From dbc000bfb51eb30d786521e6b8e29048c36cbefa Mon Sep 17 00:00:00 2001 From: Tom Warren Date: Thu, 23 May 2013 12:26:18 +0000 Subject: ARM: tegra: only enable SCU on Tegra20 The non-SPL build of U-Boot on Tegra only runs on a single CPU, and hence there is no need to enable the SCU when running U-Boot. If an SMP OS is booted, and it needs the SCU enabled, it will enable the SCU itself. U-Boot doing so is redundant. The one exception is Tegra20, where an enabled SCU is required for some aspects of PCIe to work correctly. Some Tegra SoCs contain CPUs without a software-controlled SCU. In this case, attempting to turn it on actively causes problems. This is the case for Tegra114. For example, when running Linux, the first (or at least some very early) user-space process will trigger the following kernel message: Unhandled fault: imprecise external abort (0x406) at 0x00000000 This is typically accompanied by that process receving a fatal signal, and exiting. Since this process is usually pid 1, this causes total system boot failure. Signed-off-by: Tom Warren [swarren, fleshed out description, ported to upstream chipid APIs] Signed-off-by: Stephen Warren Signed-off-by: Tom Warren --- arch/arm/cpu/tegra-common/ap.c | 4 ++++ 1 file changed, 4 insertions(+) (limited to 'arch/arm/cpu/tegra-common/ap.c') diff --git a/arch/arm/cpu/tegra-common/ap.c b/arch/arm/cpu/tegra-common/ap.c index e099683890..9e6d51dd12 100644 --- a/arch/arm/cpu/tegra-common/ap.c +++ b/arch/arm/cpu/tegra-common/ap.c @@ -109,6 +109,10 @@ static void enable_scu(void) struct scu_ctlr *scu = (struct scu_ctlr *)NV_PA_ARM_PERIPHBASE; u32 reg; + /* Only enable the SCU on T20/T25 */ + if (tegra_get_chip() != CHIPID_TEGRA20) + return; + /* If SCU already setup/enabled, return */ if (readl(&scu->scu_ctrl) & SCU_CTRL_ENABLE) return; -- cgit