From 22052c6236cbebc446ffd51ac69271fe063c654a Mon Sep 17 00:00:00 2001 From: Simon Glass Date: Mon, 7 Jul 2014 10:16:39 -0600 Subject: spi: Support half-duplex mode in FDT decode This parameter should also be supported. Signed-off-by: Simon Glass Tested-by: Ajay Kumar Reviewed-by: Jagannadha Sutradharudu Teki --- doc/device-tree-bindings/spi/spi-bus.txt | 2 ++ 1 file changed, 2 insertions(+) (limited to 'doc/device-tree-bindings') diff --git a/doc/device-tree-bindings/spi/spi-bus.txt b/doc/device-tree-bindings/spi/spi-bus.txt index 800dafe5b0..5c8720a820 100644 --- a/doc/device-tree-bindings/spi/spi-bus.txt +++ b/doc/device-tree-bindings/spi/spi-bus.txt @@ -59,6 +59,8 @@ contain the following properties. used for MOSI. Defaults to 1 if not present. - spi-rx-bus-width - (optional) The bus width(number of data wires) that used for MISO. Defaults to 1 if not present. +- spi-half-duplex - (optional) Indicates that the SPI bus should wait for + a header byte before reading data from the slave. Some SPI controllers and devices support Dual and Quad SPI transfer mode. It allows data in SPI system transfered in 2 wires(DUAL) or 4 wires(QUAD). -- cgit