driver. Until now, it is the only native Ethernet port on MPC8610HPCD board, but it could be used on other boards with ULi 526x Ethernet port as well. Signed-off-by: Roy Zang <tie-fei.zang@freescale.com> Signed-off-by: Zhang Wei <wei.zhang@freescale.com> Acked-by: Jon Loeliger <jdl@freescale.com> Signed-off-by: Ben Warren <bwarren@qstreams.com>
2007-11-06NET: Add Ethernet 1000BASE-X support for PPC4xxLarry Johnson
This patch adds support for 1000BASE-X to functions "miiphy_speed ()" and "miiphy_duplex()". It also adds function "miiphy_is_1000base_x ()", which returns non-zero iff the PHY registers are configured for 1000BASE-X. The "mii info" command is modified to distinguish between 1000BASE-T and -X. Signed-off-by: Larry Johnson <lrj@acm.org> Signed-off-by: Ben Warren <bwarren@qstreams.com>
2007-11-06NET: Cosmetic changesLarry Johnson
Signed-off-by: Larry Johnson <lrj@acm.org> Signed-off-by: Ben Warren <bwarren@qstreams.com>
2007-11-06Merge git://www.denx.de/git/u-bootBen Warren
2007-11-05ppc4xx: Make output a little shorter on PCIe detectionStefan Roese
Now not max 3 lines but 2 lines are printed per PCIe port. Signed-off-by: Stefan Roese <sr@denx.de>
2007-11-03Cleanup coding style; update CHANGELOGWolfgang Denk
Signed-off-by: Wolfgang Denk <wd@denx.de>
2007-11-03fix wording in READMEBruce Adler
Changed the wording to properly describe the shadowing of the environment from ROM to RAM Signed-off-by: Bruce Adler <bruce.adler@acm.org>
2007-11-03blackfin: Move `-D__BLACKFIN__' to $(ARCH)_config.mkShinya Kuribayashi
Signed-off-by: Shinya Kuribayashi <skuribay@ruby.dti.ne.jp>
2007-11-03Trimmed some variables in ne2000.cVlad Lungu
Signed-off-by: Vlad Lungu <vlad@comsys.ro>
2007-11-03Fix the issue of usb_kbd driver missing the scan code of key 'z'.Zhang Wei
The scan code of the key 'z' is 0x1d, which should be handled. The change has be tested on NOVATEK USB keyboard and ULI PCI OHCI controller. Signed-off-by: Zhang Wei <wei.zhang@freescale.com>
generated by cgit (git 2.34.1) at 2025-01-18 01:31:49 +0000