From e52fee9b04157c3f5bd73bb122e95d0c6ebb2270 Mon Sep 17 00:00:00 2001 From: Stefan Roese Date: Mon, 7 May 2012 21:29:30 +0000 Subject: NAND: Remove ONFI detection message to from bootup log Without this patch, boot shows this messages upon NAND detection: NAND: ONFI flash detected ONFI param page 0 valid ONFI flash detected ONFI param page 0 valid 128 MiB With this patch, its back to the U-Boot "standard": NAND: 128 MiB Tested on x600 (SPEAr600). Signed-off-by: Stefan Roese Cc: Amit Virdi Cc: Vipin Kumar Cc: Scott Wood Acked-by: Amit Virdi Signed-off-by: Scott Wood --- drivers/mtd/nand/nand_base.c | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-) (limited to 'drivers') diff --git a/drivers/mtd/nand/nand_base.c b/drivers/mtd/nand/nand_base.c index bef79bed0f..bfd668fa0a 100644 --- a/drivers/mtd/nand/nand_base.c +++ b/drivers/mtd/nand/nand_base.c @@ -2530,13 +2530,14 @@ static int nand_flash_detect_onfi(struct mtd_info *mtd, struct nand_chip *chip, chip->read_byte(mtd) != 'F' || chip->read_byte(mtd) != 'I') return 0; - printk(KERN_INFO "ONFI flash detected\n"); + MTDDEBUG(MTD_DEBUG_LEVEL0, "ONFI flash detected\n"); chip->cmdfunc(mtd, NAND_CMD_PARAM, 0, -1); for (i = 0; i < 3; i++) { chip->read_buf(mtd, (uint8_t *)p, sizeof(*p)); if (onfi_crc16(ONFI_CRC_BASE, (uint8_t *)p, 254) == le16_to_cpu(p->crc)) { - printk(KERN_INFO "ONFI param page %d valid\n", i); + MTDDEBUG(MTD_DEBUG_LEVEL0, + "ONFI param page %d valid\n", i); break; } } -- cgit