From fe450895ff1a828d39bfd09082000149f2c8d9c3 Mon Sep 17 00:00:00 2001 From: Kever Yang Date: Thu, 8 Jun 2017 15:32:04 +0800 Subject: rockchip: pinctrl: rk3328: use gpio instead of sdmmc-pwren SDMMC-PWREN is a pin to control voltage for SDMMC IO, it may be high active or low active, the dwmmc driver always assume the sdmmc-pwren as high active. Kernel treat this pin as fixed regulator instead of a pin from controller, and then it can set in dts file upon board schematic, that's a good solution, we can also do this in u-boot. Signed-off-by: Kever Yang Acked-by: Simon Glass Acked-by: Philipp Tomsich Reviewed-by: Philipp Tomsich --- drivers/pinctrl/rockchip/pinctrl_rk3328.c | 6 ++---- 1 file changed, 2 insertions(+), 4 deletions(-) diff --git a/drivers/pinctrl/rockchip/pinctrl_rk3328.c b/drivers/pinctrl/rockchip/pinctrl_rk3328.c index efa5b3105c..c74163e026 100644 --- a/drivers/pinctrl/rockchip/pinctrl_rk3328.c +++ b/drivers/pinctrl/rockchip/pinctrl_rk3328.c @@ -184,13 +184,11 @@ static void pinctrl_rk3328_sdmmc_config(struct rk3328_grf_regs *grf, if (com_iomux & IOMUX_SEL_SDMMC_MASK) rk_clrsetreg(&grf->gpio0d_iomux, GPIO0D6_SEL_MASK, - GPIO0D6_SDMMC0_PWRENM1 - << GPIO0D6_SEL_SHIFT); + GPIO0D6_GPIO << GPIO0D6_SEL_SHIFT); else rk_clrsetreg(&grf->gpio2a_iomux, GPIO2A7_SEL_MASK, - GPIO2A7_SDMMC0_PWRENM0 - << GPIO2A7_SEL_SHIFT); + GPIO2A7_GPIO << GPIO2A7_SEL_SHIFT); rk_clrsetreg(&grf->gpio1a_iomux, GPIO1A0_SEL_MASK, GPIO1A0_CARD_DATA_CLK_CMD_DETN -- cgit