From cfd6de9cf98ad1418edf96da970eac50f4fe6f0d Mon Sep 17 00:00:00 2001 From: Tom Rini Date: Fri, 27 Jun 2014 09:03:50 -0400 Subject: doc/README.falcon: Clarify steps slightly. Make it clear that we need to load a legacy-formatted (aka uImage) kernel into memory as well as the DT if used before using "spl export". Cc: Yebio Mesfin Signed-off-by: Tom Rini --- doc/README.falcon | 7 ++++--- 1 file changed, 4 insertions(+), 3 deletions(-) (limited to 'doc/README.falcon') diff --git a/doc/README.falcon b/doc/README.falcon index 82a254b2e2..e9f8a7583c 100644 --- a/doc/README.falcon +++ b/doc/README.falcon @@ -31,9 +31,10 @@ informed to load it before running the kernel. To boot the kernel, these steps under a Falcon-aware U-Boot are required: 1. Boot the board into U-Boot. -Use the "spl export" command to generate the kernel parameters area or the DT. -U-Boot runs as when it boots the kernel, but stops before passing the control -to the kernel. +After loading the desired legacy-format kernel image into memory (and DT as +well, if used), use the "spl export" command to generate the kernel parameters +area or the DT. U-Boot runs as when it boots the kernel, but stops before +passing the control to the kernel. 2. Save the prepared snapshot into persistent media. The address where to save it must be configured into board configuration -- cgit