From ada4697d0230d6da552867777f98a67ec3ba2579 Mon Sep 17 00:00:00 2001 From: Jeffrey Mann Date: Wed, 16 May 2007 13:23:10 +0200 Subject: [PATCH] Run new sequoia boards with an EBC speed of 83MHz Because the Sequoia board does not boot with an EBC faster than 66MHz, the clock divider are changed after the initial boot process. This allows for maximum clocking speeds to be achieved on newer boards. Sequoia boards with 666.66 MHz processors require that the EBC divider be set to 3 in order to start the initial boot process at a slower EBC speed. After the initial boot process, the divider can be set back to 2, which will cause the boards to run at 83.333MHz. This is backward compatible with boards with 533.33 MHz processors, as these boards will already be set with an EBC divider of 2. Signed-off-by: Jeffrey Mann --- board/amcc/sequoia/sequoia.c | 10 ++++++++-- 1 file changed, 8 insertions(+), 2 deletions(-) (limited to 'board/amcc/sequoia') diff --git a/board/amcc/sequoia/sequoia.c b/board/amcc/sequoia/sequoia.c index 930fa71cb9..870401458e 100644 --- a/board/amcc/sequoia/sequoia.c +++ b/board/amcc/sequoia/sequoia.c @@ -132,6 +132,12 @@ int board_early_init_f(void) (0x80000000 >> (28 + CFG_NAND_CS)); mtsdr(SDR0_CUST0, sdr0_cust0); + /* Update EBC speed after booting from i2c bootstrap settings + * on newer boards with 33.333 MHZ Clocks + */ + if (in8(CFG_BCSR_BASE + 3) & 0x80) + mtcpr(0xe0, 0x02000000); + return 0; } @@ -363,8 +369,8 @@ int checkboard(void) printf("Board: Rainier - AMCC PPC440GRx Evaluation Board"); #endif - rev = *(u8 *)(CFG_BCSR_BASE + 0); - val = *(u8 *)(CFG_BCSR_BASE + 5) & 0x01; + rev = in8(CFG_BCSR_BASE + 0); + val = in8(CFG_BCSR_BASE + 5) & 0x01; printf(", Rev. %X, PCI=%d MHz", rev, val ? 66 : 33); if (s != NULL) { -- cgit