From d239d9d9464f7eb3a9ae1d3b45865149a758b501 Mon Sep 17 00:00:00 2001 From: Peng Fan Date: Mon, 16 Sep 2019 03:09:55 +0000 Subject: imx: add i.MX8MN DDR4 board support Support pinctrl/clk/sdhc, include ddr4 timing data. Log: U-Boot SPL 2019.10-rc3-00356-g497c500423-dirty (Sep 16 2019 - 10:54:58 +0800) Normal Boot Trying to boot from BOOTROM image offset 0x8000, pagesize 0x200, ivt offset 0x0 U-Boot 2019.10-rc3-00356-g497c500423-dirty (Sep 16 2019 - 10:54:58 +0800) CPU: Freescale i.MX8MNano rev1.0 at 24 MHz Reset cause: POR Model: NXP i.MX8MNano DDR4 EVK board DRAM: 2 GiB MMC: FSL_SDHC: 1, FSL_SDHC: 2 Loading Environment from MMC... *** Warning - bad CRC, using default environment In: serial Out: serial Err: serial Net: No ethernet found. Hit any key to stop autoboot: 0 Signed-off-by: Peng Fan --- arch/arm/mach-imx/imx8m/Kconfig | 7 +++++++ 1 file changed, 7 insertions(+) (limited to 'arch/arm/mach-imx') diff --git a/arch/arm/mach-imx/imx8m/Kconfig b/arch/arm/mach-imx/imx8m/Kconfig index b0932f1647..eb4a73b3e2 100644 --- a/arch/arm/mach-imx/imx8m/Kconfig +++ b/arch/arm/mach-imx/imx8m/Kconfig @@ -34,9 +34,16 @@ config TARGET_IMX8MM_EVK select SUPPORT_SPL select IMX8M_LPDDR4 +config TARGET_IMX8MN_EVK + bool "imx8mn DDR4 EVK board" + select IMX8MN + select SUPPORT_SPL + select IMX8M_DDR4 + endchoice source "board/freescale/imx8mq_evk/Kconfig" source "board/freescale/imx8mm_evk/Kconfig" +source "board/freescale/imx8mn_evk/Kconfig" endif -- cgit