| Age | Commit message (Collapse) | Author |
|---|
|
|
|
|
|
Signed-off-by: Jon Loeliger <jdl@freescale.com>
|
|
|
|
It is no longer linked into U-Boot; its sources are
now located in the kernel tree.
Signed-off-by: Jon Loeliger <jdl@freescale.com>
|
|
Signed-off-by: John Traill <john.traill@freescale.com>
|
|
|
|
|
|
The changes works in with kernel irq mapping rework.
Signed-off-by: Zhang Wei <wei.zhang@freescale.com>
|
|
Added code for reading and writing Mac addresses to/from ID EEPROM(0x57).
With attached patch, we can use command "mac/mac read/mac save/"
to read and write EEPROM under u-boot prompt.
U-boot will calculate the checksum of EEPROM while bootup,
if it is right, then u-boot will check whether the mac address
of eTSEC0/1/2/3 is availalbe (non-zero).
If there is mac address availabe in EEPROM, u-boot will use it,
otherewise, u-boot will use the mac address defined in
MPC8641HPCN.h. This matches the requirement to set unique mac address
for each TSEC port.
Signed-off-by: Haiying Wang <haiying.wang@freescale.com>
Signed-off-by: York Sun <yorksun@freescale.com>
|
|
Signed-off-by: Haiying Wang <haiying.wang@freescale.com>
Acked-by: Jon Loeliger <jdl@freescale.com>
|
|
|
|
Signed-off-by: Jon Loeliger <jdl@jdl.com>
|
|
|
|
Signed-off-by: Jon Loeliger <jdl@freescale.com>
|
|
Some 80-column cleanups.
Convert printf() to puts() where possible.
Use #include "spd_sdram.h" as needed.
Enhanced reset command usage message a bit.
Signed-off-by: Jon Loeliger <jdl@freescale.com>
|
|
Signed-off-by: Jon Loeliger <jdl@freescale.com>
|
|
Signed-off-by: Jon Loeliger <jdl@freescale.com>
|
|
First cut at moving the PIXIS platform code out of
the 86xx cpu directory and into board/mpc8641hpcn
where it belongs.
Signed-off-by: Jon Loeliger <jdl@freescale.com>
|
|
Updated ethernet interrupt mappings (moved up 48).
Cleaned up a few comments.
Signed-off-by: Jon Loeliger <jdl@jdl.com>
|
|
|
|
|
|
|
|
Correctly tracks r29 as global data pointer now.
Signed-off-by: Haiying Wang <Haiying.Wang@freescale.com>
|
|
|
|
Enable the CFI driver.
Remove bogus LAWBAR7 cruft.
Use correct TEXT_BASE, Fixup load script.
Enable SPD EEPROM during DDR setup.
Use generic RFC 1918 IP addresses by default.
|
|
Removed //-style comments.
Use 80-column lines.
Remove trailing whitespace.
Remove dead code and debug cruft.
|
|
|
