From 0f3e2942c9e01b5dfc01f3dabe0e2f2ab8fd8b84 Mon Sep 17 00:00:00 2001 From: Soeren Moch Date: Thu, 27 Aug 2020 21:52:46 +0200 Subject: board: tbs2910: Use recommended distroboot addresses According to doc/README.distro fdt_addr must not be set when DTB is not available from hardware. So remove this entry. Use address 32MB above the start of DRAM for kernel_addr_r. This way we likely can avoid the self-relocation of the compressed kernel image before it decompresses to offset 0x8000 from start of DRAM. Use address 128MB above the start of DRAM for fdt_addr_r, since this is the maximum location for the end of the kernel. So we avoid overwriting the DTB. Use 512k above that for ramdisk_addr_r. This should be enough for the DTB, rest of DRAM can be used for initrd. Place boot script / extlinux.conf at offset 0 / 1MB from start of DRAM. This space is available for processing in U-Boot. Signed-off-by: Soeren Moch Reviewed-by: Fabio Estevam Reviewed-by: Tom Rini --- include/configs/tbs2910.h | 11 +++++------ 1 file changed, 5 insertions(+), 6 deletions(-) diff --git a/include/configs/tbs2910.h b/include/configs/tbs2910.h index 8092b9edfb..b05034945e 100644 --- a/include/configs/tbs2910.h +++ b/include/configs/tbs2910.h @@ -85,13 +85,12 @@ "bootm 0x10800000 0x10d00000\0" \ "console=ttymxc0\0" \ "fan=gpio set 92\0" \ - "fdt_addr=0x13000000\0" \ - "fdt_addr_r=0x13000000\0" \ + "fdt_addr_r=0x18000000\0" \ "fdtfile=" CONFIG_DEFAULT_FDT_FILE "\0" \ - "kernel_addr_r=0x10008000\0" \ - "pxefile_addr_r=0x10008000\0" \ - "ramdisk_addr_r=0x18000000\0" \ - "scriptaddr=0x14000000\0" \ + "kernel_addr_r=0x12000000\0" \ + "pxefile_addr_r=0x10100000\0" \ + "ramdisk_addr_r=0x18080000\0" \ + "scriptaddr=0x10000000\0" \ "set_con_serial=setenv stdout serial; " \ "setenv stderr serial\0" \ "set_con_hdmi=setenv stdout serial,vidconsole; " \ -- cgit