From 09ce9921a7d8b1ce764656b14b42217bbf4faa38 Mon Sep 17 00:00:00 2001 From: Becky Bruce Date: Mon, 2 Feb 2009 16:34:51 -0600 Subject: flash/cfi_flash: Use virtual sector start address, not phys include/flash.h was commented to say that the address in flash_info->start was a physical address. However, from u-boot's point of view, and looking at most flash code, it makes more sense for this to be a virtual address. So I corrected the comment to indicate that this was a virtual address. The only flash driver that was actually treating the address as physical was the mtd/cfi_flash driver. However, this code was using it inconsistently as it actually directly dereferenced the "start" element, while it used map_physmem to get a virtual address in other places. I changed this driver so that the code which initializes the info->start field calls map_physmem to get a virtual address, eliminating the need for further map_physmem calls. The code is now consistent. The *only* place a physical address should be used is when defining the flash banks list that is used to initialize the flash_info struct, usually found in the board config file. Signed-off-by: Becky Bruce Signed-off-by: Stefan Roese --- drivers/mtd/cfi_flash.c | 53 ++++++++++++++++++++++--------------------------- 1 file changed, 24 insertions(+), 29 deletions(-) (limited to 'drivers/mtd/cfi_flash.c') diff --git a/drivers/mtd/cfi_flash.c b/drivers/mtd/cfi_flash.c index 84ff7e8095..4cb5fb52e4 100644 --- a/drivers/mtd/cfi_flash.c +++ b/drivers/mtd/cfi_flash.c @@ -305,17 +305,12 @@ flash_map (flash_info_t * info, flash_sect_t sect, uint offset) { unsigned int byte_offset = offset * info->portwidth; - return map_physmem(info->start[sect] + byte_offset, - flash_sector_size(info, sect) - byte_offset, - MAP_NOCACHE); + return (void *)(info->start[sect] + byte_offset); } static inline void flash_unmap(flash_info_t *info, flash_sect_t sect, unsigned int offset, void *addr) { - unsigned int byte_offset = offset * info->portwidth; - - unmap_physmem(addr, flash_sector_size(info, sect) - byte_offset); } /*----------------------------------------------------------------------- @@ -802,13 +797,11 @@ static flash_sect_t find_sector (flash_info_t * info, ulong addr) static int flash_write_cfiword (flash_info_t * info, ulong dest, cfiword_t cword) { - void *dstaddr; + void *dstaddr = (void *)dest; int flag; flash_sect_t sect = 0; char sect_found = 0; - dstaddr = map_physmem(dest, info->portwidth, MAP_NOCACHE); - /* Check if Flash is (sufficiently) erased */ switch (info->portwidth) { case FLASH_CFI_8BIT: @@ -827,10 +820,8 @@ static int flash_write_cfiword (flash_info_t * info, ulong dest, flag = 0; break; } - if (!flag) { - unmap_physmem(dstaddr, info->portwidth); + if (!flag) return ERR_NOT_ERASED; - } /* Disable interrupts which might cause a timeout here */ flag = disable_interrupts (); @@ -873,8 +864,6 @@ static int flash_write_cfiword (flash_info_t * info, ulong dest, if (flag) enable_interrupts (); - unmap_physmem(dstaddr, info->portwidth); - if (!sect_found) sect = find_sector (info, dest); @@ -890,7 +879,7 @@ static int flash_write_cfibuffer (flash_info_t * info, ulong dest, uchar * cp, int cnt; int retcode; void *src = cp; - void *dst = map_physmem(dest, len, MAP_NOCACHE); + void *dst = dest; void *dst2 = dst; int flag = 0; uint offset = 0; @@ -1052,7 +1041,6 @@ static int flash_write_cfibuffer (flash_info_t * info, ulong dest, uchar * cp, } out_unmap: - unmap_physmem(dst, len); return retcode; } #endif /* CONFIG_SYS_FLASH_USE_BUFFER_WRITE */ @@ -1301,7 +1289,7 @@ int write_buff (flash_info_t * info, uchar * src, ulong addr, ulong cnt) /* handle unaligned start */ if ((aln = addr - wp) != 0) { cword.l = 0; - p = map_physmem(wp, info->portwidth, MAP_NOCACHE); + p = (uchar *)wp; for (i = 0; i < aln; ++i) flash_add_byte (info, &cword, flash_read8(p + i)); @@ -1313,7 +1301,6 @@ int write_buff (flash_info_t * info, uchar * src, ulong addr, ulong cnt) flash_add_byte (info, &cword, flash_read8(p + i)); rc = flash_write_cfiword (info, wp, cword); - unmap_physmem(p, info->portwidth); if (rc != 0) return rc; @@ -1372,14 +1359,13 @@ int write_buff (flash_info_t * info, uchar * src, ulong addr, ulong cnt) * handle unaligned tail bytes */ cword.l = 0; - p = map_physmem(wp, info->portwidth, MAP_NOCACHE); + p = (uchar *)wp; for (i = 0; (i < info->portwidth) && (cnt > 0); ++i) { flash_add_byte (info, &cword, *src++); --cnt; } for (; i < info->portwidth; ++i) flash_add_byte (info, &cword, flash_read8(p + i)); - unmap_physmem(p, info->portwidth); return flash_write_cfiword (info, wp, cword); } @@ -1618,7 +1604,7 @@ static void flash_read_jedec_ids (flash_info_t * info) * board_flash_get_legacy needs to fill in at least: * info->portwidth, info->chipwidth and info->interface for Jedec probing. */ -static int flash_detect_legacy(ulong base, int banknum) +static int flash_detect_legacy(phys_addr_t base, int banknum) { flash_info_t *info = &flash_info[banknum]; @@ -1634,7 +1620,10 @@ static int flash_detect_legacy(ulong base, int banknum) for (i = 0; i < sizeof(modes) / sizeof(modes[0]); i++) { info->vendor = modes[i]; - info->start[0] = base; + info->start[0] = + (ulong)map_physmem(base, + info->portwith, + MAP_NOCACHE); if (info->portwidth == FLASH_CFI_8BIT && info->interface == FLASH_CFI_X8X16) { info->addr_unlock1 = 0x2AAA; @@ -1648,8 +1637,11 @@ static int flash_detect_legacy(ulong base, int banknum) info->manufacturer_id, info->device_id, info->device_id2); - if (jedec_flash_match(info, base)) + if (jedec_flash_match(info, info->start[0])) break; + else + unmap_physmem(info->start[0], + MAP_NOCACHE); } } @@ -1671,7 +1663,7 @@ static int flash_detect_legacy(ulong base, int banknum) return 0; /* use CFI */ } #else -static inline int flash_detect_legacy(ulong base, int banknum) +static inline int flash_detect_legacy(phys_addr_t base, int banknum) { return 0; /* use CFI */ } @@ -1826,12 +1818,12 @@ static void flash_fixup_stm(flash_info_t *info, struct cfi_qry *qry) * The following code cannot be run from FLASH! * */ -ulong flash_get_size (ulong base, int banknum) +ulong flash_get_size (phys_addr_t base, int banknum) { flash_info_t *info = &flash_info[banknum]; int i, j; flash_sect_t sect_cnt; - unsigned long sector; + phys_addr_t sector; unsigned long tmp; int size_ratio; uchar num_erase_regions; @@ -1847,7 +1839,7 @@ ulong flash_get_size (ulong base, int banknum) info->legacy_unlock = 0; #endif - info->start[0] = base; + info->start[0] = (ulong)map_physmem(base, info->portwidth, MAP_NOCACHE); if (flash_detect_cfi (info, &qry)) { info->vendor = le16_to_cpu(qry.p_id); @@ -1939,7 +1931,10 @@ ulong flash_get_size (ulong base, int banknum) printf("ERROR: too many flash sectors\n"); break; } - info->start[sect_cnt] = sector; + info->start[sect_cnt] = + (ulong)map_physmem(sector, + info->portwidth, + MAP_NOCACHE); sector += (erase_region_size * size_ratio); /* @@ -2016,7 +2011,7 @@ unsigned long flash_init (void) char *s = getenv("unlock"); #endif -#define BANK_BASE(i) (((unsigned long [CFI_MAX_FLASH_BANKS])CONFIG_SYS_FLASH_BANKS_LIST)[i]) +#define BANK_BASE(i) (((phys_addr_t [CFI_MAX_FLASH_BANKS])CONFIG_SYS_FLASH_BANKS_LIST)[i]) /* Init: no FLASHes known */ for (i = 0; i < CONFIG_SYS_MAX_FLASH_BANKS; ++i) { -- cgit From ec21d5cfcb6b4e7fcdd5c6e926e1a824900706f2 Mon Sep 17 00:00:00 2001 From: Stefan Roese Date: Thu, 5 Feb 2009 11:25:57 +0100 Subject: cfi_flash: Silence compilation warning Patch "flash/cfi_flash: Use virtual sector start address, not phys" introduced a small compilation warning. This patch fixes it. Signed-off-by: Stefan Roese --- drivers/mtd/cfi_flash.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) (limited to 'drivers/mtd/cfi_flash.c') diff --git a/drivers/mtd/cfi_flash.c b/drivers/mtd/cfi_flash.c index 4cb5fb52e4..3a8f8e42e2 100644 --- a/drivers/mtd/cfi_flash.c +++ b/drivers/mtd/cfi_flash.c @@ -879,7 +879,7 @@ static int flash_write_cfibuffer (flash_info_t * info, ulong dest, uchar * cp, int cnt; int retcode; void *src = cp; - void *dst = dest; + void *dst = (void *)dest; void *dst2 = dst; int flag = 0; uint offset = 0; -- cgit From e1fb6d0d52fbe3fbc1a4c651dacf11e9c1417f63 Mon Sep 17 00:00:00 2001 From: Stefan Roese Date: Thu, 5 Feb 2009 11:44:52 +0100 Subject: cfi_flash: Fix typo in cfi_flash.c Patch "flash/cfi_flash: Use virtual sector start address, not phys" introduced a small typo and compilation warning for systems with CFI legacy support (e.g. hcu4). This patch fixes it. Signed-off-by: Stefan Roese --- drivers/mtd/cfi_flash.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) (limited to 'drivers/mtd/cfi_flash.c') diff --git a/drivers/mtd/cfi_flash.c b/drivers/mtd/cfi_flash.c index 3a8f8e42e2..bdfad98244 100644 --- a/drivers/mtd/cfi_flash.c +++ b/drivers/mtd/cfi_flash.c @@ -1622,7 +1622,7 @@ static int flash_detect_legacy(phys_addr_t base, int banknum) info->vendor = modes[i]; info->start[0] = (ulong)map_physmem(base, - info->portwith, + info->portwidth, MAP_NOCACHE); if (info->portwidth == FLASH_CFI_8BIT && info->interface == FLASH_CFI_X8X16) { @@ -1640,7 +1640,7 @@ static int flash_detect_legacy(phys_addr_t base, int banknum) if (jedec_flash_match(info, info->start[0])) break; else - unmap_physmem(info->start[0], + unmap_physmem((void *)info->start[0], MAP_NOCACHE); } } -- cgit