From 2206ac248a550a4e796cd246ce57300fe7995d91 Mon Sep 17 00:00:00 2001 From: Simon Glass Date: Fri, 6 Dec 2019 21:41:37 -0700 Subject: dm: pci: Allow delaying auto-config until after relocation At present PCI auto-configuration happens in U-Boot both before and after relocation. This is a waste of time and may mess up static addresses used in board_init_f(). Adjust the code to supporting doing auto-configuration once, after relocation, under control of a device-tree property. This is needed for Apollo Lake for debugging the silicon-init code. Once the UART is moved to a different MMIO address the debug UART does not work and any debug output in Apollo Lake's arch_fsp_init_r() causes a hang. Signed-off-by: Simon Glass Reviewed-by: Bin Meng --- drivers/pci/pci-uclass.c | 15 ++++++++++----- 1 file changed, 10 insertions(+), 5 deletions(-) (limited to 'drivers/pci/pci-uclass.c') diff --git a/drivers/pci/pci-uclass.c b/drivers/pci/pci-uclass.c index fab20fc60e..8e13adb156 100644 --- a/drivers/pci/pci-uclass.c +++ b/drivers/pci/pci-uclass.c @@ -975,12 +975,15 @@ static int pci_uclass_pre_probe(struct udevice *bus) hose->bus = bus; hose->first_busno = bus->seq; hose->last_busno = bus->seq; + hose->skip_auto_config_until_reloc = + dev_read_bool(bus, "u-boot,skip-auto-config-until-reloc"); return 0; } static int pci_uclass_post_probe(struct udevice *bus) { + struct pci_controller *hose = dev_get_uclass_priv(bus); int ret; debug("%s: probing bus %d\n", __func__, bus->seq); @@ -988,11 +991,13 @@ static int pci_uclass_post_probe(struct udevice *bus) if (ret) return ret; -#if CONFIG_IS_ENABLED(PCI_PNP) - ret = pci_auto_config_devices(bus); - if (ret < 0) - return ret; -#endif + if (CONFIG_IS_ENABLED(PCI_PNP) && + (!hose->skip_auto_config_until_reloc || + (gd->flags & GD_FLG_RELOC))) { + ret = pci_auto_config_devices(bus); + if (ret < 0) + return log_msg_ret("pci auto-config", ret); + } #if defined(CONFIG_X86) && defined(CONFIG_HAVE_FSP) /* -- cgit