From 6e75cb237d6398254c62ded0d27a30c9c59438b1 Mon Sep 17 00:00:00 2001 From: Ludwig Zenz Date: Mon, 1 Jul 2019 09:42:09 +0200 Subject: ARM: imx6: DHCOM i.MX6 PDK: enable pad pull ups of SS lines of spi used for boot It turned out that after a reset the boot process from the spi bootflash is disturbed by other spi slave devices connected to DHCOM SPI1, which uses the same spi interface with a different SS line. Therefore the pad pull ups are enabled. Signed-off-by: Ludwig Zenz --- board/dhelectronics/dh_imx6/dh_imx6_spl.c | 9 +++++++-- 1 file changed, 7 insertions(+), 2 deletions(-) (limited to 'board/dhelectronics') diff --git a/board/dhelectronics/dh_imx6/dh_imx6_spl.c b/board/dhelectronics/dh_imx6/dh_imx6_spl.c index b492961042..1b7acc8df7 100644 --- a/board/dhelectronics/dh_imx6/dh_imx6_spl.c +++ b/board/dhelectronics/dh_imx6/dh_imx6_spl.c @@ -440,8 +440,13 @@ static void setup_iomux_sd(void) /* SPI */ static iomux_v3_cfg_t const ecspi1_pads[] = { - /* SS0 */ - IOMUX_PADS(PAD_EIM_EB2__GPIO2_IO30 | MUX_PAD_CTRL(SPI_PAD_CTRL)), + /* SS0 - SS of boot flash */ + IOMUX_PADS(PAD_EIM_EB2__GPIO2_IO30 | + MUX_PAD_CTRL(SPI_PAD_CTRL | PAD_CTL_PUS_100K_UP)), + /* SS2 - SS of DHCOM SPI1 */ + IOMUX_PADS(PAD_KEY_ROW2__GPIO4_IO11 | + MUX_PAD_CTRL(SPI_PAD_CTRL | PAD_CTL_PUS_100K_UP)), + IOMUX_PADS(PAD_EIM_D17__ECSPI1_MISO | MUX_PAD_CTRL(SPI_PAD_CTRL)), IOMUX_PADS(PAD_EIM_D18__ECSPI1_MOSI | MUX_PAD_CTRL(SPI_PAD_CTRL)), IOMUX_PADS(PAD_EIM_D16__ECSPI1_SCLK | MUX_PAD_CTRL(SPI_PAD_CTRL)), -- cgit