uboot-2021-rebase.git - uboot 2021 rebase, to fix booting on modern SD cards, from https://github.com/fifteenhex/u-boot/tree/am335x_som

Age	Commit message (Collapse)	Author
2015-09-11	corvus, dfu: add dfu support	Heiko Schocher
	add support for DFU on the corvus board. Signed-off-by: Heiko Schocher <hs@denx.de>
2015-09-11	at91: corvus: board updates	Heiko Schocher
	- rename at91_spl_board_init into spl_board_init - use SZ_1X defines for sizes Signed-off-by: Heiko Schocher <hs@denx.de>
2015-08-21	arm: at91: pmc: replace the constant with a define in at91_pmc.h	Erik van Luijk
	To enable the clocks on the at91 boards a constant (0x4) is used. This is replaced with a define in at91_pmc.h (1 << 2). Signed-off-by: Erik van Luijk <evanluijk@interact.nl> Reviewed-by: Andreas Bießmann <andreas.devel@googlemail.com>
2015-08-21	arm: at91: at91sam9m10g45ek/corvus remove useless chip select 1 init	Erik van Luijk
	On these boards the DDR is connected to a dedicated controller and not to chip select 1 of the EBI. Signed-off-by: Erik van Luijk <evanluijk@interact.nl> Tested-by: Erik van Luijk <evanluijk@interact.nl>
2015-08-21	arm: at91: mpddr: allow multiple DDR controllers	Erik van Luijk
	The mpddr.c depends on ATMEL_BASE_MPDDRC for the base address to configure the controller. This cannot be used when there is more than one controller (i.e. AT91SAM9G45, AT91SAM9M10). Signed-off-by: Erik van Luijk <evanluijk@interact.nl> [remove 'new blank line at EOF'] Signed-off-by: Andreas Bießmann <andreas.devel@googlemail.com>
2015-01-19	arm, at91: corvus board updates	Heiko Schocher
	- corvus board fix problems with toshiba nand chips on the corvus board problems with toshiba chips Manufacturer ID: 0x98 Chip ID: 0xdc encounterd. Solve this in the following way: - set other nand timings - enable CONFIG_SYS_NAND_READY_PIN - correct the MACH_TYPE setting Signed-off-by: Heiko Schocher <hs@denx.de>
2014-11-17	arm, spl, at91: add spl support for the corvus board	Heiko Schocher
	replaces the at91bootstrap code with SPL code. make the spl image with: ./tools/mkimage -T atmelimage -d spl/u-boot-spl.bin spl/boot.bin this writes the length of the spl image into the 6th execption vector. This is needed from the ROM bootloader. Signed-off-by: Heiko Schocher <hs@denx.de> Reviewed-by: Bo Shen <voice.shen@atmel.com> Reviewed-by: Andreas Bießmann <andreas.devel@googlemail.com> Signed-off-by: Andreas Bießmann <andreas.devel@googlemail.com>
2013-12-09	arm, at91: add siemens corvus board	Heiko Schocher
	enable support for the siemens AT91SAM9G20 based board corvus. Signed-off-by: Boris Schmidt <boris.schmidt@siemens.com> Reviewed-by: Heiko Schocher <hs@denx.de> Cc: Andreas Bießmann <andreas.devel@googlemail.com> Cc: Bo Shen <voice.shen@atmel.com> Signed-off-by: Andreas Bießmann <andreas.devel@googlemail.com>