From c0efc3140e75e3ffd6127a5aec97b75347ec7417 Mon Sep 17 00:00:00 2001 From: Masahiro Yamada Date: Sat, 28 Jan 2017 06:53:53 +0900 Subject: ARM: uniphier: change CONFIG_SPL_PAD_TO to 128KB The Boot ROM supports authentication feature to prevent malformed software from being run on products. The signature is added at the tail of the second stage loader (= SPL in U-boot terminology). The size of the second stage loader was 64KB, and it was consistent across SoCs. The situation changed when LD20 SoC appeared; it loads 80KB second stage loader, and it is the only exception. Currently, CONFIG_SPL_PAD_TO is set to 64KB and U-Boot proper is loaded from the 64KB offset of non-volatile devices. This means the signature of LD20 SoC (located at 80KB offset) corrupts the U-Boot proper image. Let's move the U-Boot proper image to 128KB offset. It uses 48KB for nothing but padding, and we could actually locate the U-Boot proper at 80KB offset. However, the power of 2 generally seems a better choice for the offset address. Signed-off-by: Masahiro Yamada --- common/spl/Kconfig | 3 +-- 1 file changed, 1 insertion(+), 2 deletions(-) (limited to 'common/spl') diff --git a/common/spl/Kconfig b/common/spl/Kconfig index b1aa1483c9..b2ba492abd 100644 --- a/common/spl/Kconfig +++ b/common/spl/Kconfig @@ -86,9 +86,8 @@ config SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR depends on SPL && SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR default 0x50 if ARCH_SUNXI default 0x75 if ARCH_DAVINCI - default 0x80 if ARCH_UNIPHIER default 0x8a if ARCH_MX6 - default 0x100 if ARCH_ROCKCHIP + default 0x100 if ARCH_ROCKCHIP || ARCH_UNIPHIER default 0x140 if ARCH_MVEBU default 0x200 if ARCH_SOCFPGA || ARCH_AT91 default 0x300 if ARCH_ZYNQ || ARCH_KEYSTONE || OMAP34XX || OMAP44XX || \ -- cgit