/*
 * Copyright 2007-2012 Freescale Semiconductor, Inc.
 *
 * SPDX-License-Identifier:	GPL-2.0+
 */

#include <common.h>
#include <command.h>
#include <pci.h>
#include <asm/processor.h>
#include <asm/mmu.h>
#include <asm/cache.h>
#include <asm/immap_85xx.h>
#include <asm/fsl_pci.h>
#include <fsl_ddr_sdram.h>
#include <asm/io.h>
#include <asm/fsl_serdes.h>
#include <miiphy.h>
#include <libfdt.h>
#include <fdt_support.h>
#include <fsl_mdio.h>
#include <tsec.h>
#include <asm/fsl_law.h>
#include <netdev.h>

#include "../common/ngpixis.h"
#include "../common/sgmii_riser.h"

DECLARE_GLOBAL_DATA_PTR;

int board_early_init_f(void)
{
#ifdef CONFIG_MMC
	ccsr_gur_t *gur = (ccsr_gur_t *)(CONFIG_SYS_MPC85xx_GUTS_ADDR);

	setbits_be32(&gur->pmuxcr,
			 (MPC85xx_PMUXCR_SDHC_CD |
			 MPC85xx_PMUXCR_SDHC_WP));
#endif

	return 0;
}

int checkboard(void)
{
	u8 sw;

	printf("Board: P2020DS Sys ID: 0x%02x, "
	       "Sys Ver: 0x%02x, FPGA Ver: 0x%02x, ",
		in_8(&pixis->id), in_8(&pixis->arch), in_8(&pixis->scver));

	sw = in_8(&PIXIS_SW(PIXIS_LBMAP_SWITCH));
	sw = (sw & PIXIS_LBMAP_MASK) >> PIXIS_LBMAP_SHIFT;

	if (sw < 0x8)
		/* The lower two bits are the actual vbank number */
		printf("vBank: %d\n", sw & 3);
	else
		puts("Promjet\n");

	return 0;
}

#if !defined(CONFIG_DDR_SPD)
/*
 * Fixed sdram init -- doesn't use serial presence detect.
 */

phys_size_t fixed_sdram(void)
{
	struct ccsr_ddr __iomem *ddr =
		(struct ccsr_ddr __iomem *)CONFIG_SYS_FSL_DDR_ADDR;
	uint d_init;

	ddr->cs0_config = CONFIG_SYS_DDR_CS0_CONFIG;
	ddr->timing_cfg_3 = CONFIG_SYS_DDR_TIMING_3;
	ddr->timing_cfg_0 = CONFIG_SYS_DDR_TIMING_0;
	ddr->sdram_mode = CONFIG_SYS_DDR_MODE_1;
	ddr->sdram_mode_2 = CONFIG_SYS_DDR_MODE_2;
	ddr->sdram_md_cntl = CONFIG_SYS_DDR_MODE_CTRL;
	ddr->sdram_interval = CONFIG_SYS_DDR_INTERVAL;
	ddr->sdram_data_init = CONFIG_SYS_DDR_DATA_INIT;
	ddr->sdram_clk_cntl = CONFIG_SYS_DDR_CLK_CTRL;
	ddr->sdram_cfg_2 = CONFIG_SYS_DDR_CONTROL2;
	ddr->ddr_zq_cntl = CONFIG_SYS_DDR_ZQ_CNTL;
	ddr->ddr_wrlvl_cntl = CONFIG_SYS_DDR_WRLVL_CNTL;
	ddr->ddr_cdr1 = CONFIG_SYS_DDR_CDR1;
	ddr->timing_cfg_4 = CONFIG_SYS_DDR_TIMING_4;
	ddr->timing_cfg_5 = CONFIG_SYS_DDR_TIMING_5;

	if (!strcmp("performance", getenv("perf_mode"))) {
		/* Performance Mode Values */

		ddr->cs1_config = CONFIG_SYS_DDR_CS1_CONFIG_PERF;
		ddr->cs0_bnds = CONFIG_SYS_DDR_CS0_BNDS_PERF;
		ddr->cs1_bnds = CONFIG_SYS_DDR_CS1_BNDS_PERF;
		ddr->timing_cfg_1 = CONFIG_SYS_DDR_TIMING_1_PERF;
		ddr->timing_cfg_2 = CONFIG_SYS_DDR_TIMING_2_PERF;

		asm("sync;isync");

		udelay(500);

		ddr->sdram_cfg = CONFIG_SYS_DDR_CONTROL_PERF;
	} else {
		/* Stable Mode Values */

		ddr->cs1_config = CONFIG_SYS_DDR_CS1_CONFIG;
		ddr->cs0_bnds = CONFIG_SYS_DDR_CS0_BNDS;
		ddr->cs1_bnds = CONFIG_SYS_DDR_CS1_BNDS;
		ddr->timing_cfg_1 = CONFIG_SYS_DDR_TIMING_1;
		ddr->timing_cfg_2 = CONFIG_SYS_DDR_TIMING_2;

