summaryrefslogtreecommitdiff
path: root/arch/arm/dts/zynqmp-zcu216-revA.dts
AgeCommit message (Collapse)Author
2020-08-20xilinx: Fix xlnx,mio_bank propertyMichal Simek
s/xlnx,mio_bank/xlnx,mio-bank/g DT binding is describing mio-bank not mio_bank that's why fix all DTSes and also driver itself. Signed-off-by: Michal Simek <michal.simek@xilinx.com> Acked-by: Peng Fan <peng.fan@nxp.com>
2020-04-27arm64: zynqmp: Fix irps5401 device nodesMichal Simek
- Do not use irps54012 as device node which is not correct. - Fix addresses of irps5401/u180 on zcu104 revisions. - Remove clock-cells property. It is PMIC without any clock output. - Define irps5401 nodes in zynqmp-e-a2197 Signed-off-by: Michal Simek <michal.simek@xilinx.com>
2020-04-06arm64: zynqmp: Add 'no-1-8-v' property for ZynqMP BoardsManish Narani
Modify dts files to add 'no-1-8-v' property for all the ZynqMP boards. User can remove this property to enable the UHS mode. This is to keep the same speed (HS) modes across all the stages of the Linux Boot. Due to power cycling limitation of some of the ZynqMP boards, some SD cards don't get power cycled and are failing in Linux. Signed-off-by: Manish Narani <manish.narani@xilinx.com>
2020-04-06arm64: zynqmp: Update Copyright years to 2020Michal Simek
Trivial change. Signed-off-by: Michal Simek <michal.simek@xilinx.com>
2020-04-06arm64: zynqmp: Replace gpio-key,wakeup with wakeup sourceMichal Simek
The same change has been done for Zynq by commit 1241c72b6db1 ("ARM: dts: zynq: replace gpio-key,wakeup with wakeup-source property") in mainline Linux kernel. Signed-off-by: Michal Simek <michal.simek@xilinx.com>
2020-01-14arm64: zynqmp: Correct the type of eeprom for zcu216 boardsRaviteja Narayanam
Corrected the type of eeprom in device tree for zcu216 boards according to schematic. Signed-off-by: Raviteja Narayanam <raviteja.narayanam@xilinx.com> Signed-off-by: Michal Simek <michal.simek@xilinx.com>
2020-01-14arm64: zynqmp: Fix ina226 shunt resistor valueMichal Simek
Fix shunt resistor value for ina226 vccint_ams and vccint_io_bram_ps. 2mOhm shunt was only in early board revision schematics but never got to real revA board. Signed-off-by: Michal Simek <michal.simek@xilinx.com>
2019-10-24arm64: zynqmp: Add support for zcu216Michal Simek
zcu104/6 defconfig was used as source. Standard features are enabled. Signed-off-by: Michal Simek <michal.simek@xilinx.com>