From 5da71efa18e8b4eac9afd8bfa13e3c7e7ddde1d0 Mon Sep 17 00:00:00 2001 From: Eric Millbrandt Date: Thu, 3 Sep 2009 08:09:44 -0500 Subject: Reset i2c slave devices during init on mpc5xxx cpus Reset any i2c devices that may have been interrupted during a system reset. Normally this would be accomplished by clocking the line until SCL and SDA are released and then sending a start condtiion (From an Atmel datasheet). There is no direct access to the i2c pins so instead create start commands through the i2c interface. Send a start command then delay for the SDA Hold time, repeat this by disabling/enabling the bus a total of 9 times. Signed-off-by: Eric Millbrandt --- include/configs/galaxy5200.h | 1 + 1 file changed, 1 insertion(+) (limited to 'include/configs/galaxy5200.h') diff --git a/include/configs/galaxy5200.h b/include/configs/galaxy5200.h index a5b5a03a9a..f4b520d39f 100644 --- a/include/configs/galaxy5200.h +++ b/include/configs/galaxy5200.h @@ -110,6 +110,7 @@ #define CONFIG_SYS_I2C_MODULE 2 /* Select I2C module #1 or #2 */ #define CONFIG_SYS_I2C_SPEED 100000 /* 100 kHz */ #define CONFIG_SYS_I2C_SLAVE 0x7F +#define CONFIG_SYS_I2C_INIT_MPC5XXX /* Reset devices on i2c bus */ /* * EEPROM CAT24WC32 configuration -- cgit