		/* ECC will be assumed in stable mode */
		ddr->err_int_en = CONFIG_SYS_DDR_ERR_INT_EN;
		ddr->err_disable = CONFIG_SYS_DDR_ERR_DIS;
		ddr->err_sbe = CONFIG_SYS_DDR_SBE;

		asm("sync;isync");

		udelay(500);

		ddr->sdram_cfg = CONFIG_SYS_DDR_CONTROL;
	}

#if defined(CONFIG_ECC_INIT_VIA_DDRCONTROLLER)
	d_init = 1;
	debug("DDR - 1st controller: memory initializing\n");
	/*
	 * Poll until memory is initialized.
	 * 512 Meg at 400 might hit this 200 times or so.
	 */
	while ((ddr->sdram_cfg_2 & (d_init << 4)) != 0)
		udelay(1000);
	debug("DDR: memory initialized\n\n");
	asm("sync; isync");
	udelay(500);
#endif

	if (set_ddr_laws(CONFIG_SYS_DDR_SDRAM_BASE,
			 CONFIG_SYS_SDRAM_SIZE * 1024 * 1024,
			 LAW_TRGT_IF_DDR) < 0) {
		printf("ERROR setting Local Access Windows for DDR\n");
		return 0;
	};

	return CONFIG_SYS_SDRAM_SIZE * 1024 * 1024;
}

#endif

#ifdef CONFIG_PCI
void pci_init_board(void)
{
	fsl_pcie_init_board(0);
}
#endif

int board_early_init_r(void)
{
	const unsigned int flashbase = CONFIG_SYS_FLASH_BASE;
	const u8 flash_esel = find_tlb_idx((void *)flashbase, 1);

	/*
	 * Remap Boot flash + PROMJET region to caching-inhibited
	 * so that flash can be erased properly.
	 */

	/* Flush d-cache and invalidate i-cache of any FLASH data */
	flush_dcache();
	invalidate_icache();

	/* invalidate existing TLB entry for flash + promjet */
	disable_tlb(flash_esel);

	set_tlb(1, flashbase, CONFIG_SYS_FLASH_BASE_PHYS,
			MAS3_SX|MAS3_SW|MAS3_SR, MAS2_I|MAS2_G,
			0, flash_esel, BOOKE_PAGESZ_256M, 1);

	return 0;
}

#ifdef CONFIG_TSEC_ENET
int board_eth_init(bd_t *bis)
{
	struct fsl_pq_mdio_info mdio_info;
	struct tsec_info_struct tsec_info[4];
	int num = 0;

#ifdef CONFIG_TSEC1
	SET_STD_TSEC_INFO(tsec_info[num], 1);
	num++;
#endif
#ifdef CONFIG_TSEC2
	SET_STD_TSEC_INFO(tsec_info[num], 2);
	if (is_serdes_configured(SGMII_TSEC2)) {
		puts("eTSEC2 is in sgmii mode.\n");
		tsec_info[num].flags |= TSEC_SGMII;
	}
	num++;
#endif
#ifdef CONFIG_TSEC3
	SET_STD_TSEC_INFO(tsec_info[num], 3);
	if (is_serdes_configured(SGMII_TSEC3)) {
		puts("eTSEC3 is in sgmii mode.\n");
		tsec_info[num].flags |= TSEC_SGMII;
}
	num++;
#endif

	if (!num) {
		printf("No TSECs initialized\n");

		return 0;
	}

#ifdef CONFIG_FSL_SGMII_RISER
	fsl_sgmii_riser_init(tsec_info, num);
#endif

	mdio_info.regs = (struct tsec_mii_mng *)CONFIG_SYS_MDIO_BASE_ADDR;
	mdio_info.name = DEFAULT_MII_NAME;

	fsl_pq_mdio_init(bis, &mdio_info);

	tsec_eth_init(bis, tsec_info, num);

	return pci_eth_init(bis);
}
#endif

#if defined(CONFIG_OF_BOARD_SETUP)
void ft_board_setup(void *blob, bd_t *bd)
{
	phys_addr_t base;
	phys_size_t size;

	ft_cpu_setup(blob, bd);

	base = getenv_bootm_low();
	size = getenv_bootm_size();

	fdt_fixup_memory(blob, (u64)base, (u64)size);

#ifdef CONFIG_HAS_FSL_DR_USB
	fdt_fixup_dr_usb(blob, bd);
#endif

	FT_FSL_PCI_SETUP;

#ifdef CONFIG_FSL_SGMII_RISER
	fsl_sgmii_riser_fdt_fixup(blob);
#endif
}
#endif