From 14453fbfadc2f98ca35d6033140466c7a4b4947a Mon Sep 17 00:00:00 2001 From: Patrick Delaunay Date: Wed, 27 Feb 2019 15:20:36 +0100 Subject: Convert CONFIG_SF_DEFAULT_* to Kconfig This converts the following to Kconfig: CONFIG_SF_DEFAULT_BUS CONFIG_SF_DEFAULT_CS CONFIG_SF_DEFAULT_MODE CONFIG_SF_DEFAULT_SPEED I use moveconfig script and then manual check on generated u-boot.cfg to solve the remaining issue. Signed-off-by: Patrick Delaunay --- include/configs/T1040QDS.h | 2 -- 1 file changed, 2 deletions(-) (limited to 'include/configs/T1040QDS.h') diff --git a/include/configs/T1040QDS.h b/include/configs/T1040QDS.h index 147ef71084..89ace7c1b0 100644 --- a/include/configs/T1040QDS.h +++ b/include/configs/T1040QDS.h @@ -415,8 +415,6 @@ unsigned long get_board_ddr_clk(void); /* * eSPI - Enhanced SPI */ -#define CONFIG_SF_DEFAULT_SPEED 10000000 -#define CONFIG_SF_DEFAULT_MODE 0 /* * General PCI -- cgit From abe66b1b5decf9cc2fb5daad42c9e870e5b99b67 Mon Sep 17 00:00:00 2001 From: Patrick Delaunay Date: Wed, 27 Feb 2019 15:20:38 +0100 Subject: Convert CONFIG_ENV_SPI_* to Kconfig This converts the following to Kconfig: CONFIG_ENV_SPI_BUS CONFIG_ENV_SPI_CS CONFIG_ENV_SPI_MAX_HZ CONFIG_ENV_SPI_MODE Most of time these value are not needed, CONFIG_SF_DEFAULT with same value is used, so I introduced CONFIG_USE_ENV_SPI_* to force the associated value for the environment. Signed-off-by: Patrick Delaunay --- include/configs/T1040QDS.h | 4 ---- 1 file changed, 4 deletions(-) (limited to 'include/configs/T1040QDS.h') diff --git a/include/configs/T1040QDS.h b/include/configs/T1040QDS.h index 89ace7c1b0..417383c7f0 100644 --- a/include/configs/T1040QDS.h +++ b/include/configs/T1040QDS.h @@ -59,10 +59,6 @@ #ifdef CONFIG_MTD_NOR_FLASH #if defined(CONFIG_SPIFLASH) -#define CONFIG_ENV_SPI_BUS 0 -#define CONFIG_ENV_SPI_CS 0 -#define CONFIG_ENV_SPI_MAX_HZ 10000000 -#define CONFIG_ENV_SPI_MODE 0 #define CONFIG_ENV_SIZE 0x2000 /* 8KB */ #define CONFIG_ENV_OFFSET 0x100000 /* 1MB */ #define CONFIG_ENV_SECT_SIZE 0x10000 -- cgit