uboot-2021-rebase.git - uboot 2021 rebase, to fix booting on modern SD cards, from https://github.com/fifteenhex/u-boot/tree/am335x_som

Age	Commit message (Collapse)	Author
2011-04-08	Blackfin: bf518f-ezbrd: get MAC from flash	Mike Frysinger
	The MAC address is stored in the last flash sector rather than OTP. Signed-off-by: Mike Frysinger <vapier@gentoo.org>
2011-04-08	Blackfin: bf518f-ezbrd: don't require SPI logic all the time	Mike Frysinger
	Only the first run of boards had a ksz switch on it, so if building for a newer silicon rev or SPI is disabled, don't bother checking for the ksz. Signed-off-by: Mike Frysinger <vapier@gentoo.org>
2010-07-13	Blackfin: bf518f-ezbrd: convert to portmux framework	Mike Frysinger
	Rather than bang MMRs directly, use the new portmux framework to handle the details. Signed-off-by: Mike Frysinger <vapier@gentoo.org>
2010-07-13	Blackfin: bf518f-ezbrd: handle different PHYs dynamically	Mike Frysinger
	The original BF518F-EZBRD's have a Micrel KSZ8893 DSA on them, but newer ones only have a National PHY (which lack a RX Error interrupt line). So in the board eth init code, dynamically detect what is hooked up to the MAC and handle each accordingly. Signed-off-by: Mike Frysinger <vapier@gentoo.org>
2010-01-17	Blackfin: convert bfin_sdh to generic mmc	Cliff Cai
	Signed-off-by: Cliff Cai <cliff.cai@analog.com> Signed-off-by: Mike Frysinger <vapier@gentoo.org>
2010-01-17	Blackfin: kill off useless initdram() usage	Mike Frysinger
	While the initdram() function makes sense on some arches, it doesn't for Blackfin systems as it's always implemented the same way. Signed-off-by: Mike Frysinger <vapier@gentoo.org>
2009-05-25	Blackfin: bf518f-ezbrd: setup portmux for async flash	Graf Yang
	The pins for async memory where parallel flash lives are not enabled by default, so make sure we mux them as needed. Signed-off-by: Graf Yang <graf.yang@analog.com> Signed-off-by: Mike Frysinger <vapier@gentoo.org>
2009-05-15	Minor Coding Style fix; update CHANGELOG.	Wolfgang Denk
	Signed-off-by: Wolfgang Denk <wd@denx.de>
2009-05-06	Blackfin: bf518f-ezbrd: reset ethernet PHY during init	Graf Yang
	We don't know what state the ethernet PHY is in when starting up, so make sure we set it to a sane state. This fixes troubles seen when Linux boots up, configures the PHY is a non-default state, and then the system reboots into U-Boot which previously expected a reset state only. Signed-off-by: Graf Yang <graf.yang@analog.com> Signed-off-by: Mike Frysinger <vapier@gentoo.org>
2009-04-02	Blackfin: bf518f-ezbrd: new board port	Mike Frysinger
	Signed-off-by: Mike Frysinger <vapier@gentoo.org>