From 4fadcaf097887d94c909fd924864f435c69c9182 Mon Sep 17 00:00:00 2001 From: Patrice Chotard Date: Wed, 9 Aug 2017 14:45:27 +0200 Subject: i2c: add i2c driver for stm32 Add i2c driver which can be used on both STM32F7 and STM32H7. This I2C block supports the following features: _ Slave and master modes _ Multimaster capability _ Standard-mode (up to 100 kHz) _ Fast-mode (up to 400 kHz) _ Fast-mode Plus (up to 1 MHz) _ 7-bit and 10-bit addressing mode _ Multiple 7-bit slave addresses (2 addresses, 1 with configurable mask) _ All 7-bit addresses acknowledge mode _ General call _ Programmable setup and hold times _ Easy to use event management _ Optional clock stretching _ Software reset Signed-off-by: Christophe Kerello Signed-off-by: Patrice Chotard Reviewed-by: Simon Glass --- doc/device-tree-bindings/i2c/i2c-stm32.txt | 30 ++++++++++++++++++++++++++++++ 1 file changed, 30 insertions(+) create mode 100644 doc/device-tree-bindings/i2c/i2c-stm32.txt (limited to 'doc/device-tree-bindings/i2c') diff --git a/doc/device-tree-bindings/i2c/i2c-stm32.txt b/doc/device-tree-bindings/i2c/i2c-stm32.txt new file mode 100644 index 0000000000..df03743ace --- /dev/null +++ b/doc/device-tree-bindings/i2c/i2c-stm32.txt @@ -0,0 +1,30 @@ +* I2C controller embedded in STMicroelectronis STM32 platforms + +Required properties : +- compatible : Must be "st,stm32f7-i2c" +- reg : Offset and length of the register set for the device +- resets: Must contain the phandle to the reset controller +- clocks: Must contain the input clock of the I2C instance +- A pinctrl state named "default" must be defined to set pins in mode of + operation for I2C transfer +- #address-cells = <1>; +- #size-cells = <0>; + +Optional properties : +- clock-frequency : Desired I2C bus clock frequency in Hz. If not specified, + the default 100 kHz frequency will be used. As only Normal, Fast and Fast+ + modes are implemented, possible values are 100000, 400000 and 1000000. + +Example : + + i2c1: i2c@40005400 { + compatible = "st,stm32f7-i2c"; + reg = <0x40005400 0x400>; + resets = <&rcc 181>; + clocks = <&clk_pclk1>; + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_i2c1>; + clock-frequency = <400000>; + #address-cells = <1>; + #size-cells = <0>; + }; -- cgit