From 836cd453583627cbef784bd4d7963109d5914bde Mon Sep 17 00:00:00 2001 From: Eric Bénard Date: Mon, 21 Jun 2010 09:40:43 +0200 Subject: cpuat91: unbreak ethernet MIME-Version: 1.0 Content-Type: text/plain; charset=UTF-8 Content-Transfer-Encoding: 8bit * the following problems are met : config was set to use the new driver as a default but - RMII was not enabled for the new driver - the new driver didn't compile with RMII enabled - the new driver initialize a PHY at address O when the PHY of this board is at 1 thus we get "AT91 EMAC RMII: No PHY present" * to fix these problems, this patch : - enable RMII for the new driver - fix the wrong define used in the at91_emac.c - allow the config file to set a default phy address (and use 0 as a default as in the actual at91_emac.c driver) Signed-off-by: Eric Bénard Signed-off-by: Ben Warren --- include/configs/cpuat91.h | 9 +++------ 1 file changed, 3 insertions(+), 6 deletions(-) (limited to 'include/configs/cpuat91.h') diff --git a/include/configs/cpuat91.h b/include/configs/cpuat91.h index b4fda76731..049298cfa3 100644 --- a/include/configs/cpuat91.h +++ b/include/configs/cpuat91.h @@ -131,15 +131,12 @@ (CONFIG_SYS_MEMTEST_START + PHYS_SDRAM_SIZE - 512 * 1024) #define CONFIG_NET_MULTI 1 -#ifdef CONFIG_NET_MULTI #define CONFIG_DRIVER_AT91EMAC 1 #define CONFIG_SYS_RX_ETH_BUFFER 8 -#else -#define CONFIG_DRIVER_ETHER 1 -#endif +#define CONFIG_RMII 1 +#define CONFIG_MII 1 +#define CONFIG_DRIVER_AT91EMAC_PHYADDR 1 #define CONFIG_NET_RETRY_COUNT 20 -#define CONFIG_AT91C_USE_RMII 1 -#define CONFIG_PHY_ADDRESS (1 << 5) #define CONFIG_KS8721_PHY 1 #define CONFIG_SYS_FLASH_CFI 1 -- cgit