From 86ac7a9a5d0c8ae9f0e5e6ef2cc189198e498cf4 Mon Sep 17 00:00:00 2001 From: Peng Fan Date: Tue, 20 Nov 2018 10:20:00 +0000 Subject: imx: add i.MX8MQ EVK support Add i.MX8MQ EVK support. SPL will initialize ddr and load ddr phy firmware. Then loading FIT image, ATF to OCRAM, U-Boot and DTB to DRAM. The boot log with Arm trusted firmware console enabled: " U-Boot SPL 2018.11-00142-g9ae14e7274 (Nov 20 2018 - 18:13:16 +0800) PMIC: PFUZE100 ID=0x10 Normal Boot Trying to boot from MMC2 NOTICE: Configureing TZASC380 NOTICE: BL31: v1.5(release):p9.0.0_1.0.0-beta-20180928-8-ge09c4b62-dirty NOTICE: BL31: Built : 09:28:54, Nov 8 2018 lpddr4 swffc start NOTICE: sip svc init U-Boot 2018.11-00142-g9ae14e7274 (Nov 20 2018 - 18:13:16 +0800) CPU: Freescale i.MX8MQ rev2.0 at 1000 MHz Reset cause: POR Model: Freescale i.MX8MQ EVK DRAM: 3 GiB MMC: FSL_SDHC: 0, FSL_SDHC: 1 In: serial Out: serial Err: serial Net: Warning: ethernet@30be0000 using MAC address from ROM eth0: ethernet@30be0000 Hit any key to stop autoboot: 0 " Signed-off-by: Peng Fan Cc: Fabio Estevam Cc: Stefano Babic --- board/freescale/imx8mq_evk/Kconfig | 12 ++++++++++++ 1 file changed, 12 insertions(+) create mode 100644 board/freescale/imx8mq_evk/Kconfig (limited to 'board/freescale/imx8mq_evk/Kconfig') diff --git a/board/freescale/imx8mq_evk/Kconfig b/board/freescale/imx8mq_evk/Kconfig new file mode 100644 index 0000000000..421b081c76 --- /dev/null +++ b/board/freescale/imx8mq_evk/Kconfig @@ -0,0 +1,12 @@ +if TARGET_IMX8MQ_EVK + +config SYS_BOARD + default "imx8mq_evk" + +config SYS_VENDOR + default "freescale" + +config SYS_CONFIG_NAME + default "imx8mq_evk" + +endif -- cgit